- 您現在的位置：買賣IC網 > PDF目錄42339 > 90E36ERGI (INTEGRATED DEVICE TECHNOLOGY INC) SPECIALTY ANALOG CIRCUIT, PQFP48 PDF資料下載
參數資料
| 型號： | 90E36ERGI |
| 廠商： | INTEGRATED DEVICE TECHNOLOGY INC |
| 元件分類： | 模擬信號調理 |
| 英文描述： | SPECIALTY ANALOG CIRCUIT, PQFP48 |
| 封裝： | TQFP-48 |
| 文件頁數： | 14/75頁 |
| 文件大小： | 904K |
| 代理商： | 90E36ERGI |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁
90E36
POLY-PHASE HIGH-PERFORMANCE WIDE-SPAN ENERGY METERING IC
Function Description
21
August 24, 2011
3.7.2
IDLE MODE (I MODE)
In Idle mode, all functions are shut off.
The analog blocks' power supply is powered but circuits are set into
power-down mode, i.e, power supply applied but all current paths are
shut off. There is very low current since only very low device leakage
could exist in this mode.
The digital I/Os' supply is powered.
In I/O and analog interface, the input signals from digital core (which
is not powered) will be set to known state as described in Table-3. The
PM1 and PM0 pins which are controlled by external MCU are active and
can configure the 90E36 to other modes.
Figure-8 Block Diagram in Idle Mode
Please note that since the digital I/O is not shut off, the I/O circuit is
active in the Idle mode. The application shall make sure that valid logic
levels are applied to the I/O.
Table-3 lists digital I/O and power pins’ states in Idle mode. It lists the
requirements for inputs and the output level for output. For bi-directional
pins, the direction is defined.
VDD18 Regulator
Temperature Sensor
Current Detector
ADC-V1
ADC-V2
ADC-V3
ADC-I1
ADC-I2
ADC-I3
ADC-IN
SPI Interface
DSP
Energy Metering
(Forward/Reverse
Active/Reactive/CF Generator)
Measure and Monitoring
(V/I/rms,SAG, Phase, Freq)
Signal Analyzer
ADC Sample Capture, THD
Control Logic
Zero
Crossing
CF Out
Power On Reset
Crystal Oscillator
DMA
Reference Voltage
OSCI
OSCO
Power Mode
Configuration
Disabled
IRQ
Warn
Out
Table-3 Digital I/O and Power Pin States in Idle Mode
Name
I/O type
Type
Pin State in Idle Mode
Reset
I
LVTTL
Input level shall be VDD33.
CS
BLVTTL
I/O set in input mode.
Input level shall be VDD33 or VSS.
SCLK
B
LVTTL
I/O set in input mode.
Input level shall be VDD33 or VSS.
SDO
B
LVTTL
I/O set in input mode.
Input level shall be VDD33 or VSS.
SDI
B
LVTTL
I/O set in input mode.
Input level shall be VDD33 or VSS.
PM1
PM0
ILVTTL
As defined in Table-2
OSCI
OSCO
I
O
OSC
Oscillator powered down.
OSCO stays at fixed (low) level.
相關PDF資料 |
PDF描述 |
|---|---|
| 90MMCX-S50-0-51/111 | MMCX CONNECTOR, JACK |
| 91-21SUBC/S400-A6/TR10 | T-3/4 SINGLE COLOR LED, BLUE, 1.9 mm |
| 91-21SURC/S530-A3/TR7 | T-3/4 SINGLE COLOR LED, BRILLIANT RED, 1.9 mm |
| 91-21SURC/S530-A3/TR9 | T-3/4 SINGLE COLOR LED, BRILLIANT RED, 1.9 mm |
| 91-21USRC/S530-A4/F7 | T-3/4 SINGLE COLOR LED, DARK RED, 1.9 mm |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 90E36ERGI8 | 功能描述:電流和電力監控器、調節器 RoHS:否 制造商:STMicroelectronics 產品:Current Regulators 電源電壓-最大:48 V 電源電壓-最小:5.5 V 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:HPSO-8 封裝:Reel |
| 90E3-SERIES | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic |
| 90E46EMGI | 功能描述:計量片上系統 - SoC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 處理器系列:71M6511 類型:Metering SoC 最大時鐘頻率:70 Hz 程序存儲器大小:64 KB 數據 RAM 大小:7 KB 接口類型:UART 可編程輸入/輸出端數量:12 片上 ADC: 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-64 封裝:Reel |
| 90E46EMGI8 | 制造商:Integrated Device Technology Inc 功能描述:Energy Metering SoC 100-Pin TQFP 制造商:Integrated Device Technology Inc 功能描述:100-PIN TQFP - Tape and Reel |
| 90E9A | 制造商:NDK 制造商全稱:NDK 功能描述:crystal filter that supports surface mounting. |
發布緊急采購，3分鐘左右您將得到回復。