![](http://datasheet.mmic.net.cn/280000/GSU31_datasheet_16061245/GSU31_73.png)
Intel
Integrated RAID Controller GSU31
User
’
s Manual
Rev 1.0
2-53
Advanced Installation Steps
2.5.6.4
Installing Microsoft Windows NT Server 4.0 on an IDE Disk or Non-
RAID SCSI Disk
This procedure installs Microsoft Windows NT Server 4.0 on an IDE disk or non-RAID SCSI disk.
It is typically used on a system where the operating system is on a disk not controlled by GSU31.
Have all hardware and software on hand. See system requirements in
Section 2.5.6.2
.
GSU31 Hardware Installation
If necessary, install the hardware before continuing with this installation. See
Section 1.4, Install
the Adapter Card
for detailed hardware installation procedures. Install necessary IDE or SCSI
hardware (consult vendor documentation for details).
Intel Integrated RAID Software Installation
1. Install Microsoft Windows NT Server 4.0 to the desired boot device (IDE, SCSI).
2. During Windows NT installation install the following components:
—
TCP/IP
—
Microsoft Internet Information Server 2.0.
3. After the NT installation is complete, install the following components and software:
—
Microsoft Windows NT 4.0 Service Pack 5 or greater (This will automatically upgrade
Internet Information Server 2.0 to Internet Information Server 3.0.).
—
Microsoft Internet Explorer 4.00 or greater (recommended) or Netscape Navigator 4.08 or
greater.
4. If your browser uses a proxy server, then configure your browser using the procedure in
Section B.6,
“
Browser Configuration During Initial Installation
”
on page B-5
and return to this
procedure. If you have not configured your browser to use a proxy server, then go to
step 7
.
5. Configure Microsoft Internet Information Server
Warning:
Due to added security in GSU31, anonymous connections must be disabled in
Microsoft Internet Information Server (IIS) in order to execute the GSU31 configuration
utility in NT. If anonymous connections are allowed to IIS on the target server, then the
following message will appear on the web browser after launching the GSU31 configuration
utility shortcut:
Unable to open Driver
Could not open I
2
O Driver
To avoid the problem described above when attempting to run Storage Console, disable
Allow
Anonymous
connections to Microsoft IIS. Follow the directions below to disable
Allow
Anonymous
connections.
Note:
If you need to use the World Wide Web service capabilities of Internet Information
Server 4.0 to publish a web site on a server using GSU31, install IIS 4.0. Reconfigure IIS using
the IIS 4.0 instructions in
Section 2.5.7, Configuring Microsoft Internet Information Services
.
Return to this procedure when completed.
If you need to use IIS 4.0, reconfigure IIS using the IIS 4.0 instructions in
Section 2.5.7,
Configuring Microsoft Internet Information Services
. Go to
step 7
when completed.
6. Configuring Microsoft IIS 3.0