
TDA9112
24/51
Note 50: With exception of
HDUTY and BREF adjustments data that can take effect instantaneously if switches
HDutySyncV and B+SyncV are at 0 respectively.
Note 51: In Read Mode, the device always outputs data of the status register, regardless of sub address previously
selected.
Note 52: The TV, TH, TVM and THM bits are for testing purposes and must be kept at 0 by application.
Description of I2C Bus switches and flags
Write-to bits
Sad00/D7 - HDutySyncV
Synchronization of internal application of Hori-
zontal Duty cycle data, buffered in I2C Bus latch,
with internal discharge of Vertical oscillator
0: Asynchronous mode, new data applied
with ACK bit of I2C Bus transfer on this sub
address
1: Synchronous mode
Sad02/D7 - HMoiré
Horizontal Moiré characteristics
0: Adapted to an architecture with EHT gener-
ated in deflection section
1: Adapted to an architecture with separated
deflection and EHT sections
Sad03/D7 - B+SyncV
Same as HDutySyncV, applicable for B+ refer-
ence data
Sad04/D7 - HDyCorTr
Tracking of Horizontal Dynamic Correction
waveform amplitude with Horizontal Size at ad-
justment and EHT variation (voltage of HEHTIn).
0: Not active
1: Active
Sad05/D7 - HDyCorPh
Phase of start of Horizontal Dynamic Correction
waveform (and B+ drive if in internal sawtooth
configuration) in relation to horizontal flyback
pulse.
0: Start of the flyback
1: Middle of the flyback
11
Reserved
PCAC
(Pin cushion asymmetry correction)
1000000
12
Reserved
PARAL
(Parallelogram correction)
1000000
13
Reserved
TCAC
(Top corner asymmetry correction)
1000000
14
Reserved
BCAC
(Bottom corner asymmetry correction)
1000000
15
VDyCorPol
0: ”
∪"
VDC-AMP
(Vertical dynamic correction amplitude)
1000000
16
XRayReset
0: No effect
1: Reset
VSyncAuto
1: On
VSyncSel
0:Comp
1:Sep
SDetReset
0: No effect
1: Reset
0
PLL1Pump
1: Fast
0: Slow
PLL1InhEn
1: On
HLockEn
1: On
17
TV
0: Off(52)
TH
0: Off(52)
TVM
0: Off(52)
THM
0: Off(52)
BOHEdge
0: Falling
HBOutEn
0: Disable
VOutEn
0: Disable
BlankMode
1: Perm.
READ MODE (SLAVE ADDRESS = 8D)
XX
(51)
HLock
0: Locked
1: Not locked
VLock
0: Locked
1: Not lock.
XRayAlarm
1: On
0: Off
Polarity detection
Sync detection
HVPol
1: Negative
VPol
1: Negative
VExtrDet
0: Not det.
HVDet
0: Not det.
VDet
0: Not det.
Sad
D7
D6D5D4D3D2
D1
D0