![](http://datasheet.mmic.net.cn/280000/GSU31_datasheet_16061245/GSU31_93.png)
Intel
Integrated RAID Controller GSU31
User
’
s Manual
Rev 1.0
2-73
Advanced Installation Steps
HTTP and Winsock Services
RAID Management Agents
Select the desired components and hit <F10> to continue. The appropriate files are copied and
the AUTOEXEC.NCF and STARTUP.NCF files are modified as necessary.
Warning:
Once the product is installed, check for and remove any duplicate lines in
STARTUP.NCF. For example, NetWare 4.2 installations may insert an extra load line for the
module PK411.NLM. Remove the extra line.
13. After the installation is complete, reboot the server to load the new drivers.
14. Load Support Pack 8a or later and reboot.
15. See
Section 4.3
in the
“
Using the Storage Console
”
chapter to customize your RAID volumes
using Storage Console.
NetWare 5
Have all hardware and software on hand. See system requirements in
Section 2.5.10.2
.
GSU31 Hardware Installation
See
Section 1.4, Install the Adapter Card
for detailed hardware installation procedures.
Intel Integrated RAID Software Installation
1. Insert the NetWare CD-ROM and reboot.
Note:
The CMOS may need to be edited on some systems to be set to boot from the CD-ROM.
Otherwise, if the system finds a partition on the hard drive it will attempt to boot from it and an
error will result.
2. After booting you will first be asked to Accept the License Agreement. Do so. For a brand new
volume, you should then select
“
Create a New Boot Partition
”
.
3. NetWare will then ask for the size of the boot partition, you can either keep the default of
50MB or hit
“
Modify
”
to change the size to suit your needs. When you are done, select
“
Continue
”
.
4. It will ask you confirm the boot partition creation. Select
“
Continue
”
. You will then press a key
to reboot.
5. When NetWare boots again, it will first format the newly created boot partition, and then start
loading files. During this initialization, you will see a white graphical NetWare logo screen.
6. It will eventually load a Welcome screen, asking you to verify the startup directory
(C:\NWSERVER). Hit <Alt> <F10> to exit the installation. At the console, type
“
Down
”
. The
installation exits to the boot drive prompt.
7. Insert the GSU31 NetWare installation diskette into the A: drive. If your boot drive is C:, then
run NWUPDATE.BAT. If your boot drive is other than C:, then create an NWUPDATE
subdirectory and copy all the files from A:\DRIVERS into the NWUPDATE subdirectory.
8. Remove the diskette from the A: drive and reboot the server from the NetWare CD-ROM.
After booting you will be asked to Accept the License Agreement. Do so and then select
“
Continue with Existing Partition
”
. You are now ready install NetWare 5 on the GSU31
volume.