- 您現在的位置：買賣IC網 > PDF目錄361135 > NRF9E5-EVKIT868 (Electronic Theatre Controls, Inc.) 433/868/915MHz RF Transceiver with Embedded 8051 Compatible Microcontroller and 4 Input, 10 Bit ADC PDF資料下載
參數資料
| 型號： | NRF9E5-EVKIT868 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | 433/868/915MHz RF Transceiver with Embedded 8051 Compatible Microcontroller and 4 Input, 10 Bit ADC |
| 中文描述： | 433/868/915MHz RF收發器與8051兼容的嵌入式微控制器和4輸入，10位ADC |
| 文件頁數： | 77/104頁 |
| 文件大小： | 1436K |
| 代理商： | NRF9E5-EVKIT868 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁當前第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁
PRODUCT SPECIFICATION
nRF9E5 Single Chip Transceiver with Embedded Microcontroller and ADC
Main office: Nordic Semiconductor ASA - Vestre Rosten 81, N-7075 Tiller, Norway -Phone +4772898900 - Fax +4772898989
Revision: 1.1
Page 77 of 104
June 2004
18.8.1.4
Mode 3
In mode 3, Timer 0 operates as two 8-bit counters, and Timer 1 stops counting and holds
its value. As shown in Figure 20 Timer 0 – Mode 3, TL0 is configured as an 8-bit
counter controlled by the normal Timer 0 control bits. TL0 can count either CPU clock
cycles (divided by 4 or by 12) or high-to-low transitions on t0, as determined by the C/T
bit. The GATE function can be used to give counter enable control to the INT0_N
signal.
Divide by 12
Divide by 4
CPU_CLK
0
1
0
1
P05/T0
T0M
C/T
TR0
GATE
P0_ALT.3
P03/INT0_N
clk
TF0
INT
0
1
2
3
4
5
6
7
0
1
2
3
4
5
6
7
TL0
TH0
TF1
INT
clk
TR1
Figure 20 Timer 0 – Mode 3.
TH0 functions as an independent 8-bit counter. However, TH0 can count only CPU
clock cycles (divided by 4 or by 12). The Timer 1 control and flag bits (TR1 and TF1)
are used as the control and flag bits for TH0.
When Timer 0 is in mode 3, Timer 1 has limited usage because Timer 0 uses the Timer
1 control bit (TR1) and interrupt flag (TF1). Timer 1 can still be used for baud rate
generation and the Timer 1 count values are still available in the TL1 and TH1
registers.Control of Timer 1 when Timer 0 is in mode 3 is through the Timer 1 mode
bits. To turn Timer 1 on, set Timer 1 to mode 0, 1, or 2. To turn Timer 1 off, set it to
mode 3. The Timer 1 C/T bit and T1M bit are still available to Timer 1. Therefore,
Timer 1 can count CPU_clk/4, CPU_clk/12, or high-to-low transitions on the t1 pin. The
Timer 1 GATE function is also available when Timer 0 is in mode 3.
18.8.2
Timer Rate Control
The default timer clock scheme for the nRF9E5 timers is twelve CPU clock cycles per
increment, the same as in the standard 8051. However, in the nRF9E5, the instruction
cycle is four clock cycles.
Using the default rate (twelve clocks per timer increment) allows existing application
code with real-time dependencies, such as baud rate, to operate properly. However,
applications that require fast timing can set the timers to increment every four clock
cycles by setting bits in the Clock Control register (CKCON) at SFR location 0x8E,
described in Table 67 CKCON Register – SFR 0x.
The CKCON bits that control the timer clock rates are:
CKCON bit Counter/Timer
5
Timer 2
4
Timer 1
3
Timer 0
When a CKCON register bit is set to 1, the associated counter increments at four-clock
intervals. When a CKCON bit is cleared, the associated counter increments at twelve-
clock intervals. The timer controls are independent of each other. The default setting for
相關PDF資料 |
PDF描述 |
|---|---|
| NRF9E5-EVKIT433 | 433/868/915MHz RF Transceiver with Embedded 8051 Compatible Microcontroller and 4 Input, 10 Bit ADC |
| NRF9E5-EVKIT915 | 433/868/915MHz RF Transceiver with Embedded 8051 Compatible Microcontroller and 4 Input, 10 Bit ADC |
| NRF9E5IC | 433/868/915MHz RF Transceiver with Embedded 8051 Compatible Microcontroller and 4 Input, 10 Bit ADC |
| NRN9S104JTS | SINGLE-IN-LINE SIP RESISTOR NETWORKS CONFORMAL COATED LOW PROFILE |
| NRN9xxx | SINGLE-IN-LINE SIP RESISTOR NETWORKS CONFORMAL COATED LOW PROFILE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| nRF9E5-EVKIT-868/915 | 功能描述:射頻開發工具 NRF9E5 EVAL KIT 868/915 RoHS:否 制造商:Taiyo Yuden 產品:Wireless Modules 類型:Wireless Audio 工具用于評估:WYSAAVDX7 頻率: 工作電源電壓:3.4 V to 5.5 V |
| NRF9E5-EVKIT915 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:433/868/915MHz RF Transceiver with Embedded 8051 Compatible Microcontroller and 4 Input, 10 Bit ADC |
| NRF9E5IC | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:433/868/915MHz RF Transceiver with Embedded 8051 Compatible Microcontroller and 4 Input, 10 Bit ADC |
| nRF9E5-REEL | 功能描述:射頻收發器 433/868/915MHz TRNSCVR RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| NRF-D | 制造商:IDEC 功能描述:35mmDINKi[pT[Lbgz_ Bulk 制造商:IDEC CORPORATION 功能描述:DIN RAIL MT.ADAPTOR |
發布緊急采購，3分鐘左右您將得到回復。