- 您現在的位置：買賣IC網 > PDF目錄360744 > ICS1892Y-14 10Base-T/100Base-TX Integrated PHYceiver PDF資料下載
參數資料
| 型號： | ICS1892Y-14 |
| 英文描述： | 10Base-T/100Base-TX Integrated PHYceiver |
| 文件頁數： | 77/148頁 |
| 文件大?。?/td> | 816K |
| 代理商： | ICS1892Y-14 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁當前第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁
Chapter 8
Management Register Set
ICS1892, Rev. D, 2/26/01
February 26, 2001
77
ICS1892
2000-2001, Integrated Circuit Systems, Inc.
All rights reserved.
8.6.4.1
Technology Ability Field: Hardware Mode
When the ICS1892 is operating in Hardware mode (that is, the HW/SW pin is logic zero), these TAF bits are
Read Only bits. The default value of these bits depends on the signal level on the HW/SW pin and whether
the Auto-Negotiation sublayer is enabled.
In Hardware mode, with the ANSEL pin pulled:
Low to a disabled state, the ICS1892 does not execute the auto-negotiation process. Upon completion
of the initialization sequence, the port proceeds to the idle state and begins ‘sending idles’ according to
the technology mode selected by the 10/100SEL pin and the DPXSEL pin. In this mode, the value of the
TAF bits (bits 4.8:5) are undefined.
High to an enabled state, the ICS1892 executes the auto-negotiation process and advertises its
capabilities to the remote link partner. The 10/100SEL and DPXSEL input pins determine the single
capability that the ICS1892 advertises. The ICS1892 updates the Auto-Negotiation Advertisement
Register TAF field to indicate the pin selection. The ICS1892 sets only one of these four bits to logic one.
The other three are a logic zero.
Note:
The ICS1892 does not alter the value of the Status Register bits. Although the ICS1892 is
advertising only one technology, the ISO/IEC definitions for the Status Register bits require
these bits to indicate all the capabilities of the ICS1892.
8.6.4.2
Technology Ability Field: Software Mode
In Software mode (that is, the HW/SW pin is logic one), these TAF bits are Command Override Write bits.
The default value of these bits depends on the signal level on the HW/SW pin and whether the
Auto-Negotiation sublayer is enabled.
In Software mode, with the Auto-Negotiation Enable bit (bit 0.12) set to logic:
Zero (that is, disabled), the ICS1892 does not execute the auto-negotiation process. Upon completion of
the initialization sequence, the port proceeds to the idle state and begins transmitting idles. Two Control
Register bits – the Data Rate Select bit (bit 0.13), and the Duplex Select bit (bit 0.8) – determine the
technology mode that the ICS1892 uses for data transmission and reception. In this mode, the values of
the TAF bits (bits 4.8:5), are undefined.
One (that is, enabled), the ICS1892 executes the auto-negotiation process and advertises its capabilities
to the remote link partner. The TAF bits (bits 4.8:5), determine the capabilities that the ICS1892
advertises to its remote link partner. For the ICS1892, all of these bits 4.8:5 are set to logic one,
indicating the ability of the ICS1892 to provide these technologies.
Note:
1.
The ICS1892 does not alter the value of the Status Register bits based on the TAF bits in register
4, as the ISO/IEC definitions for the Status Register bits require these bits to indicate all the
capabilities of the ICS1892.
In this mode, an STA can alter the default TAF bit settings, 4.12:5, and subsequently issue an
Auto-Negotiation Restart.
2.
8.6.5
Selector Field (Bits 4.4:0)
When its Auto-Negotiation Sublayer is enabled, the ICS1892 transmits its link capabilities to its remote Link
Partner during the auto-negotiation process. The Selector Field is transmitted based on the value of bits
4.4:0. These bits indicate to the remote link partner the type of message being sent during the
auto-negotiation process. The ICS1892 supports IEEE Std 802.3, represented by a value of 00001b in bits
4.4:0. The ISO/IEC 8802-3 standard defines the Selector Field technologies in Annex 28A.
相關PDF資料 |
PDF描述 |
|---|---|
| ICS1893AF | 3.3V 10Base-T/100Base-TX Integrated PHYceiverTM |
| ICS1893Y-10 | 3.3V 10Base-T/100Base-TX Integrated PHYceiverTM |
| ICS1893 | 3.3-V 10Base-T/100Base-TX Integrated PHYceiver⑩ |
| ICS2002 | Wavedec Digital Audio Codec |
| ICS2002Y | Wavedec Digital Audio Codec |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICS1893 | 制造商:ICS 制造商全稱:ICS 功能描述:3.3-V 10Base-T/100Base-TX Integrated PHYceiver |
| ICS1893_09 | 制造商:ICS 制造商全稱:ICS 功能描述:3.3-V 10Base-T/100Base-TX Integrated PHYceiver? |
| ICS1893AF | 功能描述:PHYCEIVER LOW PWR 3.3V 48-SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:PHYceiver™ 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| ICS1893AFI | 功能描述:PHYCEIVER LOW PWR 3.3V 48-SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:PHYceiver™ 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| ICS1893AFILF | 功能描述:PHYCEIVER LOW PWR 3.3V 48-SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:PHYceiver™ 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。