參數資料
型號： MAX108CHC
廠商： MAXIM INTEGRATED PRODUCTS INC
元件分類： ADC
英文描述： 【5V, 1.5Gsps, 8-Bit ADC with On-Chip 2.2GHz Track/Hold Amplifier
中文描述： 1-CH 8-BIT FLASH METHOD ADC, PARALLEL ACCESS, PBGA192
封裝： 25 X 25 MM, ESBGA-192
文件頁數： 13/32頁
文件大小： 428K
代理商： MAX108CHC
Principle of Operation
The MAX108’s flash or parallel architecture provides
the fastest multibit conversion of all common integrated
ADC designs. The key to this high-speed flash archi-
tecture is the use of an innovative, high-performance
comparator design. The flash converter and down-
stream logic translate the comparator outputs into a
parallel 8-bit output code and pass this binary code on
to the optional 8:16 demultiplexer, where primary and
auxiliary ports output PECL-compatible data at up to
750Msps per port (depending on how the demultiplex-
er section is set on the MAX108).
The ideal transfer function appears in Figure 2.
On-Chip Track/Hold Amplifier
As with all ADCs, if the input waveform is changing
rapidly during conversion, ENOB and signal-to-noise
ratio (SNR) specifications will degrade. The MAX108’s
on-chip, wide-bandwidth (2.2GHz) T/H amplifier
reduces this effect and increases the ENOB perfor-
mance significantly, allowing precise capture of fast
analog data at high conversion rates.
The T/H amplifier buffers the input signal and allows a
full-scale signal input range of ±250mV. The T/H ampli-
fier’s differential 50
input termination simplifies inter-
facing to the MAX108 with controlled impedance lines.
Figure 3 shows a simplified diagram of the T/H amplifier
stage internal to the MAX108.
Aperture width, delay, and jitter (or uncertainty) are
parameters that affect the dynamic performance of
high-speed converters. Aperture jitter, in particular,
directly influences SNR and limits the maximum slew
rate (dV/dt) that can be digitized without contributing
significant errors. The MAX108’s innovative T/H amplifier
design limits aperture jitter typically to less than 0.5ps.
Aperture Width
Aperture width (t
AW
) is the time the T/H circuit requires
(Figure 4) to disconnect the hold capacitor from the
input circuit (for instance, to turn off the sampling
bridge and put the T/H unit in hold mode).
Aperture Jitter
Aperture jitter (t
AJ
) is the sample-to-sample variation
(Figure 4) in the time between the samples.
Aperture Delay
Aperture delay (t
AD
) is the time defined between the
rising edge of the sampling clock and the instant when
an actual sample is taken (Figure 4).
Internal Reference
The MAX108 features an on-chip +2.5V precision
bandgap reference that can be used by connecting
M
±5V, 1.5Gsps, 8-Bit ADC with
On-Chip 2.2GHz Track/Hold Amplifier
______________________________________________________________________________________
13
(
0
+
(
255
255
254
129
128
127
126
3
2
1
0
ANALOG INPUT
OVERRANGE +
D
Figure 2. Transfer Function
TO
COMPARATORS
TO
COMPARATORS
BUFFER
AMPLIFIER
INPUT
AMPLIFIER
CLOCK
SPLITTER
ALL INPUTS ARE ESD PROTECTED
(NOT SHOWN IN THIS
SIMPLIFIED DRAWING).
SAMPLING
BRIDGE
GNDI
50
50
VIN+
VIN-
GNDI
C
HOLD
50
50
CLK+
CLK-
CLKCOM
Figure 3. Internal Structure of the 2.2GHz T/H Amplifier
HOLD
CLK
ANALOG
INPUT
SAMPLED
DATA (T/H)
T/H
t
AW
t
AD
t
AJ
TRACK
TRACK
APERTURE DELAY (t
AD
)
APERTURE WIDTH (t
AW
)
APERTURE JITTER (t
AJ
)
CLK
Figure 4. T/H Aperture Timing
相關PDF資料
PDF描述
MAX108 【5V, 1.5Gsps, 8-Bit ADC with On-Chip 2.2GHz Track/Hold Amplifier
MAX1090BEEI 400ksps, +5V, 8-/4-Channel, 10-Bit ADCs with +2.5V Reference and Parallel Interface
MAX1090AEEI 400ksps, +5V, 8-/4-Channel, 10-Bit ADCs with +2.5V Reference and Parallel Interface
MAX1090ACEI RB Series - Econoline Unregulated DC-DC Converters; Input Voltage (Vdc): 15V; Output Voltage (Vdc): 09V; Power: 1W; Low Cost 1W Converter; Power Sharing on Dual Output Version; Industry Standard Pinout; 1kVDC & 2kVDC Isolation Options; Optional Continuous Short Circuit Protected; UL94V-0 Package Material; Efficiency to 85%
MAX1090 400ksps, +5V, 8-/4-Channel, 10-Bit ADCs with +2.5V Reference and Parallel Interface
相關代理商/技術參數
參數描述
MAX108CHC-D 制造商:Maxim Integrated Products 功能描述:ADC SGL FLASH 1.5GSPS 8BIT PARALLEL 192PIN ESBGA - Bulk
MAX108CHC-TD 制造商:Maxim Integrated Products 功能描述:ADC SGL FLASH 1.5GSPS 8BIT PARALLEL 192PIN ESBGA - Tape and Reel
MAX108EVKIT 制造商:Maxim Integrated Products 功能描述:+-5V, 1.5GSPS, 8-BIT ADC WITH ON-CHIP 2.2 GHZ - Bulk
MAX109 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:8-Bit, 2.2Gsps ADC with Track/Hold Amplifier and 1:4 Demultiplexed LVDS Outputs
MAX1090 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:400ksps, +5V, 8-/4-Channel, 10-Bit ADCs with +2.5V Reference and Parallel Interface
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*