- 您現在的位置：買賣IC網 > PDF目錄383877 > T9000 (Lineage Power) ISDN Network Termination Node (NTN) Device(ISDN網絡終端節點器件) PDF資料下載
參數資料
| 型號： | T9000 |
| 廠商： | Lineage Power |
| 英文描述： | ISDN Network Termination Node (NTN) Device(ISDN網絡終端節點器件) |
| 中文描述： | ISDN網絡終端節點（新界西）設備（ISDN網網絡終端節點器件） |
| 文件頁數： | 33/126頁 |
| 文件大?。?/td> | 1523K |
| 代理商： | T9000 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁當前第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁
Lucent Technologies Inc.
33
Advance Data Sheet
April 2000
ISDN Network Termination Node (NTN) Device
T9000
7 Transmission Superblock
(continued)
7.6 DFAC Register Set
Table 22. DFCF: DFAC Configuration Register (0x05)
Reg
DFCF
RESET
R/W
R/W
Default
Bit 7
ILOSS
0
Bit 6
Bit 5
URESET
0
Bit 4
—
0
Bit 3
UOADS
1
Bit 2
Bit 1
Bit 0
GRESET
0
USIMRST
0
ACT_ANSI
0
AUTOEOC
1
Bit
7
Symbol
ILOSS
Name/Description
Insertion Loss Test Control.
Causes the U-interface transmitter to continuously transmit the sequence
SN1. The U-interface transceiver remains reset during this mode.
0: No effect on device operation.
1: U transmitter sends SN1 tone continuously.
Special Simulation Reset for U-Block.
This signal causes assertion of a special reset that is used for fac-
tory testing of the U block. This bit should always be programmed to 0.
0: No effect on device operation.
1: U-block simulation reset (nonlatching-value readback will always be 0).
U Transceiver Reset.
Assertion of this bit halts U-interface data transmission and clears adaptive filter
coefficients. During URESET, the U transmitter produces 0 V. The microcontroller may use this bit to put
the U-interface in a quiet mode for maintenance as described in ANSIT1.601 Section 6.5. In addition, this
bit should be asserted whenever return loss and longitudinal balance measurements are being made on the
U-interface.
0: No effect on device operation.
1: U block is held in reset (nonlatching-value readback will always be 0).
Reserved.
Program to 0.
6
USIMRST
5
URESET
4
3
—
UOADS
UOA Default State.
During activation, the bits UOA_n and OOF_n become transparent at the same time (at
U-interface synchronization time), but UOA_n is filtered for three occurrences before being acted upon, and
hence, a direct transition to the UOA state is not possible. To satisfy this ETSI ETR 080 requirement, the
UOADS bit allows the NTN to default to the presynchronization value of UOA_n to 0. Upon synchronization,
if UOADS = 0 is received, a transition to the UOA state occurs, because the 3-time filtering criteria is satis-
fied. UOADS defaults to 1, meaning that U-only activation, at start-up, causes the U-interface to fully syn-
chronize and then a transition to the UOA state occurs. It is recommended that UOADS be programmed to
1.
ACT Mode Select.
Controls the state of the transmitted ACT bit when an EOC loopback 2 (2B+D) is
requested. The loopback occurs automatically if AUTOEOC bit is set. Otherwise, bit U2BDLT must be set to
0.
0: ACT = 1 during loopback 2 after INFO3 is recognized at the S/T-interface (per ETSI ETR 080). The
data received by the NT is not looped back towards the LT until after ACT = 1 is received from the LT.
Prior to this time, 2B+D data toward the LT is all 1s.
1: ACT = 0 during loopback 2 (per
ANSI
T1.601). The data received at the NT is looped back towards the
LT as soon as the 2B+D loopback is enabled.
Automatic EOC Processor Enable.
Enables EOC state machine which implements EOC processing per
ETSI ETR 080 (see Section 7.3.1, EOC State Machine (EOCSM) for details on the EOC state machine
operation). The EOC state machine only responds to the addresses 000 and 111 as valid addresses.
0: EOC state machine disabled.
1: EOC state machine enabled.
Global Software Reset.
Assertion of this bit resets all internal modules except the 80C32 to their default
states. U-macro adaptive filter coefficients are cleared. Since performing a GRESET also resets this bit to its
default state, it is not necessary to write it back to a 0 after writing a 1.
0: No effect on device operation.
1: Reset all circuitry except internal 80C32.
2
ACT_ANSI
1
AUTOEOC
0
GRESET
相關PDF資料 |
PDF描述 |
|---|---|
| T90RIA10 | MEDIUM POWER PHASE CONTROL THYRISTORS |
| T90RIA40 | MEDIUM POWER PHASE CONTROL THYRISTORS |
| T90RIA60 | MEDIUM POWER PHASE CONTROL THYRISTORS |
| T90RIA80 | MEDIUM POWER PHASE CONTROL THYRISTORS |
| T90RIA100 | MEDIUM POWER PHASE CONTROL THYRISTORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| T9001 | 功能描述:罩類、盒類及殼類產品 15x14x3-1/2(3.13cf) 1 Compartment RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red |
| T9006 | 功能描述:罩類、盒類及殼類產品 15 x 14 x 3-1/2 (2.96cf) RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red |
| T9007 | 功能描述:罩類、盒類及殼類產品 13 1/8 x 13 1/8 x 3" 6 COMPARTMENTS RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red |
| T9008 | 制造商:Nortools International Ltd 功能描述:HSS METRIC DIE SET,M3-M12 |
| T900BK | 功能描述:罩類、盒類及殼類產品 of Box Dividers Clear RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red |
發布緊急采購，3分鐘左右您將得到回復。