- 您現在的位置：買賣IC網 > PDF目錄368740 > 1977IFE (Linear Technology Corporation) High Voltage 1.5A, 500kHz Step-Down Switching Regulator with 100uA Quiescent Current PDF資料下載
參數資料
| 型號： | 1977IFE |
| 廠商： | Linear Technology Corporation |
| 英文描述： | High Voltage 1.5A, 500kHz Step-Down Switching Regulator with 100uA Quiescent Current |
| 中文描述： | 高電壓，500kHz降壓1.5安培的電流型開關穩壓器的靜態電流為100uA |
| 文件頁數： | 11/24頁 |
| 文件大小： | 288K |
| 代理商： | 1977IFE |
LT1977
11
1977f
APPLICATIOU
INPUT CAPACITOR
Step-down regulators draw current from the input supply
in pulses. The rise and fall times of these pulses are very
fast. The input capacitor is required to reduce the voltage
ripple this causes at the input of LT1977 and force the
switching current into a tight local loop, thereby minimiz-
ing EMI. The RMS ripple current can be calculated from:
W
U
U
I
I
V
V
V
V
RIPPLE RMS
OUT
IN
OUT
IN
OUT
(
)
–
=
(
)
Ceramic capacitors are ideal for input bypassing. At 500kHz
switching frequency input capacitor values in the range of
4.7
μ
F to 20
μ
F are suitable for most applications. If opera-
tion is required close to the minimum input required by the
LT1977 a larger value may be required. This is to prevent
excessive ripple causing dips below the minimum operat-
ing voltage resulting in erratic operation.
Input voltage transients caused by input voltage steps or
by hot plugging the LT1977 to a pre-powered source such
as a wall adapter can exceed maximum V
IN
ratings. The
sudden application of input voltage will cause a large
surge of current in the input leads that will store energy in
the parasitic inductance of the leads. This energy will
cause the input voltage to swing above the DC level of input
power source and it may exceed the maximum voltage
rating of the input capacitor and LT1977. All input voltage
transient sequences should be observed at the V
IN
pin of
the LT1977 to ensure that absolute maximum voltage
ratings are not violated.
The easiest way to suppress input voltage transients is to
add a small aluminum electrolytic capacitor in parallel with
the low ESR input capacitor. The selected capacitor needs
to have the right amount of ESR to critically damp the
resonant circuit formed by the input lead inductance and
the input capacitor. The typical values of ESR will fall in the
range of 0.5
to 2
and capacitance will fall in the range
of 5
μ
F to 50
μ
F.
If tantalum capacitors are used, values in the 22
μ
F to
470
μ
F range are generally needed to minimize ESR and
meet ripple current and surge ratings. Care should be
taken to ensure the ripple and surge ratings are not
exceeded. The AVX TPS and Kemet T495 series are surge
rated. AVX recommends derating capacitor operating
voltage by 2:1 for high surge applications.
OUTPUT CAPACITOR
The output capacitor is normally chosen by its effective
series resistance (ESR) because this is what determines
output ripple voltage. To get low ESR takes volume, so
physically smaller capacitors have higher ESR. The ESR
range for typical LT1977 applications is 0.05
to 0.2
. A
typical output capacitor is an AVX type TPS, 100
μ
F at 10V,
with a guaranteed ESR less than 0.1
. This is a “D” size
surface mount solid tantalum capacitor. TPS capacitors
are specially constructed and tested for low ESR, so they
give the lowest ESR for a given volume. The value in
microfarads is not particularly critical and values from
22
μ
F to greater than 500
μ
F work well, but you cannot
cheat Mother Nature on ESR. If you find a tiny 22
μ
F solid
tantalum capacitor, it will have high ESR and output ripple
voltage could be unacceptable. Table 3 shows some
typical solid tantalum surface mount capacitors.
Table 3. Surface Mount Solid Tantalum Capacitor ESR
and Ripple Current
E CASE SIZE
ESR MAX (
)
AVX TPS
0.1 to 0.3
D CASE SIZE
AVX TPS
0.1 to 0.3
C CASE SIZE
AVX TPS
0.2
RIPPLE CURRENT (A)
0.7 to 1.1
0.7 to 1.1
0.5
Many engineers have heard that solid tantalum capacitors
are prone to failure if they undergo high surge currents.
This is historically true and type TPS capacitors are
specially tested for surge capability but surge ruggedness
is not a critical issue with the output capacitor. Solid
tantalum capacitors fail during very high turn-on surges
which do not occur at the output of regulators. High
discharge surges, such as when the regulator output is
dead shorted, do not harm the capacitors.
Unlike the input capacitor RMS, ripple current in the
output capacitor is normally low enough that ripple cur-
rent rating is not an issue. The current waveform is
相關PDF資料 |
PDF描述 |
|---|---|
| 1982995-1 | Pluggable Bus Bar Connectors & Sockets |
| 19MT050XF | FULL BRIDGE FREDFET MTP HEXFET POWER MOSFET |
| 19TQ015S | SCHOTTKY RECTIFIER |
| 19U200PG1K | Pressure Sensors Low-Cost, Stainless Steel, Isolated Sensors |
| 19U050PA4K | Pressure Sensors Low-Cost, Stainless Steel, Isolated Sensors |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 1977-XX-XXX | 制造商:BOURNS 制造商全稱:Bourns Electronic Solutions 功能描述:1977 Series High Frequency Coaxial SPD |
| 1978 | 功能描述:電池組 RECHARGEABLE BATTRY PACK RoHS:否 制造商:Ultralife 電池大小: 電池?cái)?shù)量: 輸出電壓:3.7 V 容量: 化學性質:Lithium 端接類型:Wire |
| 19780 | 功能描述:KIT METER RES DIG TEMP/HUMIDITY RoHS:否 類別:靜電控制，ESD，無塵室產品 >> 監視器，測試儀 系列:- 產品目錄繪圖:19226 標準包裝:1 系列:- 類型:工作站監視器 使用:工作面，腕帶監視 特點:連續監視，NIST 可追溯，單芯系統 電源類型:AC 適配器 包括:AC 適配器，證書，軟線，五金件 其它名稱:16-1116 |
| 19-780 | 制造商:GC Electronics 功能描述:Squeeze Bottle Dispense Solvents In The Required Amounts In The Proper Location |
| 1978000000 | 制造商:Weidmuller 功能描述:SC-SMT 3.81/09/135G 1.5SN BK |
發布緊急采購，3分鐘左右您將得到回復。