參數資料
型號： SDCFBI-30-101
廠商： SANDISK CORP
元件分類： 存儲控制器/管理單元
英文描述： FLASH MEMORY DRIVE CONTROLLER, XMA50
封裝： PC CARD-50
文件頁數： 44/124頁
文件大?。?/td> 769K
代理商： SDCFBI-30-101
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁當前第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁
CompactFlash Memory Card Product Manual
SanDisk CompactFlash Memory Card Product Manual 1999 SANDISK CORPORATION
26
Table 4-2 Signal Description
Signal Name
Dir.
Pin
Description
A10 - A0
(PC Card Memory Mode)
I
8, 10, 11, 12,
14, 15, 16, 17,
18, 19, 20
These address lines along with the -REG signal are used to
select the following: The I/O port address registers within the
CompactFlash Card, the memory mapped port address registers
within the card, a byte in the card's information structure and its
configuration control and status registers.
A10 - A0
(PC Card I/O Mode)
This signal is the same as the PC Card Memory Mode signal.
A2 - A0
(True IDE Mode)
A10 - A3
(True IDE Mode)
I
18, 19, 20
In True IDE Mode only A[2:0] are used to select the one of eight
registers in the Task File.
In True IDE Mode, these remaining address lines should be
grounded by the host.
BVD1
(PC Card Memory Mode)
I/O
46
This signal is asserted high as the BVD1 signal since a battery
is not used with this product.
-STSCHG
(PC Card I/O Mode)
Status Changed
This signal is asserted low to alert the host to changes in the
RDY/-BSY and Write Protect states, while the I/O interface is
configured. Its use is controlled by the Card Config and Status
Register.
-PDIAG
(True IDE Mode)
In the True IDE Mode, this input / output is the Pass Diagnostic
signal in the Master / Slave handshake protocol.
BVD2
(PC Card Memory Mode)
I/O
45
This output line is always driven to a high state in Memory Mode
since a battery is not required for this product.
-SPKR
(PC Card I/O Mode)
This output line is always driven to a high state in I/O Mode
since this product does not support the audio function.
-DASP
(True IDE Mode)
In the True IDE Mode, this input/output is the Disk Active/Slave
Present signal in the Master/Slave handshake protocol.
-CD1, -CD2
(PC Card Memory Mode)
O
26, 25
These Card Detect pins are connected to ground on the
CompactFlash Card. They are used by the host to determine if
the card is fully inserted into its socket.
-CD1, -CD2
(PC Card I/O Mode)
This signal is the same for all modes.
-CD1, -CD2
(True IDE Mode)
This signal is the same for all modes.
-CE1, -CE2
(PC Card Memory Mode)
Card Enable
I
7, 32
These input signals are used both to select the card and to
indicate to the card whether a byte or a word operation is being
performed. -CE2 always accesses the odd byte of the word.
-CE1 accesses the even byte or the Odd byte of the word
depending on A0 and -CE2. A multi-plexing scheme based on
A0, -CE1, -CE2 allows 8 bit hosts to access all data on D0-D7.
See Tables 4-11, 4-12, 4-15, and 4-16.
-CE1, -CE2
(PC Card I/O Mode)
Card Enable
This signal is the same as the PC Card Memory Mode signal.
-CS0, -CS1
(True IDE Mode)
In the True IDE Mode -CS0 is the chip select for the task file
registers while -CS1 is used to select the Alternate Status
Register and the Device Control Register.
相關PDF資料
PDF描述
SDD-3-023 SLIDE DIP SWITCH-3SWITCHES, DPST, MOMENTARY,THROUGH HOLE-STRAIGHT
SDD-6-023 SLIDE DIP SWITCH-6SWITCHES, DPST, MOMENTARY,THROUGH HOLE-STRAIGHT
SDC-5-023 SLIDE DIP SWITCH-5SWITCHES, SPDT, MOMENTARY,THROUGH HOLE-STRAIGHT
SDF330JABEGD1Z 5.5 A, 400 V, 1.1 ohm, N-CHANNEL, Si, POWER, MOSFET
SDF350JAAEHD1B 15 A, 400 V, 0.3 ohm, N-CHANNEL, Si, POWER, MOSFET, TO-254AA
相關代理商/技術參數
參數描述
SDCFCF-001G-388 功能描述:COMPACT FLASH IND 1GB FIXED RoHS:是 類別:存儲卡，模塊 >> 存儲器，PC 卡 系列:- 標準包裝:30 系列:- 存儲容量:8GB 存儲器類型:存儲卡 - Extreme III SD?
SDCFCF-002G-388 功能描述:COMPACT FLASH IND 2GB FIXED RoHS:是 類別:存儲卡，模塊 >> 存儲器，PC 卡 系列:- 標準包裝:30 系列:- 存儲容量:8GB 存儲器類型:存儲卡 - Extreme III SD?
SDCFCF-004G-388 功能描述:COMPACT FLASH IND 4GB FIXED RoHS:是 類別:存儲卡，模塊 >> 存儲器，PC 卡 系列:- 標準包裝:30 系列:- 存儲容量:8GB 存儲器類型:存儲卡 - Extreme III SD?
SDCFCF-008G-388 功能描述:COMPACT FLASH IND 8GB FIXED RoHS:是 類別:存儲卡，模塊 >> 存儲器，PC 卡 系列:- 標準包裝:30 系列:- 存儲容量:8GB 存儲器類型:存儲卡 - Extreme III SD?
SDCFCF-016G-388 功能描述:COMPACT FLASH IND 16GB FIXED RoHS:是 類別:存儲卡，模塊 >> 存儲器，PC 卡 系列:- 標準包裝:30 系列:- 存儲容量:8GB 存儲器類型:存儲卡 - Extreme III SD?
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*