參數資料
型號: NCV7361ADR2G
廠商: ON SEMICONDUCTOR
元件分類: Buffer和線驅動
英文描述: Voltage Regulator with Integrated LIN Transceiver; Package: SOIC-8 Narrow Body; No of Pins: 8; Container: Tape and Reel; Qty per Container: 2500
中文描述: LINE TRANSCEIVER, PDSO8
封裝: SOIC-8
文件頁數: 7/27頁
文件大小: 272K
代理商: NCV7361ADR2G
NCV7361A
http://onsemi.com
15
RxD Output
The received BUS signal will be output to the 5.0 V RxD
pin:
BUS < Vthr_cnt – 0.5 * Vthr_hys → RxD = low
BUS > Vthr_cnt + 0.5 * Vthr_hys → RxD = high
This output is a pushpull driver between VOUT and
GND with an output current capability of 1.0 mA.
Figure 20. RxD Output Circuitry
NCV7361A
MCU
RxD
VOUT
Linear Regulator
The NCV7361A has an integrated low dropout linear
regulator with a PChannel MOSFET output driver whose
output is 5.0 V
"2% at v50 mA and 5.5 V v VSUP v
18 V. Figure 21 shows typical current limit based on the
output voltage.
Figure 21. Characteristic of Current Limit
vs. Output Voltage
05
6
3
2
VOUT (V)
IV
OU
T(mA)
120
40
0
14
80
100
20
60
RESET
RESET switches from low to high if VSUP is switched on
and VOUT > VRES for tRes.
If VOUT drops below VRES, the RESET output goes from
high to low after trr. Short transients will be filtered.
The RESET output driver is driven from VOUT to
guarantee proper operation.
Figure 22. Output Current of Reset Output vs.
VOUT Voltage
16
14
12
10
8
6
4
2
0
0.5
1.0
1.5
2.0
3.0
3.5
4.0 4.5
2.5
VOUT (V)
lol_RESET
(mA)
Initialization
The initialization is started if VSUP is switched on. This
is independent of the EN pin.
VSUP Power ON
The NCV7361A starts in the normal mode when VSUP is
applied [>3.15 V (typical)]. The internal circuitry on VOUT
as well as the internal regulator starts the initialization with
poweronreset. The voltage regulator is switched on.
If VOUT > VPOR the businterface will be activated.
If VOUT is higher than VRes, the reset time tRes = 100 ms
is started. After tRes the RESET output switches from low
to high (Figure 22).
The initialization procedure at power on is started
independent from the EN state. The regulator can only be
turned off with a high level followed by a low level on the
EN pin.
Mode Input EN
The NCV7361A is switched into the sleep mode when
EN goes from high to low. The normal mode will be kept
as long as EN = high.
The regulator can be turned off by switching EN high to
low independent of the state of the bustransceiver.
The EN input is internally pulled down to guarantee a
low with no connection. In the high state, the pulldown
current will be switched off to reduce the quiescent current.
The maximum input voltage is VSUP. The threshold is
typical 2.1 V and therefore CMOS levels can be used as
input signals. Figure 23 shows the internal circuitry of the
EN pin.
The EN input is internally pulled down to secure that if
this pin is not connected a low level will be generated. It
will be used two different pull down current sources for
high and low level to minimize the sleep mode current.
相關PDF資料
PDF描述
NCV8503PDW25R2 2.5 V FIXED POSITIVE LDO REGULATOR, PDSO16
NCV8503PDW25 2.5 V FIXED POSITIVE LDO REGULATOR, PDSO16
NCV8503PDW33R2 3.3 V FIXED POSITIVE LDO REGULATOR, PDSO16
NCV8503PDW33 3.3 V FIXED POSITIVE LDO REGULATOR, PDSO16
ND2012L-2-18 160 mA, 200 V, N-CHANNEL, Si, SMALL SIGNAL, MOSFET, TO-226AA
相關代理商/技術參數
參數描述
NCV7380 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:LIN Transceiver
NCV7380/D 制造商:未知廠家 制造商全稱:未知廠家 功能描述:LIN Transceiver
NCV7380_07 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:LIN Transceiver
NCV7380D 功能描述:IC TRANSCEIVER LINEAR 8-SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP(0.300",7.62mm) 供應商設備封裝:16-PDIP 包裝:管件
NCV7380DG 功能描述:IC TRANSCEIVER LINEAR 8-SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP(0.300",7.62mm) 供應商設備封裝:16-PDIP 包裝:管件