- 您現在的位置：買賣IC網 > PDF目錄385399 > HT46R47 (Holtek Semiconductor Inc.) 8-Bit OTP Battery Charger Controller PDF資料下載
參數資料
| 型號： | HT46R47 |
| 廠商： | Holtek Semiconductor Inc. |
| 英文描述： | 8-Bit OTP Battery Charger Controller |
| 中文描述： | 8位檢察官電池充電器控制器 |
| 文件頁數： | 12/45頁 |
| 文件大小： | 588K |
| 代理商： | HT46R47 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁
HT46R47
Rev. 1.40
12
July 18, 2001
converter request flag (ADF), enable
timer/event counter bit (ETI), enable external
interrupt bit (EEI), enable A/D converter inter-
rupt bit (EADI) and enable master interrupt bit
(EMI) constitute an interrupt control register
(INTC) which is located at 0BH in the data
memory. EMI, EEI, ETI, EADI are used to con-
trol the enabling/disabling of interrupts. These
bits prevent the requested interrupt from being
serviced. Once the interrupt request flags (TF,
EIF,ADF)areset,theywillremainintheINTC
register until the interrupts are serviced or
cleared by a software instruction.
It is recommended that a program does not
use the "CALL subroutine" within the inter-
rupt subroutine. Interrupts often occur in an
unpredictable manner or need to be serviced
immediately in some applications. If only one
stack is left and enabling the interrupt is not
well controlled,theoriginalcontrolsequencewill
be damaged once the "CALL" operates in the in-
terrupt subroutine.
Oscillator configuration
There are two oscillator circuits in the
microcontroller.
Both are designed for system clocks, namely
the RC oscillator and the Crystal oscillator,
which are determined by the ROM code option.
No matter what oscillator type is selected, the
signal provides the system clock. The HALT
mode stops the system oscillator and ignores an
external signal to conserve power.
If an RC oscillator is used, an external resistor
between OSC1 and VSS is required and the re-
sistance must range from 30k
system clock, divided by 4, is available on
OSC2, which can be used to synchronize exter-
nal logic. The RC oscillator provides the most
cost effective solution. However, the frequency
of oscillation may vary with VDD, tempera-
tures and the chip itself due to process varia-
tions. It is, therefore, not suitable for timing
sensitive operations where an accurate oscilla-
tor frequency is desired.
to 750k . The
If the Crystal oscillator is used, a crystal across
OSC1 and OSC2 is needed to provide the feed-
back and phase shift required for the oscillator,
and no other external components are required.
Instead of a crystal, a resonator can also be con-
nected between OSC1 and OSC2 to get a fre-
quency reference, but two external capacitors
in OSC1 and OSC2 are required (If the oscillat-
ing frequency is less than 1MHz).
The WDT oscillator is a free running on-chip RC
oscillator, and no external components are re-
quired.Evenifthesystementersthepowerdown
mode, the system clock is stopped, but the WDT
oscillator still works with a period of approxi-
mately 72 s/5V. The WDT oscillator can be dis-
abled by ROM code option to conserve power.
Watchdog Timer
WDT
The clock source of WDT is implemented by a
dedicated RC oscillator (WDT oscillator) or in-
struction clock (system clock divided by 4), de-
cided by ROM code option. This timer is
designed to prevent a software malfunction or
sequence from jumping to an unknown location
with unpredictable results. The Watchdog
" 1 $ . & ' $ % 0 ' ' & . ) "
$ % 0 ' ' & . ) "
/ # - " & 0 -
(
System oscillator
1 $ . # + ' ) % =
7 > 0 .) , - . # "
" # $ % & ' # "
7 > 0 .) , - . # "
) 2 #
/ . 0 ) -
# ' # % .
0 + # 7 ) , .
(
$
5 (
(
$
$
Watchdog Timer
相關PDF資料 |
PDF描述 |
|---|---|
| HT46R65-100 | A/D with LCD Type 8-Bit MCU |
| HT46C65 | A/D with LCD Type 8-Bit MCU |
| HT46C65-100 | A/D with LCD Type 8-Bit MCU |
| HT46C65-52 | A/D with LCD Type 8-Bit MCU |
| HT46C65-56 | A/D with LCD Type 8-Bit MCU |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HT46R47(18DIP-A) | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| HT46R47(18SOP-A) | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| HT46R47E | 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:Cost-Effective A/D Type 8-Bit MCU |
| HT46R47-H | 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:Cost-Effective A/D Type 8-Bit OTP MCU |
| HT46R48 | 制造商:HOLTEK 制造商全稱:Holtek Semiconductor Inc 功能描述:Cost-Effective A/D Type 8-Bit OTP MCU |
發布緊急采購，3分鐘左右您將得到回復。