參數資料
型號： ADUC836BCPZ
廠商： Analog Devices Inc
文件頁數： 64/80頁
文件大小： 0K
描述： IC MCU 62K FLASH ADC/DAC 56LFCSP
標準包裝： 1
系列： MicroConverter® ADuC8xx
核心處理器： 8052
芯體尺寸： 8-位
速度： 12.58MHz
連通性： EBI/EMI，I²C，SPI，UART/USART
外圍設備： POR，PSM，PWM，溫度傳感器，WDT
輸入/輸出數： 34
程序存儲器容量： 62KB（62K x 8）
程序存儲器類型： 閃存
EEPROM 大小： 4K x 8
RAM 容量： 2.25K x 8
電壓 - 電源 (Vcc/Vdd)： 2.7 V ~ 5.25 V
數據轉換器： A/D 7x16b; D/A 1x12b
振蕩器型： 內部
工作溫度： -40°C ~ 85°C
封裝/外殼： 56-VFQFN 裸露焊盤，CSP
包裝： 托盤
ADuC836
–66–
ADuC836
–67–
OTHER HARDWARE CONSIDERATIONS
In-Circuit Serial Download Access
Nearly all ADuC836 designs will want to take advantage of the
in-circuit reprogrammability of the chip. This is accomplished
by a connection to the ADuC836’s UART, which requires an
external RS-232 chip for level translation if downloading code
from a PC. Basic configuration of an RS-232 connection is illus-
trated in Figure 66 with a simple ADM3202 based circuit. If users
would rather not include an RS-232 chip onto the target board,
refer to the application note, uC006–A 4-Wire UART-to-PC Interface
available at www.analog.com/microconverter, for a simple (and
zero-cost-per-board) method of gaining in-circuit serial download
access to the ADuC836.
In addition to the basic UART connections, users will also need
a way to trigger the chip into Download mode.This is accom-
plished via a 1 k pull-down resistor that can be jumpered onto
the PSEN pin, as shown in Figure 66.To get the ADuC836 into
Download mode, simply connect this jumper and power-cycle the
device (or manually reset the device, if a manual reset button is
available), and it will be ready to receive a new program serially.
With the jumper removed, the device will power on in Normal
mode (and run the program) whenever power is cycled or RESET
is toggled.
Note that PSEN is normally an output (as described in the Exter-
nal Memory Interface section) and that it is sampled as an input
only on the falling edge of RESET (i.e., at power-up or upon an
external manual reset). Note also that if any external circuitry
unintentionally pulls PSEN low during power-up or reset events,
it could cause the chip to enter Download mode and therefore fail
to begin user code execution as it should.To prevent this, ensure
that no external signals are capable of pulling the PSEN pin low,
except for the external PSEN jumper itself.
Embedded Serial Port Debugger
From a hardware perspective, entry to Serial Port Debug mode is
identical to the serial download entry sequence described above.
In fact, both Serial Download and Serial Port Debug modes can
be thought of as essentially one mode of operation used in two
different ways.
Note that the serial port debugger is fully contained on the
ADuC836 device, (unlike ROM monitor type debuggers) and
therefore no external memory is needed to enable in-system
debug sessions.
Single-Pin Emulation Mode
Also built into the ADuC836 is a dedicated controller for single-pin
in-circuit emulation (ICE) using standard production ADuC836
devices. In this mode, emulation access is gained by connection to
a single pin, the EA pin. Normally, this pin is hard-wired either
high or low to select execution from internal or external program
memory space, as described earlier.To enable single-pin emu-
lation mode, however, users will need to pull the EA pin high
through a 1 k resistor, as shown in Figure 66.The emulator
will then connect to the 2-pin header also shown in Figure 66.
To be compatible with the standard connector that comes
with the single-pin emulator available from Accutron Limited
(www.accutron.com), use a 2-pin 0.1-inch pitch Friction Lock
header from Molex (www.molex.com) such as their part number
22-27-2021. Be sure to observe the polarity of this header. As
represented in Figure 66, when the Friction Lock tab is at the
right, the ground pin should be the lower of the two pins (when
viewed from the top).
REV. A
相關PDF資料
PDF描述
ADUC843BSZ62-5 IC ADC 12BIT W/FLASH MCU 52-MQFP
ADUC845BCPZ62-5 IC FLASH MCU W/24BIT ADC 56-CSP
ADUC847BCPZ62-5 IC MCU FLASH W/24BIT ADC 56-CSP
ADV202BBCZ-135 IC CODEC VIDEO 135MHZ 144CSPBGA
ADV212BBCZ-115 IC CODEC VID JPEG 2000 121CSPBGA
相關代理商/技術參數
參數描述
ADUC836BCPZ-REEL 功能描述:IC MCU 62K FLASH ADC/DAC 56LFCSP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC8xx 標準包裝:38 系列:Encore!® XP® 核心處理器:eZ8 芯體尺寸:8-位 速度:5MHz 連通性:IrDA，UART/USART 外圍設備:欠壓檢測/復位，LED，POR，PWM，WDT 輸入/輸出數:16 程序存儲器容量:4KB（4K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 3.6 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:20-SOIC（0.295"，7.50mm 寬） 包裝:管件 其它名稱:269-4116Z8F0413SH005EG-ND
ADUC836BS 制造商:Analog Devices 功能描述:MCU 8-bit ADuC8xx 8052 CISC 62KB Flash 3.3V/5V 52-Pin MQFP 制造商:Analog Devices 功能描述:8BIT MCU +16BIT DUAL ADC MQFP52
ADUC836BS 制造商:Analog Devices 功能描述:IC SEMICONDUCTOR ((NS))
ADUC836BSZ 功能描述:IC ADC DUAL 16BIT W/MCU 52-MQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC8xx 標準包裝:250 系列:56F8xxx 核心處理器:56800E 芯體尺寸:16-位 速度:60MHz 連通性:CAN，SCI，SPI 外圍設備:POR，PWM，溫度傳感器，WDT 輸入/輸出數:21 程序存儲器容量:40KB（20K x 16） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:6K x 16 電壓 - 電源 (Vcc/Vdd):2.25 V ~ 3.6 V 數據轉換器:A/D 6x12b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:48-LQFP 包裝:托盤 配用:MC56F8323EVME-ND - BOARD EVALUATION MC56F8323
ADUC841 制造商:AD 制造商全稱:Analog Devices 功能描述:MicroConverter 12-Bit ADCs and DACs with Embedded High Speed 62-kB Flash MCU
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*