- 您現在的位置：買賣IC網 > PDF目錄383877 > T9000 (Lineage Power) ISDN Network Termination Node (NTN) Device(ISDN網絡終端節點器件) PDF資料下載
參數資料
| 型號： | T9000 |
| 廠商： | Lineage Power |
| 英文描述： | ISDN Network Termination Node (NTN) Device(ISDN網絡終端節點器件) |
| 中文描述： | ISDN網絡終端節點（新界西）設備（ISDN網網絡終端節點器件） |
| 文件頁數： | 85/126頁 |
| 文件大小： | 1523K |
| 代理商： | T9000 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁當前第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁
Lucent Technologies Inc.
85
Advance Data Sheet
April 2000
ISDN Network Termination Node (NTN) Device
T9000
11 GPIO Ports
Three general-purpose input/output ports are available
on the T9000 device with each port being 8 bits wide.
For any port, each signal may be individually config-
ured as an input or as an output by proper program-
ming of registers GPDIR[0:2]. On reset, all ports are
configured as inputs.
All GPIO signals have a weak pull-up resistor of
100 k
(nominal value). Unneeded GPIO signals
should be configured as inputs, and may be left uncon-
nected. If connected on the board, it is recommended
to be tied to V
DD
to avoid power consumption.
Registers GPD[0:2] contain the value on the GPIO pin.
For GPIO pins configured as inputs, the microcontroller
accesses the port value by reading its corresponding
GPD register. For GPIO pins configured as outputs, the
microcontroller writes the desired value into its corre-
sponding GPD register.
GPIO0.[3:0] and GPIO1.[3:0] pins, when configured as
inputs (see registers GPDIR0 and GPDIR1), may also
be configured as level-activated or transition-activated
external interrupt sources for the microcontroller (see
registers GPPOL and GPLEI). Any of these eight exter-
nal interrupt sources may be masked by proper pro-
gramming of register GPIE. On module reset, all
interrupts are disabled. GPIO interrupt register (GPIR)
is cleared when read by the microcontroller.
GPIO0.[3:0] and GPIO1.[3:0] pins, when configured as
inputs, present a Schmitt trigger buffer for better noise
immunity.
GPAF0 and GPAF1 registers define alternate functional
modes for some GPIO pins.
I
GPAF0[GPAF0.(7:6)] register bits, when set, override
GPDIR0 [DIR0.(7:6)] and configure GPIO0.[7:6] as
the PWM 1 output.
I
GPAF0[GPAF0.(5:4)] register bits, when set, override
GPDIR0[DIR0.(5:4)] and configure GPIO0.[5:4] as
PWM0 outputs.
I
GPAF1[GPAF1.(7:5)] register bits, when set, override
GPDIR[DIR1.(7:5)] and configure GPIO1.[7:5] as
input trigger sources for timers 2, 1, and 0 (for proper
timer operation, the microcontroller should also con-
figure the associated SFR register bit for each timer).
I
GPAF1[GPAF2.3] register bit, when set, overrides
the GPDIR2[DIR2.3] register bit and configures
GPIO2.3 as a SYNCO output from the dc/dc module
(see Section 13, dc/dc Control Generator).
I
GPAF1[GPAF2.2] register bit, when set, overrides
the GPDIR2[DIR2.2] register bit and configures
GPIO2.2 as the reference frame sync clock (FSC)
output as specified in Section 10, GCI+ Interface
Module.
I
GPAF1[GPAF2.1] register bit, when set, overrides
the GPDIR2[DIR2.1] register bit and configures
GPIO2.1 as the GCI bit clock (BCLK) output (as
specified in Section 10, GCI+ Interface Module).
I
GPAF1[GPRESET] provides a nonlatching software
reset of the GPIO module. It has the same effect as a
global reset or a global software reset.
I
DOCR[LT_NT] register bit, when set, ignores
GPDIR2[DIR2.6] and configures GPIO2.6 as the
input for 8 kHz master transmit clock (MTC) signal.
I
When the test pin (pin 43) is asserted, GPIO1.4 and
GPIO2.7 change their functions to USSP_E and
PTLB_S, respectively, as explained in Table 4.
All registers are read/write to allow read-modify-write
operations by the microcontroller. Transition activated
interrupt sources may be individually reset by writing a
1 to the associated bits of GPPOL register.
All GPIO port signals are TTL levels. Driving capability
is 6 mA for GPIO2.0 signal and 1 mA for all others.
Figure 20 summarizes features available for all GPIO
signals.
相關PDF資料 |
PDF描述 |
|---|---|
| T90RIA10 | MEDIUM POWER PHASE CONTROL THYRISTORS |
| T90RIA40 | MEDIUM POWER PHASE CONTROL THYRISTORS |
| T90RIA60 | MEDIUM POWER PHASE CONTROL THYRISTORS |
| T90RIA80 | MEDIUM POWER PHASE CONTROL THYRISTORS |
| T90RIA100 | MEDIUM POWER PHASE CONTROL THYRISTORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| T9001 | 功能描述:罩類、盒類及殼類產品 15x14x3-1/2(3.13cf) 1 Compartment RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red |
| T9006 | 功能描述:罩類、盒類及殼類產品 15 x 14 x 3-1/2 (2.96cf) RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red |
| T9007 | 功能描述:罩類、盒類及殼類產品 13 1/8 x 13 1/8 x 3" 6 COMPARTMENTS RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red |
| T9008 | 制造商:Nortools International Ltd 功能描述:HSS METRIC DIE SET,M3-M12 |
| T900BK | 功能描述:罩類、盒類及殼類產品 of Box Dividers Clear RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red |
發布緊急采購，3分鐘左右您將得到回復。