- 您現在的位置：買賣IC網 > PDF目錄1922 > FT245RL-REEL (FTDI, Future Technology Devices International Ltd)IC USB TO PARALLEL FIFO 28-SSOP PDF資料下載
參數資料
| 型號： | FT245RL-REEL |
| 廠商： | FTDI, Future Technology Devices International Ltd |
| 文件頁數： | 16/37頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC USB TO PARALLEL FIFO 28-SSOP |
| 產品培訓模塊： | USB Introduction |
| 標準包裝： | 1 |
| 應用： | USB 至 FIFO 控制器 |
| 接口： | USB，F(xiàn)IFO，（同步/異步） |
| 電源電壓： | 1.8 V ~ 5.25 V |
| 封裝/外殼： | 28-SSOP（0.209"，5.30mm 寬） |
| 供應商設備封裝： | 28-SSOP |
| 包裝： | 標準包裝 |
| 安裝類型： | 表面貼裝 |
| 產品目錄頁面： | 634 (CN2011-ZH PDF) |
| 配用： | 768-1020-ND - MOD USB PARALLEL FIFO DEV FT245R |
| 其它名稱： | 768-1011-6 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
Copyright 2010 Future Technology Devices International Limited
23
Document No.: FT_000052
FT245R USB FIFO IC Datasheet Version 2.12
Clearance No.: FTDI# 39
7.2 Self Powered Configuration
Figure 7.2 Self Powered Configuration
Figure 7.2 illustrates the FT245R in a typical USB self powered configuration. A USB self powered device
gets its power from its own power supply, VCC, and does not draw current from the USB bus. The basic
rules for USB self powered devices are as follows –
i)
A self powered device should not force current down the USB bus when the USB host or hub
controller is powered down.
ii)
A self powered device can use as much current as it needs during normal operation and USB
suspend as it has its own power supply.
iii)
A self powered device can be used with any USB host, a bus powered USB hub or a self
powered USB hub.
The power descriptor in the internal EEPROM of the FT245R should be programmed to a value of zero
(self powered).
In order to comply with the first requirement above, the USB bus power (pin 1) is used to control the
RESET# pin of the FT245R device. When the USB host or hub is powered up an internal 1.5kΩ resistor
on USBDP is pulled up to +3.3V (generated using the 4K7 and 10k resistor network), thus identifying the
device as a full speed device to the USB host or hub. When the USB host or hub is powered off, RESET#
will be low and the FT245R is held in reset. Since RESET# is low, the internal 1.5kΩ resistor is not pulled
up to any power supply (hub or host is powered down), so no current flows down USBDP via the 1.5kΩ
pull-up resistor. Failure to do this may cause some USB host or hub controllers to power up erratically.
Error! Reference source not found. illustrates a self powered design which has a +4V to +5.25V
upply.
Note:
1. When the FT232R is in reset, the UART interface I/O pins are tri-stated. Input pins have internal
200kΩ pull-up resistors to VCCIO, so they will gently pull high unless driven by some external
logic.
2. When using internal FT232R oscillator the VCC supply voltage range must be +4.0V to 5.25V.
3. When using external oscillator the VCC supply voltage range must be +3.3V to 5.25V
Any design which interfaces to +3.3 V or +1.8V would be having a +3.3V or +1.8V supply to
VCCIO.
相關PDF資料 |
PDF描述 |
|---|---|
| FT4232HQ-REEL | IC USB HS QUAD UART/SYNC 64-QFN |
| FUSB1500MHX | IC USB 2.0 TRANSCEIVER 16-MLP |
| FUSB2805MLX | TXRX USB2.0 HS OTG ULPI 32MLP |
| FXLA2203UMX | TRANSLATOR LEVEL DUAL 24UMLP |
| GAL16V8D-15LJN | SPLD 62.5MHZ EECMOS 20 PLCC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FT245RL-TUBE | 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB FIFO IC 28-Pin SSOP Tube |
| FT245RQ | 制造商:Future Technology Devices International 功能描述:Single Chip USB 32-Pin QFN 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC USB TO FIFO SMD QFN-32 245 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC, USB TO FIFO, SMD, QFN-32, 245 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB Full Speed to Parallel FIFO IC, Includes Oscillator and EEPROM - QFN-32 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC, USB FIFO INTERFACE, QFN-32; USB Type:USB FIFO; USB Version:2.0; Supply Voltage Min:1.8V; Supply Voltage Max:5.25V; Digital IC Case Style:QFN; No. of Pins:32; Data Rate:1Mbps; No. of Ports:2; Operating Temperature Min:-40C ;RoHS Compliant: Yes |
| FT245RQ-6000 | 制造商:FTDI 制造商全稱:FTDI 功能描述:USB FIFO IC - Single chip USB to parallel FIFO bidirectional data transfer interface |
| FT245RQ-REEL | 功能描述:USB 接口集成電路 USB to Parallel FIFO Enhanced IC QFN-32 RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| FT245RQ-TRAY | 制造商:Future Technology Devices International (FTDI Chip) 功能描述:Single Chip USB Tray |
發布緊急采購，3分鐘左右您將得到回復。