- 您現在的位置：買賣IC網 > PDF目錄98070 > S3F49FAXZA FLASH MEMORY DRIVE CONTROLLER, PQFP100 PDF資料下載
參數資料
| 型號： | S3F49FAXZA |
| 元件分類： | 存儲控制器/管理單元 |
| 英文描述： | FLASH MEMORY DRIVE CONTROLLER, PQFP100 |
| 封裝： | 14 X 14 MM, TQFP-100 |
| 文件頁數： | 5/27頁 |
| 文件大?。?/td> | 282K |
| 代理商： | S3F49FAXZA |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
SPECIFICATION
S3F49FAX
12
Table 3. Signal Description for PCMCIA/IDE Interface (Continued)
Signal Name
100-Pin Number
I/O
Description
XREG
76
I
ATTRIBUTE MEMORY AREA SELECTION:
This signal is used during memory cycles to distinguish
between common memory and register (Attribute) memory
accesses. High for Common memory, low for attribute
memory.
The signal must also be active (low) during I/O cycles when
the I/O address is on the Bus.
In True IDE mode, this input signal is not used and should be
connected to VCC by the host.
XCE1
XCE2
99
98
I
CARD ENABLE:
These input signals are used both to select the card and to
indicate to the card whether a byte or a word operation is
being performed.
-CE2 always accesses the odd byte of the word.
-CE1 accesses the even byte or the Odd byte of the
word depending on A0 and -CE2. A multi-plexing
scheme based on A0, -CE1, -CE2 allows 8 bit hosts
to access all data on XDB0-XDB7.
This signal is the same as the PC card memory mode signal
in PC Card I/O mode.In the True IDE mode, CS0 is the chip
select for the task file registers while CS1 is used to select
the alternate status register and the device control register.
XOE
96
I
OUTPUT ENABLE:
This is an output enable strobe generated by the host
interface. It is used to read data from the PC Card in memory
mode and to read the CIS and configuration registers.
In PC Card I/O mode, this signal is used to read the CIS and
configuration registers. To enable True IDE mode this input
should be grounded by the host.
相關PDF資料 |
PDF描述 |
|---|---|
| S3FB42F-TX | 8-BIT, FLASH, 30 MHz, RISC MICROCONTROLLER, PQFP100 |
| S3FC40D | RISC MICROCONTROLLER, PQFP100 |
| S3P1860-DK | 4-BIT, OTPROM, 6 MHz, MICROCONTROLLER, PDIP20 |
| S3C1860XX-SK | 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDSO20 |
| S3C1860XX-DK | 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDIP20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| S3F49FAXZZ | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:S3F49FAX for Compact Flash SPECIFICATION Revision 1.0 |
| S-3-F-4-D S/C SS SPGS | 功能描述:觸點探頭 HEADED FLAT STAINLESS STEEL SPGS RoHS:否 制造商:IDI 類型:Probes 尖端類型:Spherical Radius 長度:8.26 mm 電流額定值:10 A 彈力:2.3 oz 行程:1.52 mm 系列:101050 |
| S-3-F-4-G | 制造商:Interconnect Devices Inc (IDI) 功能描述:FLAT TIP 0.125 CENTERLINE SPACING SPRING CONTACT PROBE 制造商:Interconnect Devices Inc (IDI) 功能描述:. |
| S-3-F-4-G S/C SS SPGS | 功能描述:觸點探頭 FLAT TIP PROBE RoHS:否 制造商:IDI 類型:Probes 尖端類型:Spherical Radius 長度:8.26 mm 電流額定值:10 A 彈力:2.3 oz 行程:1.52 mm 系列:101050 |
| S3F5M | 功能描述:XLR 連接器 3P JACK TO 5P PLUG RoHS:否 制造商:Neutrik 標準:Standard XLR 產品類型:Connectors 型式:Female 位置/觸點數量:3 端接類型:Solder 安裝風格:Cable 方向:Vertical |
發布緊急采購，3分鐘左右您將得到回復。