參數資料
型號: ADV7320
廠商: Analog Devices, Inc.
英文描述: Multiformat 216 MHz Video Encoder with Six NSV 12-Bit DACs
中文描述: 多格式視頻編碼器216兆赫六噪聲整形的12位DAC
文件頁數: 58/88頁
文件大?。?/td> 1002K
代理商: ADV7320
ADV7320/ADV7321
Rev. 0 | Page 58 of 88
BLOCK SIZE CONTROL
BORDER AREA
BLOCK OFFSET
CORING GAIN DATA
CORING GAIN BORDER
GAIN
DNR CONTROL
FILTER
OUTPUT
>
THRESHOLD
INPUT FILTER
BLOCK
FILTER OUTPUT
<
THRESHOLD
DNR OUT
+
+
MAIN SIGNAL PATH
ADD SIGNAL
ABOVE
THRESHOLD
RANGE FROM
ORIGINAL SIGNAL
DNR
SHARPNESS
MODE
NOISE
SIGNAL PATH
Y DATA
INPUT
BLOCK SIZE CONTROL
BORDER AREA
BLOCK OFFSET
CORING GAIN DATA
CORING GAIN BORDER
GAIN
DNR CONTROL
FILTER
OUTPUT
<
THRESHOLD
INPUT FILTER
BLOCK
FILTER OUTPUT
THRESHOLD
DNR OUT
MAIN SIGNAL PATH
SUBTRACT SIGNAL
IN THRESHOLD
RANGE FROM
ORIGINAL SIGNAL
DNR MODE
NOISE
SIGNAL PATH
Y DATA
INPUT
+
0
Figure 78. DNR Block Diagram
CORING GAIN BORDER
[Address 0x63, Bits 3 to 0]
These four bits are assigned to the gain factor applied to border
areas. In DNR mode, the range of gain values is 0 to 1 in
increments of 1/8. This factor is applied to the DNR filter
output, which lies below the set threshold range. The result is
then subtracted from the original signal.
In DNR sharpness mode, the range of gain values is 0 to 0.5 in
increments of 1/16. This factor is applied to the DNR filter
output, which lies above the threshold range. The result is
added to the original signal.
CORING GAIN DATA
[Address 0x63, Bits 7 to 4]
These four bits are assigned to the gain factor applied to the luma
data inside the MPEG pixel block. In DNR mode, the range of
gain values is 0 to 1 in increments of 1/8. This factor is applied
to the DNR filter output, which lies below the set threshold
range. The result is then subtracted from the original signal.
In DNR sharpness mode, the range of gain values is 0 to 0.5 in
increments of 1/16. This factor is applied to the DNR filter
output, which lies above the threshold range. The result is
added to the original signal.
O X X X X X X O O X X X X X X O
O X X X X X X O O X X X X X X O
O X X X X X X O O X X X X X X O
DNR27 – DNR24 = 0x01
OFFSET CAUSED
BY VARIATIONS IN
INPUT TIMING
APPLY BORDER
CORING GAIN
APPLY DATA
CORING GAIN
0
Figure 79. DNR Offset Control
DNR THRESHOLD
[Address 0x64, Bits 5 to 0]
These six bits are used to define the threshold value in the range
of 0 to 63. The range is an absolute value.
BORDER AREA
[Address 0x64, Bit 6]
When this bit is set to Logic 1, the block transition area can be
defined to consist of four pixels. If this bit is set to Logic 0, the
border transition area consists of two pixels, where one pixel
refers to two clock cycles at 27 MHz.
720
×
485 PIXELS
(NTSC)
8
×
8 PIXEL BLOCK
2-PIXEL
BORDER
DATA
8
×
8 PIXEL BLOCK
0
Figure 80. DNR Border Area
BLOCK SIZE CONTROL
[Address 0x64, Bit 7]
This bit is used to select the size of the data blocks to be
processed. Setting the block size control function to Logic 1
defines a 16 pixel × 16 pixel data block, and Logic 0 defines an
8 pixel × 8 pixel data block, where one pixel refers to two clock
cycles at 27 MHz.
DNR INPUT SELECT CONTROL
[Address 0x65, Bits 2 to 0]
Three bits are assigned to select the filter, which is applied to the
incoming Y data. The signal that lies in the pass band of the
selected filter is the signal that will be DNR processed. Figure 81
shows the filter responses selectable with this control.
相關PDF資料
PDF描述
ADV7321 Multiformat 216 MHz Video Encoder with Six NSV 12-Bit DACs
ADV7321KSTZ Multiformat 216 MHz Video Encoder with Six NSV 12-Bit DACs
ADV7324 Multiformat 216 MHz Video Encoder with Six NSV 14-Bit DACs
ADV7324KSTZ Multiformat 216 MHz Video Encoder with Six NSV 14-Bit DACs
ADV7340 Multiformat Video Encoder, Six 12-Bit Noise Shaped Video㈢ DACS
相關代理商/技術參數
參數描述
ADV73205705 制造商:LG Corporation 功能描述:Frame Assembly
ADV73205706 制造商:LG Corporation 功能描述:Frame Assembly
ADV73205753 制造商:LG Corporation 功能描述:Frame Assembly
ADV73207202 制造商:LG Corporation 功能描述:Frame Assembly,Door
ADV73207203 制造商:LG Corporation 功能描述:FRAME ASSEMBLY,DOOR