參數資料
型號： FT245RL-REEL
廠商： FTDI, Future Technology Devices International Ltd
文件頁數： 3/37頁
文件大?。?/td> 0K
描述： IC USB TO PARALLEL FIFO 28-SSOP
產品培訓模塊： USB Introduction
標準包裝： 1
應用： USB 至 FIFO 控制器
接口： USB，F(xiàn)IFO，（同步/異步）
電源電壓： 1.8 V ~ 5.25 V
封裝/外殼： 28-SSOP（0.209"，5.30mm 寬）
供應商設備封裝： 28-SSOP
包裝： 標準包裝
安裝類型： 表面貼裝
產品目錄頁面： 634 (CN2011-ZH PDF)
配用： 768-1020-ND - MOD USB PARALLEL FIFO DEV FT245R
其它名稱： 768-1011-6
Copyright 2010 Future Technology Devices International Limited
11
Document No.: FT_000052
FT245R USB FIFO IC Datasheet Version 2.12
Clearance No.: FTDI# 39
Pin No.
Name
Type
Description
1
VCCIO
PWR
+1.8V to +5.25V supply for the FIFO Interface group pins (2, 3, 6,7,8,9,10 11, 21,
22, 30,31,32). In USB bus powered designs connect this pin to 3V3OUT to drive out
at +3.3V levels, or connect to VCC to drive out at +5V CMOS level. This pin can also
be supplied with an external +1.8V to +2.8V supply in order to drive out at lower
levels. It should be noted that in this case this supply should originate from the
same source as the supply to VCC. This means that in bus powered designs a
regulator which is supplied by the +5V on the USB bus should be used.
4, 17,
20
GND
PWR
Device ground supply pins.
16
3V3OUT
Output
+3.3V output from integrated LDO regulator. This pin should be decoupled to
ground using a 100nF capacitor. The purpose of this output is to provide the
internal +3.3V supply to the USB transceiver cell and the internal 1.5kΩ pull up
resistor on USBDP. Up to 50mA can be drawn from this pin to power external logic if
required. This pin can also be used to supply the VCCIO pin.
19
VCC
PWR
+3.3V to +5.25V supply to the device core. (see Note 1).
24
AGND
PWR
Device analogue ground supply for internal clock multiplier.
Table 3.6 Power and Ground Group
Pin No.
Name
Type
Description
5, 12,
13, 23,
25, 29
NC
No internal connection. Do not connect.
18
RESET#
Input
Active low reset. Can be used by an external device to reset the FT245R. If
not required can be left unconnected, or pulled up to VCC.
26
TEST
Input
Puts the device into IC test mode. Must be tied to GND for normal
operation, otherwise the device will appear to fail.
27
OSCI
Input
Input 12MHz Oscillator Cell. Optional – Can be left unconnected for normal
operation. (see Note 2).
28
OSCO
Output
Output from 12MHZ Oscillator Cell. Optional – Can be left unconnected for
normal operation if internal Oscillator is used. (see Note 2).
Table 3.7 Miscellaneous Signal Group
Pin
No.
Name
Type
Description
30
D0
I/O
FIFO Data Bus Bit 0
31
D4
I/O
FIFO Data Bus Bit 4
32
D2
I/O
FIFO Data Bus Bit 2
2
D1
I/O
FIFO Data Bus Bit 1
3
D7
I/O
FIFO Data Bus Bit 7
相關PDF資料
PDF描述
FT4232HQ-REEL IC USB HS QUAD UART/SYNC 64-QFN
FUSB1500MHX IC USB 2.0 TRANSCEIVER 16-MLP
FUSB2805MLX TXRX USB2.0 HS OTG ULPI 32MLP
FXLA2203UMX TRANSLATOR LEVEL DUAL 24UMLP
GAL16V8D-15LJN SPLD 62.5MHZ EECMOS 20 PLCC
相關代理商/技術參數
參數描述
FT245RL-TUBE 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB FIFO IC 28-Pin SSOP Tube
FT245RQ 制造商:Future Technology Devices International 功能描述:Single Chip USB 32-Pin QFN 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC USB TO FIFO SMD QFN-32 245 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC, USB TO FIFO, SMD, QFN-32, 245 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB Full Speed to Parallel FIFO IC, Includes Oscillator and EEPROM - QFN-32 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC, USB FIFO INTERFACE, QFN-32; USB Type:USB FIFO; USB Version:2.0; Supply Voltage Min:1.8V; Supply Voltage Max:5.25V; Digital IC Case Style:QFN; No. of Pins:32; Data Rate:1Mbps; No. of Ports:2; Operating Temperature Min:-40C ;RoHS Compliant: Yes
FT245RQ-6000 制造商:FTDI 制造商全稱:FTDI 功能描述:USB FIFO IC - Single chip USB to parallel FIFO bidirectional data transfer interface
FT245RQ-REEL 功能描述:USB 接口集成電路 USB to Parallel FIFO Enhanced IC QFN-32 RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
FT245RQ-TRAY 制造商:Future Technology Devices International (FTDI Chip) 功能描述:Single Chip USB Tray
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*