參數資料
型號： PIC12F519
廠商： Microchip Technology Inc.
英文描述： 8-Pin, 8-Bit Flash Microcontroller
中文描述： 8引腳，8位閃存微控制器
文件頁數： 34/88頁
文件大?。?/td> 802K
代理商： PIC12F519
PIC12F519
DS41319A-page 32
Preliminary
2007 Microchip Technology Inc.
7.2
Prescaler
An 8-bit counter is available as a prescaler for the
Timer0 module or as a postscaler for the Watchdog
Timer (WDT), respectively (see
Section 8.6 “Watch-
dog Timer (WDT)”
). For simplicity, this counter is
being referred to as “prescaler” throughout this data
sheet.
The PSA and PS<2:0> bits (OPTION<3:0>) determine
prescaler assignment and prescale ratio.
When assigned to the Timer0 module, all instructions
writing to the TMR0 register (e.g.,
CLRF 1
,
MOVWF 1,
BSF 1
,
x
, etc.) will clear the prescaler. When assigned
to WDT, a
CLRWDT
instruction will clear the prescaler
along with the WDT. The prescaler is neither readable
nor writable. On a Reset, the prescaler contains all ‘
0
’s.
7.2.1
SWITCHING PRESCALER
ASSIGNMENT
The prescaler assignment is fully under software
control (i.e., it can be changed “on-the-fly” during pro-
gram execution). To avoid an unintended device Reset,
the following instruction sequence (Example 7-1) must
be executed when changing the prescaler assignment
from Timer0 to the WDT.
EXAMPLE 7-1:
CHANGING PRESCALER
(TIMER0
→
WDT)
;Clear WDT
;Clear TMR0 and Prescaler
‘00xx1111’b ;These 3 lines (5, 6, 7)
;are required only if
;desired
;PS<2:0> are 000 or 001
‘00xx1xxx’b ;Set Postscaler to
;desired WDT rate
To change the prescaler from the WDT to the Timer0
module, use the sequence shown in Example 7-2. This
sequence must be used even if the WDT is disabled. A
CLRWDT
instruction should be executed before
switching the prescaler.
EXAMPLE 7-2:
CHANGING PRESCALER
(WDT
→
TIMER0)
Note:
The prescaler may be used by either the
Timer0 module or the WDT, but not both.
Thus, a prescaler assignment for the
Timer0 module means that there is no
prescaler for the WDT and vice versa.
CLRWDT
CLRF
MOVLW
OPTION
TMR0
CLRWDT
MOVLW
OPTION
CLRWDT
;Clear WDT and
;prescaler
;Select TMR0, new
;prescale value and
;clock source
MOVLW
‘xxxx0xxx’
OPTION
相關PDF資料
PDF描述
PIC12F609 8-bit PIC㈢ Microcontrollers with High Voltage Support and Fan Control Capabilities
PIC12F615 8-bit PIC㈢ Microcontrollers with High Voltage Support and Fan Control Capabilities
PIC12HV609 8-bit PIC㈢ Microcontrollers with High Voltage Support and Fan Control Capabilities
PIC12HV615 8-Pin Flash-Based, 8-Bit CMOS Microcontrollers
PIC16C505-04 14-Pin, 8-Bit CMOS Microcontroller
相關代理商/技術參數
參數描述
PIC12F519_08 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:8-Pin, 8-Bit Flash Microcontrollers
PIC12F519-E/MC 功能描述:8位微控制器 -MCU 15KB Flash Prgrm 64B 8MHz Intrnl Oscilatr RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC12F519-E/MS 功能描述:8位微控制器 -MCU 15KB Flash Prgrm 64B 8MHz Intrnl Oscilatr RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC12F519-E/P 功能描述:8位微控制器 -MCU 15KB Flash Prgrm 64B 8MHz Intrnl Oscilatr RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC12F519-E/SN 功能描述:8位微控制器 -MCU 15KB Flash Prgrm 64B 8MHz Intrnl Oscilatr RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*