- 您現在的位置：買賣IC網 > PDF目錄2011 > MAX5858AECM+D (Maxim Integrated Products)IC DAC 10BIT DUAL 300MSPS 48TQFP PDF資料下載
參數資料
| 型號： | MAX5858AECM+D |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 13/25頁 |
| 文件大小： | 0K |
| 描述： | IC DAC 10BIT DUAL 300MSPS 48TQFP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 250 |
| 設置時間： | 11ns |
| 位數： | 10 |
| 數據接口： | 并聯 |
| 轉換器數目： | 2 |
| 電壓電源： | 單電源 |
| 功率耗散（最大）： | 816mW |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-TQFP 裸露焊盤 |
| 供應商設備封裝： | 48-TQFP 裸露焊盤（7x7） |
| 包裝： | 托盤 |
| 輸出數目和類型： | 2 電流，單極 |
| 采樣率（每秒）： | 300M |
MAX5858A
Dual, 10-Bit, 300Msps, DAC with 4x/2x/1x
Interpolation Filters and PLL
20
______________________________________________________________________________________
CLKXN
1
CLKXP
1
CLK
2
tCXD
tCWH
tCWS
DA0–DA9/
CONTROL WORD
DB0–DB9
DAN
DAN+1
DBN
DBN+1
CONTROL WORD
tDCSR
tDCHR
1. CLKXP AND CLKXN MUST BE PRESENT WHEN PLL IS DISABLED, WITH PLLEN CONNECTED TO GND. THE DIAGRAM SHOWS 4x INTERPOLATION.
2. CLK IS AN OUTPUT WHEN PLL IS DISABLED WITH PLLEN CONNECTED TO GND, OTHERWISE, IT IS AN INPUT.
CW
Figure 6. Timing Diagram for Noninterleave Data Mode (IDE = Low)
Figure 6 depicts the write cycle of the MAX5858A in 4x
interpolation mode. With the interpolation feature
enabled, the device can operate with the PLL enabled
or disabled.
With the PLL disabled (PLLEN = 0), the clock signal is
applied to CLKXP/CLKXN and internally divided by 4 to
generate the DAC’s CLK signal. The CLK signal is a
divide-by-four output used to synchronize data into the
MAX5858A data ports. The CLKXP/CLKXN signal dri-
ves the interpolation filters and DAC cores at the
desired conversion rate.
If the PLL is enabled (PLLEN = 1), CLK becomes an
input and the clock signal is applied to CLK. In Figure
6, the CLK signal is multiplied by a factor of four by the
PLL and distributed to the interpolation filters and DAC
cores. In this mode, CLKXP must be pulled low and
CLKXN pulled high.
The MAX5858A can operate with a single-ended clock
input used as both data clock and conversion clock. To
operate the device in this mode, disable the interpolation
filters and enable the PLL (PLLEN = 1). Apply a single-
ended clock input at CLK. The CLK signal acts as the
data synchronization clock and DAC core conversion
clock. Though the PLL is enabled, the lock pin (LOCK) is
not valid and the PLL is internally disconnected from
interpolating filters and DAC cores. In this mode, CLKXP
must be pulled low and CLKXN pulled high.
Figure 6 shows the timing for the control word write
pulse (CW). An 8-bit control word routed through chan-
nel A’s data port programs the gain matching, interpo-
lator configuration, and operational mode of the
MAX5858A. The control word is latched on the falling
edge of CW. The CW signal is asynchronous with con-
version clocks CLK and CLKXN/CLKXP; therefore, the
conversion clock (CLK or CLKXN/CLKXP) can run unin-
terrupted when a control word is written to the device.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX5858ECM+D | IC DAC 10BIT DUAL 300MSPS 48TQFP |
| MAX5863ETM+T | IC AFE 8/10BIT 7.5MSPS 48-TQFN |
| MAX5864ETM+T | IC ANLG FRONT END 22MSPS 48-TQFN |
| MAX5865ETM+T | IC ANLG FRONT END 40MSPS 48-TQFN |
| MAX5866ETM+ | IC ANLG FRONT END 60MSPS 48-TQFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX5858AECM-TD | 功能描述:數模轉換器- DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5858AEVKIT | 制造商:Maxim Integrated Products 功能描述:DUAL-10-BIT, 300MSPS, CURRENT-OUTPUT DAC WITH - Bulk |
| MAX5858ECM | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX5858ECM+D | 功能描述:數模轉換器- DAC 10-Bit 2Ch 300Msps DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5858ECM+TD | 功能描述:數模轉換器- DAC 10-Bit 2Ch 300Msps DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。