- 您現在的位置：買賣IC網 > PDF目錄384950 > TC253SPD-30 (Texas Instruments, Inc.) Impactron High Sensitivity CCD (Non-Cooled) PDF資料下載
參數資料
| 型號： | TC253SPD-30 |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | Impactron High Sensitivity CCD (Non-Cooled) |
| 中文描述： | Impactron 高靈敏度 CCD（非冷卻） |
| 文件頁數： | 10/21頁 |
| 文件大?。?/td> | 286K |
| 代理商： | TC253SPD-30 |
×
JULY 2003 SOCS085
10
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
optical characteristics, T
A
= 25
°
C (unless otherwise noted)
PARAMETER
MIN
TYP
290
MAX
UNIT
Sensitivity with typical CCM gain (see Note 11)
No IR filter
V/Lx*s
With IR filter
36
Sensitivity without CCM gain (see Note 11)
No IR filter
9.6
V/Lx*s
With IR filter
1.2
Vsat
Saturation signal output without CCM gain (see Note 12)
300
400
mV
Handling capacity of charge multiplier
400
500
Voff
Zero-input offset output (see Note 13)
90
200
mV
Blooming overload ratio (see Note 14)
1000:1
Image area well capacity
33k
44k
e-/pixel
Smear (see Note 15)
60
dB
Dark current (see Note 16 and Note 21)
0.01
0.03
nA/cm2
Dark signal (see Note 17 and Note 21)
0.005
0.015
mV
Dark-signal uniformity (see Note 18)
0.15
mV
Dark-signal shading (see Note 19)
0.1
mV
Spurious nonuniformity
Dark
0.8
1.5
mV
Illuminated
20
20
%
Column uniformity (see Note 20)
4.5
mV
Electronic-shutter capability
NOTES: 11. Light source temperature is 2856
°
K. The IR filter used is CM500, 1-mm thick.
12. Saturation is the condition in which further increase in exposure does not lead to further increases in output signal.
13. Zero-input offset is the residual output signal measured from the reset level with no input charge present. This level is not caused
by the dark current and remains approximately constant, independent of temperature. It may vary with the amplitude of SRG.
14. Blooming is the condition in which charge induced by light in one element spills over to the neighboring elements.
15. Smear is the measure of error signal introduced into the pixels by transferring them through the illuminated region into the memory.
The illuminated region is 1/10 of the image area height. The value in the table is obtained for an integration time of 16.66 ms and
a 3.125-MHz vertical-clock transfer frequency.
16. Dark current depends on temperature and approximately doubles every 8 oC. Dark current is also multiplied by CCM operation. The
value given in the table is with the multiplier turned off and it is a calculated value.
17. Dark signal is actual device output measured in darkness.
18. Dark signal uniformity is the sigma of the difference between two neighboring pixels taking from all the image area pixels.
19. Dark signal shading is the difference between maximum and minimum of a 5-pixel median taken anywhere in the array.
20. Column uniformity is obtained by summing all the lines in the array, finding the maximum of the difference between two neighboring
columns anywhere in the array, and dividing the result by the number of lines.
21. There will be an estimated 20% degradation in dark current performance when exposed to 320 nm UV light at 1 uWatt/cm2 for
2700 hours.
1/5000
1/30
s
相關PDF資料 |
PDF描述 |
|---|---|
| TC253SPD-B0 | 680 x 500 PIXEL IMPACTRON CCD IMAGE SENSOR |
| TC303 | POWER NAND GATES |
| TC3097-8 | TV 32C 32#20 PIN WALL RECP |
| TC3097F-5 | CONNECTOR ACCESSORY |
| TC3097F-8 | D52 - BACKSHELL ENVIRON EMI-RFI 90 DEG M |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TC253SPD-B0 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:680 x 500 PIXEL IMPACTRON CCD IMAGE SENSOR |
| TC254 | 制造商:Cooper Wiring Devices 功能描述: |
| TC2540 | 功能描述:鋁質電解電容器 - 帶引線 4000uF 25Volts RoHS:否 制造商:Kemet 引線類型: 電容:220 uF 容差:20 % 電壓額定值:25 V 工作溫度范圍: 端接類型:Radial 外殼直徑:8 mm 外殼長度:11 mm 引線間隔:5 mm 產品:General Purpose Electrolytic Capacitors 封裝:Bulk |
| TC2540A | 制造商:CDE 制造商全稱:Cornell Dubilier Electronics 功能描述:Axial Leaded Aluminum Electrolytic Capacitors |
| TC254P | 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。