參數資料
型號: ADF4002BRUZ-RL7
廠商: Analog Devices Inc
文件頁數: 20/20頁
文件大小: 0K
描述: IC PLL FREQUENCY SYNTH 16-TSSOP
設計資源: Very Low Jitter Encode (Sampling) Clocks for High Speed Analog-to-Digital Converters Using ADF4002 (CN0003)
標準包裝: 1,000
類型: 時鐘/頻率合成器(RF),相位檢測器
PLL:
輸入: CMOS,TTL
輸出: 時鐘
電路數: 1
比率 - 輸入:輸出: 2:1
差分 - 輸入:輸出: 是/無
頻率 - 最大: 400MHz
除法器/乘法器: 是/無
電源電壓: 2.7 V ~ 3.3 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 16-TSSOP(0.173",4.40mm 寬)
供應商設備封裝: 16-TSSOP
包裝: 帶卷 (TR)
配用: EVAL-ADF4002EBZ1-ND - BOARD EVAL FOR ADF4002
Data Sheet
ADF4002
Rev. C | Page 9 of 20
MUXOUT AND LOCK DETECT
The output multiplexer on the ADF4002 allows the user to
access various internal points on the chip. The state of
MUXOUT is controlled by M3, M2, and M1 in the function
latch. Figure 18 shows the full truth table. Figure 14 shows the
MUXOUT section in block diagram form.
DGND
DVDD
CONTROL
MUX
ANALOG LOCK DETECT
DIGITAL LOCK DETECT
R COUNTER OUTPUT
N COUNTER OUTPUT
SDOUT
MUXOUT
06052-
024
Figure 14. MUXOUT Circuit
Lock Detect
MUXOUT can be programmed for two types of lock detect:
digital lock detect and analog lock detect.
Digital lock detect is active high. When LDP in the R counter
latch is set to 0, digital lock detect is set high when the phase
error on three consecutive phase detector (PD) cycles is less
than 15 ns. With LDP set to 1, five consecutive cycles of less
than 15 ns are required to set the lock detect. It stays set at high
until a phase error of greater than 25 ns is detected on any
subsequent PD cycle. For PFD frequencies greater than 10 MHz,
analog lock detect is more accurate because of the smaller pulse
widths.
The N-channel, open-drain, analog lock detect should be
operated with an external pull-up resistor of 10 k nominal.
When lock has been detected, this output is high with narrow,
low going pulses.
INPUT SHIFT REGISTER
The ADF4002 digital section includes a 24-bit input shift
register, a 14-bit R counter, and a 13-bit N counter. Data is
clocked into the 24-bit shift register on each rising edge of CLK.
The data is clocked in MSB first. Data is transferred from the
shift register to one of four latches on the rising edge of LE. The
destination latch is determined by the state of the two control
bits (C2, C1) in the shift register. These are the two LSBs, DB1
and DB0, as shown in the timing diagram (see Figure 2). Table 6
provides the truth table for these bits. Figure 15 shows a
summary of how the latches are programmed.
Table 6. C2, C1 Truth Table
Control Bits
Data Latch
C2
C1
0
R Counter
0
1
N Counter
1
0
Function Latch
1
Initialization Latch
相關PDF資料
PDF描述
ADF4007BCPZ-RL7 IC DIVIDER/PLL SYNTHESZR 20LFCSP
ADF4106BRU IC PLL FREQ SYNTHESIZER 16-TSSOP
ADF4106SCPZ-EP IC PLL FREQ SYNTHESIZER 20LFCSP
ADF4107BCPZ IC PLL FREQ SYNTHESIZER 20LFCSP
ADF4108BCPZ IC PLL FREQUENCY SYNTH 20-LFCSP
相關代理商/技術參數
參數描述
ADF4002SRU-EP 制造商:Analog Devices 功能描述:Phase Detector/Frequency Synthesizer 16-Pin TSSOP 制造商:Analog Devices 功能描述:LOW FREQUENCY PLL CLOCK SOURCE - Rail/Tube 制造商:Analog Devices 功能描述:IC PLL FREQUENCY SYNTH 16TSSOP 制造商:Analog Devices Inc. 功能描述:Phase Locked Loops - PLL Low Frequency PLL Clock Source
ADF4002SRU-EP-RL7 制造商:Analog Devices 功能描述:Phase Detector/Frequency Synthesizer 16-Pin TSSOP T/R 制造商:Analog Devices 功能描述:LOW FREQUENCY PLL CLOCK SOURCE 制造商:Analog Devices 功能描述:LOW FREQUENCY PLL CLOCK SOURCE - Tape and Reel 制造商:Analog Devices 功能描述:IC PLL FREQUENCY SYNTH 16TSSOP 制造商:Analog Devices Inc. 功能描述:Phase Locked Loops - PLL Low Frequency PLL Clock Source
ADF4002SRUZ-EP 功能描述:IC PLL FREQUENCY SYNTH 16TSSOP 制造商:analog devices inc. 系列:* 零件狀態:在售 標準包裝:96
ADF4002SRUZ-EP-RL7 功能描述:IC PLL FREQUENCY SYNTH 16TSSOP 制造商:analog devices inc. 系列:* 零件狀態:在售 標準包裝:1,000
ADF4007 制造商:AD 制造商全稱:Analog Devices 功能描述:High Frequency Divider/PLL Synthesizer