參數資料
型號： MT90823
廠商： Mitel Networks Corporation
英文描述： 3V Large Digital Switch(3V 大數字開關)
中文描述： 3V的大型數字交換機（3V的大數字開關）
文件頁數： 19/37頁
文件大小： 162K
代理商： MT90823
CMOS
MT90823
19
JTAG Support
The MT90823 JTAG interface conforms to the IEEE
1149.1
Boundary-Scan
Boundary-Scan Test (BST) design-for-testability
technique it specifies. The operation of the
boundary-scan circuitry is controlled by an external
test access port (TAP) Controller.
standard
and
the
Test Access Port (TAP)
The Test Access Port (TAP) provides access to the
many test functions of the MT90823. It consists of
three input pins and one output pin. The following
pins comprise the TAP.
Test Clock Input
(TCK)
TCK provides the clock for the test logic. The
TCK does not interfere with any on-chip clock
and thus remains independent. The TCK
permits shifting of test data into or out of the
Boundary-Scan register cells concurrently with
the operation of the device and without
interfering with the on-chip logic.
Test Mode Select Input
(TMS)
The logic signals received at the TMS input are
interpreted by the TAP Controller to control the
test operations. The TMS signals are sampled
at the rising edge of the TCK pulse. This pin is
internally pulled to Vdd when it is not driven
from an external source.
Test Data Input
(TDI)
Serial input data applied to this port is fed
either into the instruction register or into a test
data register, depending on the sequence
previously applied to the TMS input. Both
registers are described in a subsequent
section. The received input data is sampled at
the rising edge of TCK pulses. This pin is
internally pulled to Vdd when it is not driven
from an external source.
Test Data Output
(TDO)
Depending on the sequence previously applied
to the TMS input, the contents of either the
instruction register or data register are serially
shifted out towards the TDO. The data out of
the TDO is clocked on the falling edge of the
TCK pulses. When no data is shifted through
the boundary scan cells, the TDO driver is set
to a high impedance state.
Test Reset
(TRST)
Resets the JTAG scan structure. This pin is
internally pulled to VDD.
Instruction Register
In accordance with the IEEE 1149.1 standard, the
MT90823 uses public instructions. The MT90823
JTAG Interface contains a two-bit instruction register.
Instructions are serially loaded into the instruction
register from the TDI when the TAP Controller is in
its shifted-IR state. Subsequently, the instructions
are decoded to achieve two basic functions: to select
the test data register that may operate while the
instruction is current, and to define the serial test
data register path, which is used to shift data
between TDI and DO during data register scanning.
Test Data Register
As specified in IEEE 1149.1, the MT90823 JTAG
Interface contains three test data registers:
The Boundary-Scan Register
The Boundary-Scan register consists of a
series of Boundary-Scan cells arranged to form
a scan path around the boundary of the
MT90823 core logic.
The Bypass Register
The Bypass register is a single stage shift
register that provides a one-bit path from TDI to
its TDO.
The Device Identification Register
The device identification register is a 32-bit
register with the register contain of:
The LSB bit in the device identification register is
the first bit clocked out.
The MT90823 boundary scan register contains 118
bits. Bit 0 in Table 15 Boundary Scan Register is the
first bit clocked out. All tristate enable bits are active
high.
MSB
LSB
0000 0000 1000 0010 0011 0001 0100 1011
相關PDF資料
PDF描述
MT90826 Quad Digital Switch(四數字開關)
MT90840 Distributed Hyperchannel Switch(分布式超級通道開關)
MT90863AL1 3V Rate Conversion Digital Switch
MT90863 3V Rate Conversion Digital Switch(3V 速率轉換數字開關)
MT9125 Dual ADPCM Transcoder(雙ADPCM編解碼器)
相關代理商/技術參數
參數描述
MT90823AB 制造商:Microsemi Corporation 功能描述:SWIT FABRIC 2K X 2K/1K X 1K/512 X 512 3.3V 100LQFP - Trays 制造商:Microsemi Corporation 功能描述:3V LARGE DIGITAL SWITCH
MT90823AB1 制造商:Microsemi Corporation 功能描述:SWIT FABRIC 2K X 2K/1K X 1K/512 X 512 3.3V 100LQFP - Trays 制造商:Microsemi Corporation 功能描述:3V LARGE DIGITAL SWITCH 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC DGTL SWITCH 2048X2048 100LQFP 制造商:Microsemi Corporation 功能描述:IC DGTL SWITCH 2048X2048 100LQFP
MT90823AG 制造商:Microsemi Corporation 功能描述:SWIT FABRIC 2K X 2K/1K X 1K/512 X 512 3.3V 120BGA - Trays
MT90823AG2 制造商:Microsemi Corporation 功能描述:SWIT FABRIC 2K X 2K/1K X 1K/512 X 512 3.3V 120BGA - Trays
MT90823AL 制造商:Microsemi Corporation 功能描述:SWIT FABRIC 2K X 2K/1K X 1K/512 X 512 3.3V 100MQFP - Trays
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*