參數資料
型號： MT9171AE1
廠商： ZARLINK SEMICONDUCTOR INC
元件分類： 數字傳輸電路
英文描述： Digital Subscriber Interface Circuit Digital Network Interface Circuit
中文描述： DATACOM, DIGITAL SLIC, PDIP22
封裝： LEAD FREE, PLASTIC, DIP-22
文件頁數： 9/28頁
文件大?。?/td> 552K
代理商： MT9171AE1
MT9171/72
Data Sheet
9
Zarlink Semiconductor Inc.
Table 2 - Mode Definitions
Table 3 - Pin Configurations
The overall mode of operation of the DNIC can be programmed to be either a baseband modem (MOD mode) or a
digital network transceiver (DN mode). As a baseband modem, transmit/receive data is passed transparently
through the device at 80 or 160 kbit/s by the DV port. The CD port transfers the C-channel and D-Channel also at
80 or 160 kbit/s.
In DN mode, both the DV and CD ports operate as ST-BUS streams at 2.048 Mbit/s. The DV port transfers data
over pins DSTi and DSTo while on the CD port, the CDSTi and CDSTo pins are used. The SINGL port option only
exists in DN mode.
Mode
Function
SLV
SLAVE
-
The chip timebase is extracted from the received line data and the external 10.24 MHz
crystal is phase locked to it to provide clocks for the entire device and are output for the external
system to synchronize to.
MASTER
-
The timebase is derived from the externally supplied data clocks and 10.24 MHz clock
which must be frequency locked. The transmit data is synchronized to the system timing with the
receive data recovered by a clock extracted from the receive data and resynchronized to the system
timing.
DUAL PORT
-
Both the CD and DV ports are active with the CD port transferring the C&D channels
and the DV port transferring the B1& B2 channels.
SINGLE PORT -
The B1& B2, C and D channels are all transferred through the DV port. The CD
port is disabled and CDSTi should be pulled high.
MODEM
-
Baseband operation at 80 or 160 kbits/s. The line data is received and transmitted
through the DV port at the baud rate selected. The C-channel is transferred through the CD port
also at the baud rate and is synchronized to the CLD output.
DIGITAL NETWORK
-
Intended for use in the digital network with the DV and CD ports operating at
2.048 Mbits/s and the line at 80 or 160 kbits/s configured according to the applicable ISDN
recommendation.
D BEFORE C-CHANNEL
-
The D-channel is transferred before the C-channel following F0.
C BEFORE D-CHANNEL
-
The C-channel is transferred before the D-channel following F0.
OUTPUT DATA ENABLE
-
When mode 7 is selected, the DV and CD ports are put in high
impedance state. This is intended for power-up reset to avoid bus contention and possible damage
to the device during the initial random state in a daisy chain configuration of DNICs. In all the other
modes of operation DV and CD ports are enabled during the appropriate channel times.
MAS
DUAL
SINGL
MOD
DN
D-C
C-D
ODE
Mode
#
F0/CLD
F0o/RCK
C4/TCK
Name
Input/Output
Name
Input/Output
Name
Input/Output
0
1
2
3
4
5
6
7
F0
CLD
F0
F0
F0
CLD
F0
F0
Input
Output
Input
Input
Output
Output
Output
Input
F0o
RCK
F0o
F0o
F0o
RCK
F0o
F0o
Output
Output
Output
Output
Output
Output
Output
Output
C4
TCK
C4
C4
C4
TCK
C4
C4
Input
Output
Input
Input
Output
Output
Output
Input
相關PDF資料
PDF描述
MT9171 ISO2-CMOS ST-BUS FAMILY
MT9171AE ISO2-CMOS ST-BUS FAMILY
MT9171AN ISO2-CMOS ST-BUS FAMILY
MT9171AP ISO2-CMOS ST-BUS FAMILY
MT9171 ISO2-CMOS ST-BUS⑩ FAMILY Digital Subscriber Interface Circuit Digital Network Interface Circuit
相關代理商/技術參數
參數描述
MT9171AN 制造商:Microsemi Corporation 功能描述:
MT9171AN1 制造商:Zarlink Semiconductor Inc 功能描述:PB FREE DNIC 1.5UM - Rail/Tube
MT9171ANR 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Digital Subscriber Interface Circuit Digital Network Interface Circuit
MT9171ANR1 制造商:Microsemi Corporation 功能描述:PB FREE DNIC 1.5MM - Tape and Reel 制造商:Zarlink Semiconductor Inc 功能描述:PB FREE DNIC 1.5MM - Tape and Reel
MT9171AP 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:ISO2-CMOS ST-BUS FAMILY
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*