- 您現在的位置：買賣IC網 > PDF目錄225250 > STW5094ADT/LF (STMICROELECTRONICS) SERIAL INPUT LOADING, 18-BIT DAC, PBGA36 PDF資料下載
參數資料
| 型號： | STW5094ADT/LF |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | DAC |
| 英文描述： | SERIAL INPUT LOADING, 18-BIT DAC, PBGA36 |
| 封裝： | 6 X 6 MM, 1.2 MM HEIGHT, TFBGA-36 |
| 文件頁數： | 52/52頁 |
| 文件大小： | 596K |
| 代理商： | STW5094ADT/LF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁當前第52頁
8/51
FUNCTIONAL DESCRIPTION
1 DEVICE MODES
STw5094A can work in 4 different modes, selected by bits MD in Control Register 21 (CR21). Depending
on the mode different data interfaces, clock inputs, and internal blocks are selected. A built-in power con-
sumption management function keeps in power down the blocks that are not needed by the selected op-
erating mode. In all the modes the Output Drivers can be activated in different combinations with bits PLS,
PHL, PHR in CR6 (in case of stereo input and LSP
N driver selected the Left channel is sent to this
driver, while in case of voice input and HPL + HPR drivers selected the same signal is sent to both driv-
ers).
1.1 Audio Mode
In Audio mode the path from the Audio interface (Au I
F) to the output drivers is active to allow the Stereo
Audio DAC function. The Au I
F is active while the PCM I F is inactive.
The master clock of the device is AMCK. The AMCK frequency is fixed, and independent from the audio
samples data rate (LRCK frequency). AMCK source can be any fixed system clock whose nominal fre-
quency value lies in the range 9.5MHz to 28MHz (the full range is covered in three sub-ranges, selected
by bits AMCK_DIV in CR18). The rate of the audio data (LRCK frequency) can be any value in the range
8kHz to 48kHz (non standard values are allowed) and does not need to be specified.
Since the AMCK clock is used directly in the D to A Converters section, its jitter and spectral properties
must be adequate to the desired Audio quality.
In Audio Mode there are additional functions for audio signal processing:
–
A digital volume control with 54 dB range is implemented (bits VOL in CR20). If the digital volume is
used in addition with the analog gain regulation a 94dB range volume is obtained.
–
Bass controls can be regulated in the -12.5dB to +12.5dB range in 2.5 dB step (bits BASS in CR19).
–
Treble controls can be regulated in the -6dB to +6dB range in 2 dB step (bits TREBLE in CR19).
–
The 50
s 15s de-emphasis filter is activated instead of treble controls (bits TREBLE in CR19).
Note: the time constants are referred to the 44.1kHz FS.
–
A dynamic range compressor is implemented (bit CMP in CR20).
Note:The de-emphasis filter and the Bass/Treble controls freq. responses scale with the input sampling rate.
The tone
ring DTMF generator can be activated if needed. In audio mode the frequency values of the
tones is a function of the AMCK frequency value as explained in Table 1.
1.2 Voice Mode
In Voice mode the TX path from microphone input to DX and the RX path from DR to the output drivers
are active to allow the PCM CODEC function. The PCM I
F is active while the Au I F is inactive.
The master clock of the device is MCLK, the frequency of the clock can be selected with bits F in CR0.
The tone
ring DTMF generator can be activated if needed.
1.3 Tone Only Mode
In tone only mode the path from the tone generator to the output drivers and to the buzzer is active to allow
tones or ringer listening only. Both Au I
F and PCM I F are inactive, as all the Audio and Voice converters
functions.
The master clock of the device can be selected to be AUXCLK, MCLK or AMCK (bits CFM in CR21).
1.4 FM Mode
In FM mode the path from FML and FMR analog inputs to the output Drivers is active to allow FM Stereo
Radio listening. Both Au I
F and PCM I F are inactive, as all the Audio and Voice converters functions.
The master clock of the device can be selected to be AUXCLK, MCLK or AMCK (bits CFM in CR21).
The Tone
Ring DTMF generator is in power down.
相關PDF資料 |
PDF描述 |
|---|---|
| STW5094AD/LF | SERIAL INPUT LOADING, 18-BIT DAC, PBGA36 |
| SU-1-B3 | POWER TRANSFORMER, 1000 VA |
| SU-1/2-B2 | POWER TRANSFORMER, 500 VA |
| SU-1/4-B1 | POWER TRANSFORMER, 250 VA |
| SU-10-B8 | POWER TRANSFORMER, 10000 VA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| STW5094T | 功能描述:音頻 DSP 14-Bit Linear CODEC RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| STW5095 | 制造商:ST-Ericsson 功能描述:- Trays 制造商:STMicroelectronics 功能描述:AUD CODEC 1ADC / 1DAC 20-BIT 64TFBGA - Trays |
| STW5095/E01 | 功能描述:BOARD EVAL I2C/SPI STW5095 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 標準包裝:1 系列:PCI Express® (PCIe) 主要目的:接口，收發器，PCI Express 嵌入式:- 已用 IC / 零件:DS80PCI800 主要屬性:- 次要屬性:- 已供物品:板 |
| STW5095/M01 | 制造商:ST-Ericsson 功能描述:- Bulk |
| STW5095_07 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Low-power asynchronous stereo audio Codec with integrated power amplifiers |
發布緊急采購，3分鐘左右您將得到回復。