參數資料
型號: SAK-XC2765X-72F80LAA
廠商: INFINEON TECHNOLOGIES AG
元件分類: 微控制器/微處理器
英文描述: 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP100
封裝: 0.50 MM PITCH, GREEN, PLASTIC, LQFP-100
文件頁數: 86/123頁
文件大?。?/td> 1000K
代理商: SAK-XC2765X-72F80LAA
XC2765X
XC2000 Family Derivatives / Base Line
Functional Description
Data Sheet
65
V2.0, 2009-03
3.16
Watchdog Timer
The Watchdog Timer is one of the fail-safe mechanisms which have been implemented
to prevent the controller from malfunctioning for longer periods of time.
The Watchdog Timer is always enabled after an application reset of the chip. It can be
disabled and enabled at any time by executing the instructions DISWDT and ENWDT
respectively. The software has to service the Watchdog Timer before it overflows. If this
is not the case because of a hardware or software failure, the Watchdog Timer
overflows, generating a prewarning interrupt and then a reset request.
The Watchdog Timer is a 16-bit timer clocked with the system clock divided by 16,384
or 256. The Watchdog Timer register is set to a prespecified reload value (stored in
WDTREL) in order to allow further variation of the monitored time interval. Each time it
is serviced by the application software, the Watchdog Timer is reloaded and the
prescaler is cleared.
Time intervals between 3.2
μs and 13.4 s can be monitored (@ 80 MHz).
The default Watchdog Timer interval after power-up is 6.5 ms (@ 10 MHz).
3.17
Clock Generation
The Clock Generation Unit can generate the system clock signal
f
SYS for the XC2765X
from a number of external or internal clock sources:
External clock signals with pad voltage or core voltage levels
External crystal or resonator using the on-chip oscillator
On-chip clock source for operation without crystal/resonator
Wake-up clock (ultra-low-power) to further reduce power consumption
The programmable on-chip PLL with multiple prescalers generates a clock signal for
maximum system performance from standard crystals, a clock input signal, or from the
on-chip clock source. See also Section 4.6.2.
The Oscillator Watchdog (OWD) generates an interrupt if the crystal oscillator frequency
falls below a certain limit or stops completely. In this case, the system can be supplied
with an emergency clock to enable operation even after an external clock failure.
All available clock signals can be output on one of two selectable pins.
相關PDF資料
PDF描述
SAK-XC2768X-136F128L 32-BIT, FLASH, 128 MHz, RISC MICROCONTROLLER, PQFP100
SAK-XE160FU-4F40R 16-BIT, FLASH, 40 MHz, RISC MICROCONTROLLER, PDSO38
SAK-XE169FH-136F100L 16-BIT, FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP176
SAL-TC1766-192F80U 32-BIT, FLASH, 80 MHz, MICROCONTROLLER, UUC231
SAL-XC866L-4FRA 8-BIT, FLASH, 75 MHz, MICROCONTROLLER, PDSO38
相關代理商/技術參數
參數描述
SAK-XC2766X-96F66L AC 功能描述:16位微控制器 - MCU 16 BIT FLASH C11 BCS RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
SAK-XC2766X-96F66L66 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16/32-Bit Single-Chip Microcontroller with 32-Bit Performance
SAK-XC2768X-136F128L AA 功能描述:16位微控制器 - MCU 16/32b Sngl Chip MCU 32Bit Perform 128MHz RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
SAK-XC2785X-104F80L AA 功能描述:16位微控制器 - MCU 16 BIT FLASH C11 BCS RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
SAK-XC2785X-72F80L AA 功能描述:IC MCU 32BIT FLASH 144-LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:XC27x5X 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:260 系列:73S12xx 核心處理器:80515 芯體尺寸:8-位 速度:24MHz 連通性:I²C,智能卡,UART/USART,USB 外圍設備:LED,POR,WDT 輸入/輸出數:9 程序存儲器容量:64KB(64K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:2K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:68-VFQFN 裸露焊盤 包裝:管件