- 您現在的位置：買賣IC網 > PDF目錄385093 > AKD4564 (Asahi Kasei Microsystems Co.,Ltd) 16BIT CODEC WITH BUILT-IN ALC AND MIC/HP/SPK-AMP PDF資料下載
參數資料
| 型號： | AKD4564 |
| 廠商： | Asahi Kasei Microsystems Co.,Ltd |
| 元件分類： | Codec |
| 英文描述： | 16BIT CODEC WITH BUILT-IN ALC AND MIC/HP/SPK-AMP |
| 中文描述： | 16位編解碼器，配有ALC和麥克風/惠普/胰腎聯合移植腺苷 |
| 文件頁數： | 14/48頁 |
| 文件大小： | 382K |
| 代理商： | AKD4564 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁
ASAHI KASEI
[AK4564]
MS0140-E-01
2002/07
- 14 -
OPERATION OVERVIEW
n
System Clock
The clocks required to operate are MCLK (256fs/384fs), LRCK (fs) and BCLK (32fs
～
). The master clock (MCLK)
should be synchronized with LRCK. The phase between these clocks does not matter. The frequency of MCLK can be
input as 256fs or 384fs. When the 384fs is input, the internal master clock is divided into 2/3 automatically.
*fs is sampling frequency.
When the synchronization is out of phase by changing the clock frequencies during normal operation, the AK4564 may
occur click noise. DAC input data should be “0” to avoid click noise.
All external clocks (MCLK, BCLK and LRCK) should always be present except MIC = ADC = DAC = VCOM = HPP =
SPKP = AOUT1P = AOUT2P = “0” or PDN = “L”. If these clocks are not provided, the AK4564 may draw excess current
and will not operate properly because it utilizes these clocks for internal dynamic refresh of registers. If the external
clocks are not present, the AK4564 should be placed in MIC = ADC = DAC = VCOM = HPP = SPKP = AOUT1P =
AOUT2P = “0” or PDN = “L”. However, ADC, DAC and ALC2 are in power-down mode until MCLK, BCLK and
LRCK is input, even if they release a power-down mode by PDN pin or control register. (Refer to the “Power
Management Mode”.)
n
System Reset
AK4564 should be reset once by bringing PDN pin “L” upon power-up. After the system reset operation, the all internal
registers become initial value.
Initializing cycle is 4128/fs=86ms@fs=48kHz. During initializing cycle, the ADC digital data outputs of both channels
are forced to a 2's compliment, “0”. Output data of ADC settles data equivalent for analog input signal after initializing
cycle. This cycle is not for DAC.
n
Digital High Pass Filter
The AK4564 has a Digital High Pass Filter (HPF) to cancel DC-offset in ADC. The cut-off frequency of the HPF is 3.7Hz
at fs=48kHz and it is attenuated to –0.15dB at 20Hz. This cut-off frequency scales with the sampling frequency (fs).
相關PDF資料 |
PDF描述 |
|---|---|
| AK4565 | LOW POWER 20BIT CODEC WITH BUILT IN ALC |
| AK4565VF | LOW POWER 20BIT CODEC WITH BUILT IN ALC |
| AK4566 | 20bit Stereo CODEC with built-in IPGA & HP-AMP |
| AK4566VN | 20bit Stereo CODEC with built-in IPGA & HP-AMP |
| AK4569 | 20-Bit Stereo CODEC with IPGA & HP-AMP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AKD4565 | 制造商:AKM 制造商全稱:AKM 功能描述:Evaluation board Rev.A for AK4565 |
| AKD4566 | 制造商:AKM 制造商全稱:AKM 功能描述:20bit Stereo CODEC with built-in IPGA & HP-AMP |
| AKD4569 | 制造商:AKM 制造商全稱:AKM 功能描述:Evaluation board Rev.A for AK4569 |
| AKD4571 | 制造商:AKM 制造商全稱:AKM 功能描述:USB Interface Audio CODEC |
| AKD4584 | 制造商:AKM 制造商全稱:AKM 功能描述:24Bit 96kHz Audio CODEC with DIT/DIR |
發布緊急采購，3分鐘左右您將得到回復。