參數資料
型號： TPS65735RSNR
廠商： TEXAS INSTRUMENTS INC
元件分類： 模擬信號調理
英文描述： SPECIALTY ANALOG CIRCUIT, PQCC32
封裝： GREEN, PLASTIC, QFN-32
文件頁數： 9/32頁
文件大?。?/td> 1324K
代理商： TPS65735RSNR
SLVSAI6
– JUNE 2011
Figure 2-5. Battery Charge Phases
In the pre-charge phase, the battery is charged with the pre-charge current that is scaled to be 10% of the
fast-charge current set by the resistor connected to the ISET pin. Once the battery voltage crosses the
VLOWV threshold, the battery is charged with the fast-charge current (ICHG). As the battery voltage reaches
VBAT(REG), the battery is held at a constant voltage of VBAT(REG) and the charge current tapers off as the
battery approaches full charge. When the battery current reaches ITERM, the charger indicates charging is
done by making the nCHG_STAT pin high impedance. Note that termination detection is disabled
whenever the charge rate is reduced from the set point because of the actions of the thermal loop, the
DPM loop, or the VIN(LOWV) loop.
2.7.2.1
Pre-charge
The value for the pre-charge current is set to be 10% of the charge current that is set by the external
resistor, RISET. Pre-charge current is scaled to lower currents when the charger is in thermal regulation.
2.7.2.2
Charge Termination
In the fast charge state, once VBAT ≥ VBAT(REG), the charger enters constant voltage mode. In constant
voltage mode, the charge current will taper until termination when the charge current falls below the I(TERM)
threshold (typically 10% of the programmed fast charge current). Termination current is not scaled when
the charger is in thermal regulation. When the charging is terminated, the nCHG_STAT pin will be high
impedance (effectively turning off any LED that is connected to this pin).
2.7.2.3
Recharge
Once a charge cycle is complete and termination is reached, the battery voltage is monitored. If VBAT <
VBAT(REG) - VRCH, the device determines if the battery has been removed. If the battery is still present, then
the recharge cycle begins and will end when VBAT ≥ VBAT(REG).
2.7.2.4
Charge Timers
The charger in this device has internal safety timers for the pre-charge and fast charge phases to prevent
potential damage to either the battery or the system. The default values for these timers are found as
follows: Pre-charge timer = 0.5 hours (30 minutes) and Fast charge timer = 5 hours (300 minutes).
Copyright
2011, Texas Instruments Incorporated
POWER MANAGEMENT CORE
17
Product Folder Link(s): TPS65735
相關PDF資料
PDF描述
TPS70702PWP DUAL-OUTPUT LOW-DROPOUT VOLTAGE REGULATORS WITH POWER UP SEQUENCING FOR SPLIT VOLTAGE DSP SYSTEMS
TPS70745PWP DUAL-OUTPUT LOW-DROPOUT VOLTAGE REGULATORS WITH POWER UP SEQUENCING FOR SPLIT VOLTAGE DSP SYSTEMS
TPS70751PWP DUAL-OUTPUT LOW-DROPOUT VOLTAGE REGULATORS WITH POWER UP SEQUENCING FOR SPLIT VOLTAGE DSP SYSTEMS
TPS70758PWPRG4 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO20
TPS70802PWP DUAL-OUTPUT LOW-DROPOUT VOLTAGE REGULATORS WITH INTEGRATED SVS FOR SPLIT VOLTAGE SYSTEMS
相關代理商/技術參數
參數描述
TPS65800EVM 功能描述:電源管理IC開發工具 TPS65800 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
TPS65800RTQR 功能描述:電池管理 1-Cell L-Ion Battery & Pwr Mngmnt IC RoHS:否 制造商:Texas Instruments 電池類型:Li-Ion 輸出電壓:5 V 輸出電流:4.5 A 工作電源電壓:3.9 V to 17 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:VQFN-24 封裝:Reel
TPS65800RTQRG4 功能描述:電池管理 1-Cell L-Ion Battery & Pwr Mngmnt IC RoHS:否 制造商:Texas Instruments 電池類型:Li-Ion 輸出電壓:5 V 輸出電流:4.5 A 工作電源電壓:3.9 V to 17 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:VQFN-24 封裝:Reel
TPS65800RTQT 功能描述:電池管理 1-Cell L-Ion Battery & Pwr Mngmnt IC RoHS:否 制造商:Texas Instruments 電池類型:Li-Ion 輸出電壓:5 V 輸出電流:4.5 A 工作電源電壓:3.9 V to 17 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:VQFN-24 封裝:Reel
TPS65800RTQT 制造商:Texas Instruments 功能描述:POWER M SGL C LI ION 3~18V 56QFN 制造商:Texas Instruments 功能描述:POWER M, SGL C LI ION, 3~18V, 56QFN
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*