參數資料
型號: STM32W108HBU7
廠商: STMICROELECTRONICS
元件分類: 微控制器/微處理器
英文描述: SPECIALTY MICROPROCESSOR CIRCUIT, QCC40
封裝: 6 X 6 MM, 0.50 MM PITCH, ROHS COMPLIANT, VFQFPN-40
文件頁數: 17/198頁
文件大?。?/td> 2871K
代理商: STM32W108HBU7
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁
STM32W108CB, STM32W108HB
General-purpose timers
Doc ID 16252 Rev 3
113/198
Enable capture from the counter into the capture register by setting the TIM_CC1E bit
in the TIMx_CCER register.
If needed, enable the related interrupt request by setting the INT_TIMCC1IF bit in the
INT_TIMxCFG register.
When an input capture occurs:
The TIMx_CCR1 register gets the value of the counter on the active transition.
INT_TIMCC1IF flag is set (capture/compare interrupt flag). The missed
capture/compare flag INT_TIMMISSCC1IF in INT_TIMxMISS is also set if another
capture occurs before the INT_TIMCC1IF flag is cleared.
An interrupt may be generated if enabled by the INT_TIMCC1IF bit.
To detect missed captures reliably, read captured data in TIMxCCRy before checking the
missed capture/compare flag. This sequence avoids missing a capture that could happen
after reading the flag and before reading the data.
Note:
Software can generate IC interrupt requests by setting the corresponding TIM_CCyG bit in
the TIMx_EGR register.
10.1.6
PWM input mode
This mode is a particular case of input capture mode. The procedure is the same except:
Two ICy signals are mapped on the same TIy input.
These two ICy signals are active on edges with opposite polarity.
One of the two TIyFP signals is selected as trigger input and the slave mode controller
is configured in reset mode.
For example, to measure the period in the TIMx_CCR1 register and the duty cycle in the
TIMx_CCR2 register of the PWM applied on TI1, use the following procedure depending on
CK_INT frequency and prescaler value:
Select the active input for TIMx_CCR1: write the TIM_CC1S bits to 01 in the
TIMx_CCMR1 register (TI1 selected).
Select the active polarity for TI1FP1, used both for capture in the TIMx_CCR1 and
counter clear, by writing the TIM_CC1P bit to 0 (active on rising edge).
Select the active input for TIMx_CCR2by writing the TIM_CC2S bits to 10 in the
TIMx_CCMR1 register (TI1 selected).
Select the active polarity for TI1FP2 (used for capture in the TIMx_CCR2) by writing the
TIM_CC2P bit to 1 (active on falling edge).
Select the valid trigger input by writing the TIM_TS bits to 101 in the TIMx_SMCR
register (TI1FP1 selected).
Configure the slave mode controller in reset mode by writing the TIM_SMS bits to 100
in the TIMx_SMCR register.
Enable the captures by writing the TIM_CC1E and TIM_CC2E bits to 1 in the
TIMx_CCER register.
相關PDF資料
PDF描述
STP506C-2IW-012V SINGLE COLOR DISPLAY CLUSTER, WHITE, 152.4 mm
SUGR47M DUAL COLOR LED, RED/GREEN, 5 mm
SUR76D SINGLE COLOR LED, RED, 3 mm
SUY17D SINGLE COLOR LED, YELLOW, 3.9 mm
SY405T SINGLE COLOR LED, AMBER, 2.7 mm
相關代理商/技術參數
參數描述
STM32WC-RFCKIT 功能描述:Zigbee/802.15.4開發工具 STM32W Low-Cost RF STM32F103 MCU Kit RoHS:否 制造商:Silicon Labs 產品:Development Kits 工具用于評估:EM35x 頻率:2.4 GHz 接口類型:USB 工作電源電壓:
STM32W-RFCKIT 功能描述:開發板和工具包 - 無線 STM32W RF CNTRL KIT STM32F103 USB JTAG RoHS:否 制造商:Arduino 產品:Evaluation Boards 工具用于評估:AT32UC3L 核心:AVR32 頻率: 接口類型:USB 工作電源電壓:5 V
STM3-3 制造商:RINO MECH.(GENGARELL 功能描述:
STM330 制造商:EnOcean GmbH 功能描述:Temperature energy harvester, 868MHz
STM330U 制造商:EnOcean GmbH 功能描述:Temperature energy harvester, 315MHz 制造商:EnOcean GmbH 功能描述:Temperature energy harvester, 902MHz