
NXP Semiconductors
MPT612
Maximum power point tracking IC
MPT612
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2010. All rights reserved.
Product data sheet
Rev. 2 — 14 September 2010
19 of 19
port to be used for sending and receiving data without affecting the normal program flow.
The debug communication channel data and control registers are mapped in to
addresses in the EmbeddedICE logic. The JTAG clock (TCK) must be slower than
1
/
6
of
the CPU clock (CCLK) to enable the JTAG interface to operate.
7.17.11 RealMonitor
RealMonitor is a configurable software module, developed by ARM Inc. which enables
real time debugging. It is a lightweight debug monitor that runs in the background while
users debug the foreground application. It communicates with the host using DCC which
is present in the EmbeddedICE logic. The MPT612 contain a specific configuration of
RealMonitor software programmed into the on-chip boot ROM memory.
8. Limiting values
Table 3. Limiting values
In accordance with the Absolute Maximum Rating System (IEC 60134).
[1]
Symbol
Parameter
V
DDC
core supply voltage
V
DD(IO)
input/output supply voltage
V
DD(ADC)
ADC supply voltage
V
DD(RTC)
RTC supply voltage
V
IA
analog input voltage
V
I
input voltage
Conditions
typical: 1.8 V
Min
Max
+2.5
Unit
V
[1]b)
0.5
typical: 3.3 V
[2]
0.5
0.5
0.5
+4.6
V
pad supply: 3.3 V
+4.6
V
+4.6
V
[3]
0.5
+5.1
V
5 V tolerant I/O pins
[4][5]
0.5
+6.0
V
DD(IO)
+ 0.5
[6]
100
[8]
100
[8]
V
other I/O pins
[4][5]
0.5
V
I
DD
I
SS
T
stg
P
tot(pack)
supply current
[7]
-
mA
ground current
[9]
-
mA
°
C
storage temperature
[10]
65
+150
total power dissipation (per
package)
based on package heat
transfer, not device power
consumption
-
1.5
W
V
ESD
electrostatic discharge voltage
Human Body Model (HBM)
[[11]
4000
+4000
V
Machine Model (MM)
[12]
200
+200
V
Charged Device Model (CDM)
[13]
800
+800
V
[1] The following applies to the limiting values:
a) This product includes circuitry specifically designed for the protection of its internal devices from the damaging effects of excessive
static charge. Nonetheless, it is suggested that conventional precautions be taken to avoid applying greater than the rated
maximum. Parameters are valid over operating temperature range unless otherwise specified. All voltages are with respect to GND
unless otherwise noted.
b) Core and internal rail
[2] External rail
[3] On ADC related pins
[4] Including voltage on outputs in 3-state mode
[5] Only valid when the V
DD(IO)
supply voltage is present
[6] Not to exceed 4.6 V
[7] Per supply pin
[8] The peak current is limited to 25 times the corresponding maximum current
[9] Per ground pin
[10] Dependent on package type