- 您現在的位置：買賣IC網 > PDF目錄19292 > SPAKDSP311VL150 (Freescale Semiconductor)IC DSP 24BIT 150MHZ 196-MAPBGA PDF資料下載
參數資料
| 型號： | SPAKDSP311VL150 |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 2/96頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DSP 24BIT 150MHZ 196-MAPBGA |
| 標準包裝： | 2 |
| 系列： | DSP56K/Symphony |
| 類型： | 定點 |
| 接口： | 主機接口，SSI，SCI |
| 時鐘速率： | 150MHz |
| 非易失內存： | ROM（576 B） |
| 芯片上RAM： | 384kB |
| 電壓 - 輸入/輸出： | 3.30V |
| 電壓 - 核心： | 1.80V |
| 工作溫度： | -40°C ~ 100°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 196-LBGA |
| 供應商設備封裝： | 196-MAPBGA（15x15） |
| 包裝： | 托盤 |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁
DSP56311 Technical Data, Rev. 8
1-6
Freescale Semiconductor
Signals/Connections
BR
Output
Reset: Output
(deasserted)
State during Stop/Wait
depends on BRH bit
setting:
BRH = 0: Output,
deasserted
BRH = 1: Maintains
last state (that is, if
asserted, remains
asserted)
Bus Request—Asserted when the DSP requests bus mastership. BR is deasserted
when the DSP no longer needs the bus. BR may be asserted or deasserted
independently of whether the DSP56311 is a bus master or a bus slave. Bus
“parking” allows BR to be deasserted even though the DSP56311 is the bus master.
(See the description of bus “parking” in the BB signal description.) The bus request
hold (BRH) bit in the BCR allows BR to be asserted under software control even
though the DSP does not need the bus. BR is typically sent to an external bus
arbitrator that controls the priority, parking, and tenure of each master on the same
external bus. BR is affected only by DSP requests for the external bus, never for the
internal bus. During hardware reset, BR is deasserted and the arbitration is reset to
the bus slave state.
BG
Input
Ignored Input
Bus Grant—Asserted by an external bus arbitration circuit when the DSP56311
becomes the next bus master. When BG is asserted, the DSP56311 must wait until
BB is deasserted before taking bus mastership. When BG is deasserted, bus
mastership is typically given up at the end of the current bus cycle. This may occur in
the middle of an instruction that requires more than one external bus cycle for
execution.
The default operation of this bit requires a set-up and hold time as specified in
Chapter 2
. An alternate mode can be invoked: set the asynchronous bus arbitration
enable (ABE) bit (Bit 13) in the Operating Mode Register. When this bit is set, BG and
BB are synchronized internally. This eliminates the respective set-up and hold time
requirements but adds a required delay between the deassertion of an initial BG input
and the assertion of a subsequent BG input.
BB
Input/ Output
Ignored Input
Bus Busy—Indicates that the bus is active. Only after BB is deasserted can the
pending bus master become the bus master (and then assert the signal again). The
bus master may keep BB asserted after ceasing bus activity regardless of whether
BR is asserted or deasserted. Called “bus parking,” this allows the current bus master
to reuse the bus without rearbitration until another device requires the bus. BB is
deasserted by an “active pull-up” method (that is, BB is driven high and then released
and held high by an external pull-up resistor).
The default operation of this signal requires a set-up and hold time as specified in
Chapter 2. An alternative mode can be invoked by setting the ABE bit (Bit 13) in the
Operating Mode Register. When this bit is set, BG and BB are synchronized
internally. See BG for additional information.
Note: BB requires an external pull-up resistor.
CAS
Output
Tri-stated
Column Address Strobe—When the DSP is the bus master, CAS is an active-low
output used by DRAM to strobe the column address. Otherwise, if the Bus
Mastership Enable (BME) bit in the DRAM control register is cleared, the signal is tri-
stated.
Note: DRAM access is not supported above 100 MHz.
BCLK
Output
Tri-stated
Bus Clock
When the DSP is the bus master, BCLK is active when the ATE bit in the Operating
Mode Register is set. When BCLK is active and synchronized to CLKOUT by the
internal PLL, BCLK precedes CLKOUT by one-fourth of a clock cycle.
Note: At operating frequencies above 100 MHz, this signal produces a low-amplitude
waveform that is not usable externally by other devices.
BCLK
Output
Tri-stated
Bus Clock Not
When the DSP is the bus master, BCLK is the inverse of the BCLK signal. Otherwise,
the signal is tri-stated.
Note: At operating frequencies above 100 MHz, this signal produces a low-amplitude
waveform that is not usable externally by other devices.
Table 1-8.
External Bus Control Signals (Continued)
Signal
Name
Type
State During Reset,
Stop, or Wait
Signal Description
相關PDF資料 |
PDF描述 |
|---|---|
| VE-24T-CW-F1 | CONVERTER MOD DC/DC 6.5V 100W |
| VE-24P-CW-F3 | CONVERTER MOD DC/DC 13.8V 100W |
| VE-2TR-CW-F4 | CONVERTER MOD DC/DC 7.5V 100W |
| VI-25B-CY-S | CONVERTER MOD DC/DC 95V 50W |
| TPSD156M025R0100 | CAP TANT 15UF 25V 20% 2917 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SPAKDSP321VF240 | 功能描述:IC DSP 24BIT 196-MAPBGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:DSP56K/Symphony 標準包裝:40 系列:TMS320DM64x, DaVinci™ 類型:定點 接口:I²C，McASP，McBSP 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:160kB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:0°C ~ 90°C 安裝類型:表面貼裝 封裝/外殼:548-BBGA，F(xiàn)CBGA 供應商設備封裝:548-FCBGA（27x27） 包裝:托盤 配用:TMDSDMK642-0E-ND - DEVELPER KIT W/NTSC CAMERA296-23038-ND - DSP STARTER KIT FOR TMS320C6416296-23059-ND - FLASHBURN PORTING KIT296-23058-ND - EVAL MODULE FOR DM642TMDSDMK642-ND - DEVELOPER KIT W/NTSC CAMERA |
| SPAKDSP321VF275 | 功能描述:IC DSP 24BIT 196-MAPBGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:DSP56K/Symphony 標準包裝:40 系列:TMS320DM64x, DaVinci™ 類型:定點 接口:I²C，McASP，McBSP 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:160kB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:0°C ~ 90°C 安裝類型:表面貼裝 封裝/外殼:548-BBGA，F(xiàn)CBGA 供應商設備封裝:548-FCBGA（27x27） 包裝:托盤 配用:TMDSDMK642-0E-ND - DEVELPER KIT W/NTSC CAMERA296-23038-ND - DSP STARTER KIT FOR TMS320C6416296-23059-ND - FLASHBURN PORTING KIT296-23058-ND - EVAL MODULE FOR DM642TMDSDMK642-ND - DEVELOPER KIT W/NTSC CAMERA |
| SPAKDSP321VL240 | 功能描述:IC DSP 24BIT 240MHZ 196-MAPBGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:DSP56K/Symphony 標準包裝:2 系列:StarCore 類型:SC140 內核 接口:DSI，以太網，RS-232 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:1.436MB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:431-BFBGA，F(xiàn)CBGA 供應商設備封裝:431-FCPBGA（20x20） 包裝:托盤 |
| SPAKDSP321VL275 | 功能描述:IC DSP 24BIT 275MHZ 196-MAPBGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:DSP56K/Symphony 標準包裝:40 系列:TMS320DM64x, DaVinci™ 類型:定點 接口:I²C，McASP，McBSP 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:160kB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:0°C ~ 90°C 安裝類型:表面貼裝 封裝/外殼:548-BBGA，F(xiàn)CBGA 供應商設備封裝:548-FCBGA（27x27） 包裝:托盤 配用:TMDSDMK642-0E-ND - DEVELPER KIT W/NTSC CAMERA296-23038-ND - DSP STARTER KIT FOR TMS320C6416296-23059-ND - FLASHBURN PORTING KIT296-23058-ND - EVAL MODULE FOR DM642TMDSDMK642-ND - DEVELOPER KIT W/NTSC CAMERA |
| SPAKDSP56824BU70 | 制造商:Freescale Semiconductor 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。