參數資料
型號: MT312
廠商: ZARLINK SEMICONDUCTOR INC
元件分類: 消費家電
英文描述: Satellite Channel Decoder
中文描述: SPECIALTY CONSUMER CIRCUIT, PQFP80
封裝: MQFP-80
文件頁數: 15/90頁
文件大?。?/td> 318K
代理商: MT312
Functional Overview
MT312
15
Figure 11 - DVB Energy dispersal conceptual diagram
1
1
0
2
0
3
1
4
0
5
1
6
0
7
1
8
0
9
0
10
0
11
0
12
0
13
0
14
0
15
Initialisation sequence
XOR
1.4.6 Output Stage
Transport stream can be output in a byte-parallel or
bit-serial mode. The output interface consists of an
8-bit output, output clock, a packet validation level, a
packet start pulse and a block error indicator.
The output clock rate depends on the Symbol rate,
QPSK/BPSK choice, convolutional (Viterbi) coding
rate, DVB/DSS choice and byte-parallel or bit-serial
output mode. This rate is computed by MT312 to be
very close to the minimum required to output packet
data without packet overlap. Furthermore, the
packets at the output of MT312 are as evenly spaced
as possible to minimise packet position movement in
the transport layer. The maximum movement in the
packet synchronisation byte position is limited to ±
one output clock period.
An external MPEG clock can be input to synchronise
the MPEG data output to MPEG decoders.
1.5 Control
Automatic Symbol Rate Search, Code Rate Search,
Signal Acquisition and Signal Tracking algorithms are
built into the MT312 using a sophisticated on-chip
controller. The software interaction with the device is
via a simple Command Driven Control (CDC)
interface. This CDC maps high level inputs such as
symbol rates in MBaud and frequencies in MHz, to
low level on-chip register settings. The on-chip
control state machine and the CDC signi
fi
cantly
reduces the software overhead as well as the
channel search times. There is also an option for the
host processor to by-pass both the CDC as well as
the on-chip controller and take direct control of the
QPSK demodulator.
Once the MT312 has locked up, any frequency offset
can be read from the LNB FREQ error registers 7
and 8. The frequency synthesiser under the software
control can be re-tuned in frequency to optimise the
received signal within the SAW bandwidth. Note that
MT312 compensates for any frequency offsets
before QPSK demodulation. Hence a frequency
offset will not necessarily lead to a performance loss.
Performance loss will occur only if a signi
fi
cant part
of the signal is cut off by the SAW or base-band
fi
lter,
due to this frequency offset. This will happen only if
the symbol rate is close to maximum supported by
that
fi
lter. In such an event it is recommended that
front-end be re-tuned to neutralise this error before
the SAW
fi
lter. It is then necessary for the MT312 to
re-acquire the signal.
The MT312 can generate control signals to enable
full control of the dish and LNB. The chip implements
the signals needed for the full DiSEqC
v2.2
speci
fi
cation. This includes high/low band selection,
polarisation and dish position.
In this mode, the Symbol rate in MBaud and Viterbi
code rate are the only values needed to start the
MT312 searching for the signal. The CDC module
maps the high level parameters into the various low
level register settings needed to acquire and track
the signal. The low level registers may be read and
directly modi
fi
ed to suit very speci
fi
c requirements.
However, this is not recommended.
相關PDF資料
PDF描述
MT312T-Y 2x4mm Rectangular LED Lamps
MT3371BN Wide Dynamic Range DTMF Receiver
MT3371BS Wide Dynamic Range DTMF Receiver
MT3371BNR Wide Dynamic Range DTMF Receiver
MT3371BSR1 Wide Dynamic Range DTMF Receiver
相關代理商/技術參數
參數描述
MT3-1203SI 制造商:VOLGEN 制造商全稱:VOLGEN 功能描述:3 WATT DC/DC CONVERTER, SIINGLE & MULTIIPLE OUTPUTS
MT3-1205SI 制造商:VOLGEN 制造商全稱:VOLGEN 功能描述:3 WATT DC/DC CONVERTER, SIINGLE & MULTIIPLE OUTPUTS
MT3-1212SI 制造商:VOLGEN 制造商全稱:VOLGEN 功能描述:3 WATT DC/DC CONVERTER, SIINGLE & MULTIIPLE OUTPUTS
MT3-1212WI 制造商:VOLGEN 制造商全稱:VOLGEN 功能描述:3 WATT DC/DC CONVERTER, SIINGLE & MULTIIPLE OUTPUTS
MT3-1215WI 制造商:VOLGEN 制造商全稱:VOLGEN 功能描述:3 WATT DC/DC CONVERTER, SIINGLE & MULTIIPLE OUTPUTS