- 您現在的位置：買賣IC網 > PDF目錄225172 > SDCFBI-30-101 (SANDISK CORP) FLASH MEMORY DRIVE CONTROLLER, XMA50 PDF資料下載
參數資料
| 型號： | SDCFBI-30-101 |
| 廠商： | SANDISK CORP |
| 元件分類： | 存儲控制器/管理單元 |
| 英文描述： | FLASH MEMORY DRIVE CONTROLLER, XMA50 |
| 封裝： | PC CARD-50 |
| 文件頁數： | 63/124頁 |
| 文件大小： | 769K |
| 代理商： | SDCFBI-30-101 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁當前第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁
CompactFlash Memory Card Product Manual
SanDisk CompactFlash Memory Card Product Manual 1999 SANDISK CORPORATION
43
Changed
Indicates that one or both of the Pin Replacement register CRdy, or CWProt bits are set to one (1).
When the Changed bit is set, -STSCHG Pin 46 is held low if the SigChg bit is a One (1) and the
CompactFlash Memory Card is configured for the I/O interface.
SigChg
This bit is set and reset by the host to enable and disable a state-change “signal” from the Status
Register, the Changed bit control pin 46 the Changed Status signal. If no state change signal is
desired, this bit should be set to zero (0) and pin 46 (-STSCHG) signal will be held high while the
CompactFlash Memory Card is configured for I/O.
IOis8
The host sets this bit to a one (1) if the CompactFlash Memory Card is to be configured in an 8 bit
I/O mode. The CompactFlash Card is always configured for both 8- and 16-bit I/O, so this bit is
ignored.
PwrDwn
This bit indicates whether the host requests the CompactFlash Memory Card to be in the power
saving or active mode. When the bit is one (1), the CompactFlash Card enters a power down mode.
When zero (0), the host is requesting the CompactFlash Card to enter the active mode. The
PCMCIA Rdy/-Bsy value becomes BUSY when this bit is changed. Rdy/-Bsy will not become Ready
until the power state requested has been entered. The CompactFlash Card automatically powers
down when it is idle and powers back up when it receives a command.
Int
This bit represents the internal state of the interrupt request. This value is available whether or not
I/O interface has been configured. This signal remains true until the condition which caused the
interrupt request has been serviced. If interrupts are disabled by the -IEN bit in the Device Control
Register, this bit is a zero (0).
4.4.4
Pin Replacement Register (Address 204h
in Attribute Memory)
Operation
D 7
D 6
D 5
D 4
D 3
D 2
D 1
D 0
Read
0
CRdy/-Bsy
CWProt
1
RRdy/-Bsy
RWProt
Write
0
CRdy/-Bsy
CWProt
0
MRdy/-Bsy
MWProt
CRdy/-Bsy
This bit is set to one (1) when the bit RRdy/-Bsy changes state. This bit can also be written by the
host.
CWProt
This bit is set to one (1) when the RWprot changes state. This bit may also be written by the host.
RRdy/-Bsy
This bit is used to determine the internal state of the Rdy/-Bsy signal. This bit may be used to
determine the state of the Ready/-Busy as this pin has been reallocated for use as Interrupt
Request on an I/O card. When written, this bit acts as a mask for writing the corresponding bit
CRdy/-Bsy.
RWProt
This bit is always zero (0) since the CompactFlash Memory Card does not have a Write Protect
switch. When written, this bit acts as a mask for writing the corresponding bit CWProt.
MRdy/-Bsy
This bit acts as a mask for writing the corresponding bit CRdy/-Bsy.
MWProt
This bit when written acts as a mask for writing the corresponding bit CWProt.
相關PDF資料 |
PDF描述 |
|---|---|
| SDD-3-023 | SLIDE DIP SWITCH-3SWITCHES, DPST, MOMENTARY,THROUGH HOLE-STRAIGHT |
| SDD-6-023 | SLIDE DIP SWITCH-6SWITCHES, DPST, MOMENTARY,THROUGH HOLE-STRAIGHT |
| SDC-5-023 | SLIDE DIP SWITCH-5SWITCHES, SPDT, MOMENTARY,THROUGH HOLE-STRAIGHT |
| SDF330JABEGD1Z | 5.5 A, 400 V, 1.1 ohm, N-CHANNEL, Si, POWER, MOSFET |
| SDF350JAAEHD1B | 15 A, 400 V, 0.3 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-254AA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SDCFCF-001G-388 | 功能描述:COMPACT FLASH IND 1GB FIXED RoHS:是 類別:存儲卡，模塊 >> 存儲器，PC 卡 系列:- 標準包裝:30 系列:- 存儲容量:8GB 存儲器類型:存儲卡 - Extreme III SD? |
| SDCFCF-002G-388 | 功能描述:COMPACT FLASH IND 2GB FIXED RoHS:是 類別:存儲卡，模塊 >> 存儲器，PC 卡 系列:- 標準包裝:30 系列:- 存儲容量:8GB 存儲器類型:存儲卡 - Extreme III SD? |
| SDCFCF-004G-388 | 功能描述:COMPACT FLASH IND 4GB FIXED RoHS:是 類別:存儲卡，模塊 >> 存儲器，PC 卡 系列:- 標準包裝:30 系列:- 存儲容量:8GB 存儲器類型:存儲卡 - Extreme III SD? |
| SDCFCF-008G-388 | 功能描述:COMPACT FLASH IND 8GB FIXED RoHS:是 類別:存儲卡，模塊 >> 存儲器，PC 卡 系列:- 標準包裝:30 系列:- 存儲容量:8GB 存儲器類型:存儲卡 - Extreme III SD? |
| SDCFCF-016G-388 | 功能描述:COMPACT FLASH IND 16GB FIXED RoHS:是 類別:存儲卡，模塊 >> 存儲器，PC 卡 系列:- 標準包裝:30 系列:- 存儲容量:8GB 存儲器類型:存儲卡 - Extreme III SD? |
發布緊急采購，3分鐘左右您將得到回復。