參數資料
型號: TMX320F28069UPFPA
廠商: Texas Instruments
文件頁數: 89/174頁
文件大小: 0K
描述: IC MCU 32BIT 128KB FLASH 80HTQFP
產品培訓模塊: ControlSUITE
Piccolo F2806x
標準包裝: 1
系列: TMS320F2806x, Piccolo™, C2000™
核心處理器: C28x
芯體尺寸: 32-位
速度: 80MHz
連通性: CAN,I²C,McBSP,SCI,SPI,UART/USART
外圍設備: 欠壓檢測/復位,DMA,POR,PWM,WDT
輸入/輸出數: 40
程序存儲器容量: 256KB(128K x 16)
程序存儲器類型: 閃存
RAM 容量: 50K x 16
電壓 - 電源 (Vcc/Vdd): 1.71 V ~ 1.995 V
數據轉換器: A/D 12x12b
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 80-TQFP 裸露焊盤
包裝: 托盤
其它名稱: 296-30085
TMX320F28069UPFPA-ND
SPRS698D – NOVEMBER 2010 – REVISED DECEMBER 2012
2.4
Signal Descriptions
Table 2-5 describes the signals. With the exception of the JTAG pins, the GPIO function is the default at
reset, unless otherwise mentioned. The peripheral signals that are listed under them are alternate
functions. Some peripheral functions may not be available in all devices. See Table 2-1 for details. Inputs
are not 5-V tolerant. All GPIO pins are I/O/Z and have an internal pullup, which can be selectively enabled
or disabled on a per-pin basis. This feature only applies to the GPIO pins. The pullups on the PWM pins
are not enabled at reset. The pullups on other GPIO pins are enabled upon reset. The AIO pins do not
have an internal pullup.
NOTE: When the on-chip VREG is used, the GPIO19, GPIO34, GPIO35, GPIO36, GPIO37, and GPIO38
pins could glitch during power up. If this is unacceptable in an application, 1.8 V could be supplied
externally. There is no power-sequencing requirement when using an external 1.8-V supply. However, if
the 3.3-V transistors in the level-shifting output buffers of the I/O pins are powered prior to the 1.9-V
transistors, it is possible for the output buffers to turn on, causing a glitch to occur on the pin during power
up. To avoid this behavior, power the VDD pins prior to or simultaneously with the VDDIO pins, ensuring that
the VDD pins have reached 0.7 V before the VDDIO pins reach 0.7 V.
Table 2-5. Terminal Functions(1)
PIN NO.
PIN NAME
I/O/Z
DESCRIPTION
PZ
PN
PZP
PFP
JTAG
JTAG test reset with internal pulldown. TRST, when driven high, gives the scan system
control of the operations of the device. If this signal is not connected or driven low, the
device operates in its functional mode, and the test reset signals are ignored.
NOTE: TRST is an active-high test pin and must be maintained low at all times during
TRST
12
10
I
normal device operation. An external pull-down resistor is required on this pin. The
value of this resistor should be based on drive strength of the debugger pods
applicable to the design. A 2.2-k
resistor generally offers adequate protection. Since
this is application-specific, it is recommended that each target board be validated for
proper operation of the debugger and the application. (
↓)
TCK
See GPIO38
I
See GPIO38. JTAG test clock with internal pullup. (
↑)
See GPIO36. JTAG test-mode select (TMS) with internal pullup. This serial control
TMS
See GPIO36
I
input is clocked into the TAP controller on the rising edge of TCK. (
↑)
See GPIO35. JTAG test data input (TDI) with internal pullup. TDI is clocked into the
TDI
See GPIO35
I
selected register (instruction or data) on a rising edge of TCK. (
↑)
See GPIO37. JTAG scan out, test data output (TDO). The contents of the selected
TDO
See GPIO37
O/Z
register (instruction or data) are shifted out of TDO on the falling edge of TCK.
(8-mA drive)
FLASH
VDD3VFL
46
37
3.3-V Flash Core Power Pin. This pin should be connected to 3.3 V at all times.
TEST2
45
36
I/O
Test Pin. Reserved for TI. Must be left unconnected.
(1)
I = Input, O = Output, Z = High Impedance, OD = Open Drain,
↑ = Pullup, ↓ = Pulldown
Copyright 2010–2012, Texas Instruments Incorporated
Device Overview
21
相關PDF資料
PDF描述
TPS2371PWRG4 IC PWR INTRFCE SW FOR POE 8TSSOP
TS3A24157RSERG4 IC SWITCH DUAL SPDT 10UQFN
TS5A3159MDBVREP IC SWITCH SPDT SOT23-6
TS87C51RB2-MCB IC MCU 8BIT 16K OTP 40MHZ 44PLCC
TSB42AC3PZT IC LINK LAYER CTRLR 1394 100TQFP
相關代理商/技術參數
參數描述
TMX320F28069UPZPA 功能描述:IC MCU 32BIT 128KB FLSH 100HTQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:TMS320F2806x, Piccolo™, C2000™ 標準包裝:38 系列:Encore!® XP® 核心處理器:eZ8 芯體尺寸:8-位 速度:5MHz 連通性:IrDA,UART/USART 外圍設備:欠壓檢測/復位,LED,POR,PWM,WDT 輸入/輸出數:16 程序存儲器容量:4KB(4K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 3.6 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:20-SOIC(0.295",7.50mm 寬) 包裝:管件 其它名稱:269-4116Z8F0413SH005EG-ND
TMX320F2806GGMA 功能描述:IC 32-BIT DSP W/FLASH 100-BGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:TMS320F280x, C2000™ 產品培訓模塊:XLP Deep Sleep Mode 8-bit PIC® Microcontroller Portfolio 標準包裝:22 系列:PIC® XLP™ 18F 核心處理器:PIC 芯體尺寸:8-位 速度:48MHz 連通性:I²C,SPI,UART/USART,USB 外圍設備:欠壓檢測/復位,POR,PWM,WDT 輸入/輸出數:14 程序存儲器容量:8KB(4K x 16) 程序存儲器類型:閃存 EEPROM 大小:256 x 8 RAM 容量:512 x 8 電壓 - 電源 (Vcc/Vdd):1.8 V ~ 5.5 V 數據轉換器:A/D 11x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:20-DIP(0.300",7.62mm) 包裝:管件 產品目錄頁面:642 (CN2011-ZH PDF) 配用:DV164126-ND - KIT DEVELOPMENT USB W/PICKIT 2DM164127-ND - KIT DEVELOPMENT USB 18F14/13K50AC164112-ND - VOLTAGE LIMITER MPLAB ICD2 VPP
TMX320F2806PZA 功能描述:IC 32-BIT DSP W/FLASH 100-LQFP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:TMS320F280x, C2000™ 產品培訓模塊:XLP Deep Sleep Mode 8-bit PIC® Microcontroller Portfolio 標準包裝:22 系列:PIC® XLP™ 18F 核心處理器:PIC 芯體尺寸:8-位 速度:48MHz 連通性:I²C,SPI,UART/USART,USB 外圍設備:欠壓檢測/復位,POR,PWM,WDT 輸入/輸出數:14 程序存儲器容量:8KB(4K x 16) 程序存儲器類型:閃存 EEPROM 大小:256 x 8 RAM 容量:512 x 8 電壓 - 電源 (Vcc/Vdd):1.8 V ~ 5.5 V 數據轉換器:A/D 11x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:20-DIP(0.300",7.62mm) 包裝:管件 產品目錄頁面:642 (CN2011-ZH PDF) 配用:DV164126-ND - KIT DEVELOPMENT USB W/PICKIT 2DM164127-ND - KIT DEVELOPMENT USB 18F14/13K50AC164112-ND - VOLTAGE LIMITER MPLAB ICD2 VPP
TMX320F2806ZGMA 制造商:Texas Instruments 功能描述:32-BIT DIGITAL SIGNAL CONTROLLER WITH FLASH - Trays
TMX320F28075PTPT 功能描述:C28x C2000? C28x Piccolo? Microcontroller IC 32-Bit 120MHz 512KB (256K x 16) FLASH 176-HLQFP (24x24) 制造商:texas instruments 系列:C2000?? C28x Piccolo?? 包裝:托盤 零件狀態:過期 核心處理器:C28x 核心尺寸:32-位 速度:120MHz 連接性:CAN,EBI/EMI,I2C,McBSP,SCI,SPI,UART/USART,USB 外設:DMA,POR,PWM,WDT I/O 數:97 程序存儲容量:512KB(256K x 16) 程序存儲器類型:閃存 EEPROM 容量:- RAM 容量:50K x 16 電壓 - 電源(Vcc/Vdd):1.14 V ~ 3.47 V 數據轉換器:A/D 17x12B,D/A 3x12b 振蕩器類型:外部 工作溫度:-40°C ~ 105°C(TA) 封裝/外殼:176-LQFP 裸露焊盤 供應商器件封裝:176-HLQFP(24x24) 標準包裝:1