參數資料
型號: SDCFBI-30-101
廠商: SANDISK CORP
元件分類: 存儲控制器/管理單元
英文描述: FLASH MEMORY DRIVE CONTROLLER, XMA50
封裝: PC CARD-50
文件頁數: 45/124頁
文件大?。?/td> 769K
代理商: SDCFBI-30-101
CompactFlash Memory Card Product Manual
SanDisk CompactFlash Memory Card Product Manual 1999 SANDISK CORPORATION
27
Table 4-2 Signal Description (continued)
Signal Name
Dir.
Pin
Description
-CSEL
(PC Card Memory Mode)
I
39
This signal is not used for this mode.
-CSEL
(PC Card I/O Mode)
This signal is not used for this mode.
-CSEL
(True IDE Mode)
This internally pulled up signal is used to configure this device
as a Master or a Slave when configured in the True IDE Mode.
When this pin is grounded, this device is configured as a
Master. When the pin is open, this device is configured as a
Slave.
D15 - D00
(PC Card Memory Mode)
I/O
31, 30, 29, 28,
27, 49, 48, 47,
6, 5, 4, 3, 2,
23, 22, 21
These lines carry the Data, Commands and Status information
between the host and the controller. D00 is the LSB of the Even
Byte of the Word. D08 is the LSB of the Odd Byte of the Word.
D15 - D00
(PC Card I/O Mode)
This signal is the same as the PC Card Memory Mode signal.
D15 - D00
(True IDE Mode)
In True IDE Mode, all Task File operations occur in byte mode on
the low order bus D00-D07 while all data transfers are 16 bit
using D00-D15.
GND
(PC Card Memory Mode)
--
1, 50
Ground.
GND
(PC Card I/O Mode)
This signal is the same for all modes.
GND
(True IDE Mode)
This signal is the same for all modes.
-INPACK
( PC Card Memory Mode)
O
43
This signal is not used in this mode.
-INPACK
( PC Card I/O Mode)
Input Acknowledge
The Input Acknowledge signal is asserted by the CompactFlash
Card when the card is selected and responding to an I/O read
cycle at the address that is on the address bus. This signal is
used by the host to control the enable of any input data buffers
between the card and the CPU.
-INPACK
(True IDE Mode)
In True IDE Mode this output signal is not used and should not
be connected at the host.
-IORD
(PC Card Memory Mode)
I
34
This signal is not used in this mode.
-IORD
(PC Card I/O Mode)
This is an I/O Read strobe generated by the host. This signal
gates I/O data onto the bus from the CompactFlash Card when
the card is configured to use the I/O interface.
-IORD
(True IDE Mode)
In True IDE Mode, this signal has the same function as in PC
Card I/O Mode.
相關PDF資料
PDF描述
SDD-3-023 SLIDE DIP SWITCH-3SWITCHES, DPST, MOMENTARY,THROUGH HOLE-STRAIGHT
SDD-6-023 SLIDE DIP SWITCH-6SWITCHES, DPST, MOMENTARY,THROUGH HOLE-STRAIGHT
SDC-5-023 SLIDE DIP SWITCH-5SWITCHES, SPDT, MOMENTARY,THROUGH HOLE-STRAIGHT
SDF330JABEGD1Z 5.5 A, 400 V, 1.1 ohm, N-CHANNEL, Si, POWER, MOSFET
SDF350JAAEHD1B 15 A, 400 V, 0.3 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-254AA
相關代理商/技術參數
參數描述
SDCFCF-001G-388 功能描述:COMPACT FLASH IND 1GB FIXED RoHS:是 類別:存儲卡,模塊 >> 存儲器,PC 卡 系列:- 標準包裝:30 系列:- 存儲容量:8GB 存儲器類型:存儲卡 - Extreme III SD?
SDCFCF-002G-388 功能描述:COMPACT FLASH IND 2GB FIXED RoHS:是 類別:存儲卡,模塊 >> 存儲器,PC 卡 系列:- 標準包裝:30 系列:- 存儲容量:8GB 存儲器類型:存儲卡 - Extreme III SD?
SDCFCF-004G-388 功能描述:COMPACT FLASH IND 4GB FIXED RoHS:是 類別:存儲卡,模塊 >> 存儲器,PC 卡 系列:- 標準包裝:30 系列:- 存儲容量:8GB 存儲器類型:存儲卡 - Extreme III SD?
SDCFCF-008G-388 功能描述:COMPACT FLASH IND 8GB FIXED RoHS:是 類別:存儲卡,模塊 >> 存儲器,PC 卡 系列:- 標準包裝:30 系列:- 存儲容量:8GB 存儲器類型:存儲卡 - Extreme III SD?
SDCFCF-016G-388 功能描述:COMPACT FLASH IND 16GB FIXED RoHS:是 類別:存儲卡,模塊 >> 存儲器,PC 卡 系列:- 標準包裝:30 系列:- 存儲容量:8GB 存儲器類型:存儲卡 - Extreme III SD?