- 您現在的位置：買賣IC網 > PDF目錄1976 > XRT73L03BIV-F (Exar Corporation)IC LIU E3/DS3/STS-1 3CH 120LQFP PDF資料下載
參數資料
| 型號： | XRT73L03BIV-F |
| 廠商： | Exar Corporation |
| 文件頁數： | 47/61頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC LIU E3/DS3/STS-1 3CH 120LQFP |
| 標準包裝： | 72 |
| 類型： | 線路接口裝置（LIU） |
| 驅動器/接收器數： | 3/3 |
| 規程： | DS3，E3，STS-1 |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 120-LQFP |
| 供應商設備封裝： | 120-LQFP（14x20） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁當前第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁
XRT73L03B
3 CHANNEL DS3/E3/STS-1 LINE INTERFACE UNIT
REV. 1.0.1
49
To configure Channel (n) to operate in the Digital Lo-
cal Loop-Back Mode, pull both the LLB input pin and
the RLB input pin "High".
4.3
THE REMOTE LOOP-BACK MODE
When a given channel is configured to operate in the
Remote Loop-Back Mode, the channel ignores any
signals that are input to the TPData and TNData input
pins. The channel receives the incoming line signal
via the RTIP and RRing input pins. This data is pro-
cessed through the entire Receive Section and is out-
put to the Receive Terminal Equipment via the RPOS,
RNEG and RxClk output pins. Additionally, this data
is also internally looped back into the Pulse-Shaping
block within the Transmit Section. At this point, this
data is routed through the remainder of the Transmit
Section of the channel and transmitted out onto the
line via the TTIP_(n) and TRing_(n) output pins.
Figure 35 illustrates the path that the data takes when
the chip is configured to operate in the Remote Loop-
Back Mode.
Configure a channel to operate in the Remote Loop-
Back Mode by employing either one of the following
two steps
a. Operating in the HOST Mode
To configure Channel (n) to operate in the Remote
Loop-Back Mode, write a "1" into the RLB bit-field,
and a "0" into the LLB bit-field, within Command Reg-
ister CR4.
b. Operating in the Hardware Mode
To configure Channel(n) to operate in the Remote
Loop-Back Mode, pull both the RLB_(n) input pin to
“High" and the LLB_(n) input pin to "Low".
FIGURE 35. THE REMOTE LOOP-BACK PATH, WITHIN A GIVEN CHANNEL
AGC/
Equalizer
Peak
Detector
LOS Detector
Slicer
Clock
Recovery
Data
Recovery
Invert
Loop MUX
HDB3/
B3ZS
Decoder
LOSTHR_(n)
SDI
SDO
SClk
CS
REGR
RTIP_(n)
RRing_(n)
REQEN_(n)
RxClk_(n)
RPOS_(n)
RNEG_(n)
LCV_(n)
ENDECDIS
RLOS_(n)
LLB_(n)
RLB_(n)
TAOS_(n)
TPData_(n)
TNData_(n)
TxClk_(n)
Notes: 1. (n) = 0, 1 or 2 for respective Channels
2. Serial Processor Interface input pins are shared by the three Channels in HOST Mode and redefined in
Hardware Mode.
RLOL_(n) EXClk_(n)
Device
Monitor
MTIP_(n)
MRing_(n)
Transmit
Logic
Duty Cycle Adjust
TxLEV_(n)
TxOFF_(n)
DMO_(n)
TTIP_(n)
TRing_(n)
Pulse
Shaping
HDB3/
B3ZS
Encoder
Serial
Processor
Interface
Remote
Loop-Back Path
COMMAND REGISTER CR4-(n)
D4
D3
D2
D1
D0
X
STS-1/DS3_(n)
E3_(n)
LLB_(n)
RLB_(n)
XX
X
0
1
相關PDF資料 |
PDF描述 |
|---|---|
| XRT73L04BIV-F | IC LIU E3/DS3/STS-1 4CH 144LQFP |
| XRT73L06IB-F | IC LIU E3/DS3/STS-1 6CH 217BGA |
| XRT73LC00AIV-F | IC LIU STS1/DS3/E3 SGL 44TQFP |
| XRT73LC03AIV-F | IC LIU E3/DS3/STS-1 3CH 120LQFP |
| XRT73LC04AIV-F | IC LIU E3/DS3/STS-1 4CH 144LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT73L03IV | 制造商:EXAR 制造商全稱:EXAR 功能描述:3 CHANNEL E3/DS3/STS-1 LINE INTERFCE UNIT |
| XRT73L03IVS | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC |
| XRT73L04A | 制造商:EXAR 制造商全稱:EXAR 功能描述:4 CHANNEL DS3/E3/STS-1 LINE INTERFACE UNIT |
| XRT73L04AIV | 制造商:EXAR 制造商全稱:EXAR 功能描述:4 CHANNEL DS3/E3/STS-1 LINE INTERFACE UNIT |
| XRT73L04B | 制造商:EXAR 制造商全稱:EXAR 功能描述:4 CHANNEL DS3/E3/STS-1 LINE INTERFACE UNIT |
發布緊急采購，3分鐘左右您將得到回復。