- 您現在的位置：買賣IC網 > PDF目錄22057 > MSC7118VM1200 (Freescale Semiconductor)DSP 16BIT W/DDR CTRLR 400-MAPBGA PDF資料下載
參數資料
| 型號： | MSC7118VM1200 |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 51/60頁 |
| 文件大小： | 0K |
| 描述： | DSP 16BIT W/DDR CTRLR 400-MAPBGA |
| 標準包裝： | 90 |
| 系列： | StarCore |
| 類型： | 定點 |
| 接口： | 主機接口，I²C，UART |
| 時鐘速率： | 300MHz |
| 非易失內存： | ROM（8 kB） |
| 芯片上RAM： | 464kB |
| 電壓 - 輸入/輸出： | 3.30V |
| 電壓 - 核心： | 1.20V |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 400-LFBGA |
| 供應商設備封裝： | 400-MAPBGA（17x17） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁當前第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
Ordering Information
MSC7118 Low-Cost 16-bit DSP with DDR Controller Data Sheet, Rev. 7
Freescale Semiconductor
55
3.6
Connectivity Guidelines
This section summarizes the connections and special conditions, such as pull-up or pull-down resistors, for the MSC7118
device. Following are guidelines for signal groups and configuration settings:
Clock and reset signals.
— SWTE is used to configure the MSC7118 device and is sampled on the deassertion of PORESET, so it should be
tied to VDDC or GND either directly or through pull-up or pull-down resistors until PORESET is deasserted. After
PORESET
, this signal can be left floating.
— BM[0–1] configure the MSC7118 device and are sampled until PORESET is deasserted, so they should be tied to
VDDIO or GND either directly or through pull-up or pull-down resistors.
— HRESET should be pulled up.
Interrupt signals. When used, IRQ pins must be pulled up.
HDI16 signals.
— When they are configured for open-drain, the HREQ/HREQ or HTRQ/HTRQ signals require a pull-up resistor.
However, these pins are also sampled at power-on reset to determine the HDI16 boot mode and may need to be
pulled down. When these pins must be pulled down on reset and pulled up otherwise, a buffer can be used with
the HRESET signal as the enable.
— When the device boots through the HDI16, the HDDS, HDSP and H8BIT pins should be pulled up or down,
depending on the required boot mode settings.
I2C signals. The SCL and SDA signals, when programmed for I2C, requires an external pull-up resistor.
General-purpose I/O (GPIO) signals. An unused GPIO pin can be disconnected. After boot, program it as an output
pin.
Other signals.
—The TEST0 pin must be connected to ground.
—The TPSEL pin should be pulled up to enable debug access via the EOnCE port and pulled down for boundary
scan.
— Pins labelled NO CONNECT (NC) must not be connected.
— When a 16-pin double data rate (DDR) interface is used, the 16 unused data pins should be no connects (floating)
if the used lines are terminated.
— Do not connect DBREQ to DONE (as you would for the MSC8101 device). Connect DONE to one of the EVNT
pins, and DBREQ to HRRQ.
4
Ordering Information
Consult a Freescale Semiconductor sales office or authorized distributor to determine product availability and place an order.
Part
Supply Voltage
Package Type
Pin
Count
Core
Frequency
(MHz)
Solder Spheres
Order Number
MSC7118
1.2 V core
2.5 V memory
3.3 V I/O
Molded Array Process-Ball Grid
Array (MAP-BGA)
400
300
Lead-free
MSC7118VM1200
Lead-bearing
MSC7118VF1200
相關PDF資料 |
PDF描述 |
|---|---|
| MSC7118VF1200 | DSP 16BIT W/DDR CTRLR 400-MAPBGA |
| VI-24V-EU | CONVERTER MOD DC/DC 5.8V 200W |
| MIC384-0BM TR | IC SUPERVSR THERM LOC/REM 8SOIC |
| VI-213-EU | CONVERTER MOD DC/DC 24V 200W |
| TCJW686M006R0070 | CAP TANT 68UF 6.3V 20% 2312 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MSC7119 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Low-Cost 16-bit DSP with DDR Controller and 10/100 Mbps Ethernet MAC |
| MSC7119_08 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Low-Cost 16-bit DSP with DDR Controller and 10/100 Mbps Ethernet MAC |
| MSC7119VF1200 | 功能描述:數字信號處理器和控制器 - DSP, DSC FASTSTAR DSP RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| MSC7119VM1200 | 功能描述:數字信號處理器和控制器 - DSP, DSC FASTSTAR DSP RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| MSC711XADS | 功能描述:開發板和工具包 - 其他處理器 DEV SYS FOR FSL 711X DEV RoHS:否 制造商:Freescale Semiconductor 產品:Development Systems 工具用于評估:P3041 核心:e500mc 接口類型:I2C, SPI, USB 工作電源電壓: |
發布緊急采購，3分鐘左右您將得到回復。