- 您現在的位置：買賣IC網 > PDF目錄385396 > HSP50110 (Intersil Corporation) Digital Quadrature Tuner(數字調諧器) PDF資料下載
參數資料
| 型號： | HSP50110 |
| 廠商： | Intersil Corporation |
| 英文描述： | Digital Quadrature Tuner(數字調諧器) |
| 中文描述： | 數字正交調諧器（數字調諧器） |
| 文件頁數： | 20/24頁 |
| 文件大?。?/td> | 207K |
| 代理商： | HSP50110 |
3-20
TABLE 11. CHIP CONFIGURATION REGISTER
DESTINATION ADDRESS = 6
BIT
POSITION
FUNCTION
DESCRIPTION
0
HI/LO Output Sense
1 = HI/LO output of 1 means input > threshold.
0 = HI/LO output of 1 means input
≤
threshold.
(See Input Level Detector Section).
1
AGC Disable
1 = AGC disabled, gain forced to 1.0 (0dB), 0 = Normal operation.
(See AGC Section).
2
AGC Level Detector
Sense
1 = Error signal is 1 when output > threshold, -1 otherwise.
0 = Error signal is -1 when output > threshold, 1 otherwise.
Set to 0 for normal operation. (See AGC Section).
4-3
Carrier Offset
Frequency Word Width
0 0 = 8 bits
0 1 = 16 bits
1 0 = 24 bits
1 1 = 32 bits
(See Synthesizer/Mixer Section).
6-5
Sample Rate Offset
Frequency Word Width
0 0 = 8 bits
0 1 = 16 bits
1 0 = 24 bits
1 1 = 32 bits
(See Re-Sampler Section).
7
Carrier Offset
Frequency Enable
1 = Enable Offset Frequency, 0 = Zero Offset Frequency.
(See Synthesizer/Mixer Section).
8
Sample Rate Offset
Frequency Enable
1 = Enable Offset Frequency, 0 = Zero Offset Frequency.
(See Re-Sampler Section).
9
Load Synthesizer NCO
1 = Accumulation enabled.
0 = Feedback in accumulator is zeroed.
(See Synthesizer/Mixer Section) Set to 1 for normal operation.
10
Load Re-Sampler NCO
1 = Accumulation enabled.
0 = Feedback in accumulator is zeroed.
(See Re-Sampler Section) Set to 1 for normal operation.
12-11
Sample Phase Output
Select
Selects 5 of the 8 MSBs of the Re-Sampler NCO’s phase accumulator for output on SPH0-4. (See Re-
Sampler Section).
0 0 Bits 28:24.
0 1 Bits 29:25.
1 0 Bits 30:26.
1 1 Bits 31:27.
13
Sample Phase
Output Control
Selects whether the sample phase output pins and SSTRB update continuously or only when the DA-
TARDY is active. (See Re-Sampler Section).
1 = Continuous Update.
0 = Updated by DATARDY.
14
Clear Accumulators
Writing a 1 to the Clear Accumulator bit forces the contents of all accumulators to 0. Accumulators will
remain at 0 until a 0 is written to this bit. The following accumulators are affected by this bit.
Carrier NCO Accumulator
Cascode CIC Filter Accumulator
AGC Loop Filter Accumulator
Serial Output Shifter Counter
Serial Output Clock Logic
ReSampler NCO Carry Output Programmable Divider
31-15
Reserved.
HSP50110
相關PDF資料 |
PDF描述 |
|---|---|
| HSP50210 | Digital Costas Loop(數字Costas鎖相環) |
| HSP50214VC | Programmable Downconverter |
| HSP50214VI | Programmable Downconverter |
| HSP50214 | Programmable Downconverter |
| HSP50215VC | Digital UpConverter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HSP50110_01 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Digital Quadrature Tuner |
| HSP50110JC-52 | 功能描述:調諧器 DIGITAL QUADRATURE TUNER 84 PLCC,52MHZ,COMM RoHS:否 制造商:NXP Semiconductors 功能: 噪聲系數: 工作電源電壓: 最小工作溫度: 最大工作溫度: |
| HSP50110JC-52Z | 功能描述:調諧器 W/ANNEAL DIGTL TUNER 84 PLCC 52MHZ RoHS:否 制造商:NXP Semiconductors 功能: 噪聲系數: 工作電源電壓: 最小工作溫度: 最大工作溫度: |
| HSP50110JC-60 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Communications Tuner Circuit |
| HSP50110JI-52 | 功能描述:調諧器 DIGITAL QUADRATURE TUNER 84 PLCC,52MHZ,INDUSTRIAL RoHS:否 制造商:NXP Semiconductors 功能: 噪聲系數: 工作電源電壓: 最小工作溫度: 最大工作溫度: |
發布緊急采購，3分鐘左右您將得到回復。