參數資料
型號: ATAM893T-TKS
廠商: Atmel
文件頁數: 85/98頁
文件大?。?/td> 0K
描述: IC MON TIRE-PRESS ATARX9X SER
標準包裝: 830
系列: MARC4
核心處理器: MARC4
芯體尺寸: 4-位
速度: 4MHz
連通性: SSI(2 線,3 線)
外圍設備: 欠壓檢測/復位,POR,PWM,WDT
輸入/輸出數: 16
程序存儲器容量: 4KB(4K x 8)
程序存儲器類型: EEPROM
EEPROM 大小: 64 x 16
RAM 容量: 256 x 4
電壓 - 電源 (Vcc/Vdd): 1.8 V ~ 6.5 V
振蕩器型: 內部
工作溫度: -40°C ~ 125°C
封裝/外殼: 20-SOIC(0.209",5.30mm 寬)
包裝: 管件
86
4680C–4BMCU–01/05
ATAM893-D
6.1.2
Control Byte Format
6.2
EEPROM
The EEPROM has a size of 2
× 512 bits and is organized as 32 x 16-bit matrix each. To read
and write data to and from the EEPROM the serial interface must be used. The interface sup-
ports one and two byte write accesses and one to n-byte read accesses to the EEPROM.
6.2.1
EEPROM - Operating Modes
The operating modes of the EEPROM are defined via the control byte. The control byte contains
the row address, the mode control bits and the read/not-write bit that is used to control the direc-
tion of the following transfer. A 0 defines a write access and a 1 a read access. The five address
bits select one of the 32 rows of the EEPROM memory to be accessed. For all accesses the
complete 16-bit word of the selected row is loaded into a buffer. The buffer must be read or over-
written via the serial interface. The two mode control bits C
1 and C2 define in which order the
accesses to the buffer are performed: High byte – low byte or low byte – high byte. The
EEPROM also supports auto increment and auto decrement read operations.
After sending the start address with the corresponding mode, consecutive memory cells can be
read row by row without transmission of the row addresses.
Two special control bytes enable the complete initialization of EEPROM with 0 or with 1.
6.2.2
Write Operations
The EEPROM permits 8-bit and 16-bit write operations. A write access starts with the START
condition followed by a write control byte and one or two data bytes from the master. It is com-
pleted via the STOP condition from the master after the acknowledge cycle.
The programming cycle consists of an erase cycle (write “zeros”) and the write cycle (write
“ones”). Both cycles together take about 10 ms.
6.2.2.1
Acknowledge Polling
If the EEPROM is busy with an internal write cycle, all inputs are disabled and the EEPROM will
not acknowledge until the write cycle is finished. This can be used to detect the end of the write
cycle. The master must acknowledge polling by sending a start condition followed by the control
byte. If the device is still busy with the write cycle, it will not return an acknowledge and the mas-
ter has to generate a stop condition or perform further acknowledge polling sequences. If the
cycle is complete, it returns an acknowledge and the master can proceed with the next read or
write cycle.
EEPROM Address
Mode Control Bits
Read/
Write
Start
A4
A3
A2
A1
A0
C1
C0
R/NW
Acne
Start
Control byte
Acne
Data byte
Acne
Data byte
Acne
Stop
相關PDF資料
PDF描述
TS87C54X2-MIB IC MCU 8BIT 16K OTP 40MHZ 44PLCC
TS87C58X2-LCB IC MCU 8BIT 32K OTP 30MHZ 44PLCC
TS87C54X2-VCB IC MCU 8BIT 16K OTP 40MHZ 44PLCC
TS87C58X2-VCB IC MCU 8BIT 32K OTP 40MHZ 44PLCC
PIC16C57-LP/P IC MCU OTP 2KX12 28DIP
相關代理商/技術參數
參數描述
ATAM893T-TKSYD 功能描述:4位微控制器 - MCU Marc4 micrium 4k FLASH RoHS:否 最大時鐘頻率:32 KHz/4 MHz 程序存儲器大小:4 KB 封裝 / 箱體:SSO-20 制造商:Atmel 核心:MARC4 數據總線寬度:4 bit 安裝風格:SMD/SMT
ATAM893X-TKHYZ 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:Flash Version for ATAR080, ATAR090/890 and ATAR092/892
ATAM893X-TKQYZ 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:Flash Version for ATAR080, ATAR090/890 and ATAR092/892
ATAM893X-TKSYZ 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:Flash Version for ATAR080, ATAR090/890 and ATAR092/892
ATAM894 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8k-flash Microcontroller