參數資料
型號： RC28F256P33T85A
廠商： NUMONYX
元件分類： PROM
英文描述： 16M X 16 FLASH 3V PROM, 85 ns, PBGA64
封裝： BGA-64
文件頁數： 51/96頁
文件大小： 1378K
代理商： RC28F256P33T85A
November 2007
Datasheet
Order Number: 314749-05
55
Numonyx StrataFlash Embedded Memory (P33)
11.1.0.11 Burst Length
The Burst Length bits (BL[2:0]) selects the linear burst length for all synchronous burst
reads of the flash memory array. The burst lengths are 4-word, 8-word, 16-word, and
continuous word.
Continuous burst accesses are linear only, and do not wrap within any word length
cycle begins, the device outputs synchronous burst data until it reaches the end of the
“burstable” address space.
11.1.0.12 End of Word Line (EOWL) Considerations
When performing synchronous burst reads with BW set (no wrap) and DH reset (1-
clock cycle), an output “delay” requiring additional clock Wait States may occur when
the burst sequence crosses its first device-row (16-word) boundary. The delay would
take place only once, and will not occur if the burst sequence does not cross a device-
row boundary. The WAIT signal informs the system of this delay when it occurs. If the
burst sequence’s start address is 4-word aligned (i.e. 0x00h, 0x04h, 0x08, 0x0Ch) then
no delay occurs. If the start address is at the end of a 4-word boundary (i.e. 0x03h,
0x07h, 0x0Bh, 0x0Fh), the worst case delay (number of Wait States required) will be
one clock cycle less than the first access Latency Count (LC-1) when crossing the first
device-row boundary (i.e. 0x0Fh to 0x10h). Other address misalignments may require
wait states depending upon the LC setting and the starting address alignment. For
example, an LC setting of 3 with a starting address of 0xFD requires 0 wait states, but
the same LC setting of 3 with a starting address of 0xFE would require 1 wait state
when crossing the first device row boundary.
11.2
Read Operations
The device can be in any of four read states: Read Array, Read Identifier, Read Status
or Read Query. Upon power-up, or after a reset, the device defaults to Read Array
mode. To change the read state, the appropriate read command must be written to the
sections describe read-mode operations in detail.
The device supports two read modes: asynchronous page mode and synchronous burst
mode. Asynchronous page mode is the default read mode after device power-up or a
reset. The RCR must be configured to enable synchronous burst reads of the flash
11.2.1
Asynchronous Page-Mode Read
Following a device power-up or reset, asynchronous page mode is the default read
mode and the device is set to Read Array mode. However, to perform array reads after
any other device operation (e.g. write operation), the Read Array command must be
issued in order to read from the flash memory array.
Note:
Asynchronous page-mode reads can only be performed when RCR 15 is set
The Clear Status Register command clears the status register. It functions independent
of VPP. The WSM sets and clears SR[7,6,2], but it sets bits SR[5:3,1] without clearing
them. The Status Register should be cleared before starting a command sequence to
avoid any ambiguity. A device reset also clears the Status Register.
相關PDF資料
PDF描述
RC28F160C3TC90 1M X 16 FLASH 3V PROM, 90 ns, PBGA64
RC28F160C3BD70 1M X 16 FLASH 3V PROM, 70 ns, PBGA64
RC4194K DUAL OUTPUT, ADJUSTABLE MIXED REGULATOR, MBFM9
RM4194K DUAL OUTPUT, ADJUSTABLE MIXED REGULATOR, MBFM9
RC4194D DUAL OUTPUT, ADJUSTABLE MIXED REGULATOR, CDIP14
相關代理商/技術參數
參數描述
RC28F256P33T85B 制造商:Micron Technology Inc 功能描述:256MB, KEARNY EBGA 3.0 - Tape and Reel
RC28F256P33TFA 功能描述:IC FLASH 256MBIT 95NS 64EZBGA RoHS:否 類別:集成電路 (IC) >> 存儲器 系列:Axcell™ 產品變化通告:Product Discontinuation 26/Apr/2010 標準包裝:136 系列:- 格式 - 存儲器:RAM 存儲器類型:SRAM - 同步，DDR II 存儲容量:18M（1M x 18） 速度:200MHz 接口:并聯 電源電壓:1.7 V ~ 1.9 V 工作溫度:0°C ~ 70°C 封裝/外殼:165-TBGA 供應商設備封裝:165-CABGA（13x15） 包裝:托盤 其它名稱:71P71804S200BQ
RC28F256P33TFE 功能描述:IC FLASH 256MBIT 64EZBGA RoHS:否 類別:集成電路 (IC) >> 存儲器 系列:Axcell™ 標準包裝:72 系列:- 格式 - 存儲器:RAM 存儲器類型:SRAM - 同步 存儲容量:4.5M（256K x 18） 速度:133MHz 接口:并聯 電源電壓:3.135 V ~ 3.465 V 工作溫度:0°C ~ 70°C 封裝/外殼:100-LQFP 供應商設備封裝:100-TQFP（14x20） 包裝:托盤
RC28F320C3 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:3 VOLT ADVANCED+ BOOT BLOCK 8-, 16-, 32-MBIT FLASH MEMORY FAMILY
RC28F320C3BA100 功能描述:IC FLASH 32MBIT 100NS 64BGA RoHS:否 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:150 系列:- 格式 - 存儲器:EEPROMs - 串行 存儲器類型:EEPROM 存儲容量:4K (2 x 256 x 8) 速度:400kHz 接口:I²C，2 線串口 電源電壓:2.5 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 封裝/外殼:8-VFDFN 裸露焊盤 供應商設備封裝:8-DFN（2x3） 包裝:管件 產品目錄頁面:1445 (CN2011-ZH PDF)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*