參數資料
型號: TZA1038HW,118
廠商: NXP Semiconductors
文件頁數: 45/45頁
文件大?。?/td> 0K
描述: IC DVD SIGNAL PROC 48-HTQFP
標準包裝: 2,500
系列: *
類型: *
應用: *
安裝類型: 表面貼裝
封裝/外殼: 48-TQFP 裸露焊盤
供應商設備封裝: 48-HTQFP
包裝: 帶卷 (TR)
其它名稱: 935273843118
TZA1038HW-T
TZA1038HW-T-ND
2003 Sep 03
9
Philips Semiconductors
Product specication
High speed advanced analog DVD signal
processor and laser supply
TZA1038HW
7
FUNCTIONAL DESCRIPTION
7.1
RF data processing
The RF data path is a fully DC-coupled, multi-stage
amplifier (see Fig.3). The input signal for data can be
selected from RF inputs A to D or from the summed
RF inputs RFSUMP and RFSUMN. Switching between the
two sets of signals is performed by an internal multiplexer.
The signals are fully balanced internally to improve signal
quality and reduce power supply interference.
RF outputs RFP and RFN can be DC coupled to the
Analog-to-Digital Converter (ADC) of the decoder.
The RF input signals are from photodiodes and have
a large DC content by nature. This DC component must be
removed from the signals for good system performance.
Built-in DACs, located after the input stages
G1 and RFSUM, have the ability to do this. The DAC range
and resolution is scaled with the gain setting of the first
amplifier stage. When the DC content is removed, the
RF signal can be DC coupled to the decoder. The main
advantage of DC coupling is fast recovery from signal
swings due to disc defects since there is no AC coupling
capacitance to slow the recovery. When using DC
coupling, both AC and DC content in the data signal is
known. The Philips Iguana decoders have on-chip control
loops to support Automatic Gain Control (AGC) and DC
cancellation.
Two separate DACs are available for cases where the left
and right side DC conditions can be different.
When it is not possible to have a DC connection between
the TZA1038HW and the decoder, the signals on servo
outputs OA to OD can be used as they contain the same
LP-filtered and DC coupled information.
Summing of the photodiode signals A to D is performed in
the second amplifier stage G2. Each individual diode
channel can be switched on, off or inverted with switches
SW-A to SW-D.
Switching between photodiode signals and RFSUM input
is performed immediately before the third amplifier
stage G3. This stage has a variable gain with fine
resolution to allow automatic gain adjustment to be
controlled by the decoder.
The filter stage limits the bandwidth according to the
maximum playback speed of the disc. This is to optimize
the noise performance. The filter stage consists of an
equalizer and a noise filter, both of which can be
bypassed, also the boost factor of the equalizer can be set.
The corner frequencies of the equalizer and noise filter are
equal and can be programmed to a 7-bit resolution.
The RF output signals RFP and RFN can be DC coupled
to a decoder with a differential input pair (as with Philips
Iguana decoders). The common mode output voltage can
be set externally at pin RFREF.
The signals for differential phase detection are tapped
from the inputs A to D at the RF amplifier G1 stages.
DC cancellation for the A to D and RFSUM signal paths
can be set independently or simultaneously.
相關PDF資料
PDF描述
UG80960HD5016SL2GM IC MPU I960HD 3V 50MHZ 208-QFP
ULQ2003ATDG4Q1 IC DARLINGTON TRANS ARRAY 16SOIC
UPD70F3025AGC-33-8EU-A MCU 32BIT 256K FLASH 100LQFP
UPD70F3201YGC-YEU-A MCU 32BIT I2C 100TQFP
UPD70F3452GC-UBT-A MCU 32BIT 256KB FLASH 80LQFP
相關代理商/技術參數
參數描述
TZA1038HW-T 功能描述:音頻 DSP DVDALASLITE AUTO RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube
TZ-A103SS 制造商:Panasonic Industrial Company 功能描述:SIGNAL SENDER
TZA1045 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Photodiode and amplifier IC for CD and DVD applications
TZA1045TS 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Photodiode and amplifier IC for CD and DVD applications
TZA1046 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Photodiode and amplifier IC for CD and DVD applications