- 您現在的位置：買賣IC網 > PDF目錄383308 > MAX101CFR (MAXIM INTEGRATED PRODUCTS INC) 500Msps, 8-Bit ADC with Track/Hold PDF資料下載
參數資料
| 型號： | MAX101CFR |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | ADC |
| 英文描述： | 500Msps, 8-Bit ADC with Track/Hold |
| 中文描述： | DUAL 1-CH 8-BIT FLASH METHOD ADC, PARALLEL ACCESS, PQFP84 |
| 封裝： | HEAT SINK, CERAMIC, FP-84 |
| 文件頁數： | 8/16頁 |
| 文件大?。?/td> | 116K |
| 代理商： | MAX101CFR |
M
500Msps, 8-Bit ADC with Trac k/Hold
8
_______________________________________________________________________________________
72, 73
AIN+
75, 76
AIN-
Analog Inputs, internally terminated with 50
to ground. Full-scale linear input range is approximately
±250mV. Drive AIN+ and AIN- differentially for best high-frequency performance.
52
TP1
Internal connection, leave pin open.
53
TP2
Internal connection, leave pin open.
54
VA
RBS
“A” side negative reference voltage sense (Note 9)
55
VA
RB
“A” side negative reference voltage input (Note 9)
65
TP5
Internal connection, leave pin open.
50
VA
RT
“A” side positive reference voltage input (Note 9)
51
VA
RTS
“A” side positive reference voltage sense (Note 9)
NAME
FUNCTION
PIN
_________________________________________________Pin Desc ription (c ontinued)
83
PH
ADJ
Phase adjustment for T/H. Normally connected to ground. A phase adjustment of approximately ±18ps
can be made by varying this pin’s bias point to optimize interleaving between sides A and B (Note 10).
66
TP6
Internal connection, leave pin open.
Note 9:
VA
RT
, VA
RB
, VB
RT
, and VB
RB
should be adjusted separately from a well bypassed reference circuit to ensure proper
amplitude and offset matching. The sense connections to each of these terminals allows precision setting of the reference
voltage. The reference ladder is similar for both converter halves (check electrical section for values). Any noise on these
terminals will severely reduce overall performance.
Note 10:
Good results are obtained by connecting the PH
ADJ
input to ground. Improve performance by applying a voltage between
±1.25V to this input. The time that the “A” T/H bridge samples relative to the time that the “B” T/H bridge samples can be
varied through a ±18ps range.
CLK
ADATA
BDATA
CLK
DCLK
DCLK
t
PD1
t
PD2
t
PD2
t
PWH
t
PWL
Figure 1. Output Timing, Normal Mode (DIV10 = OPEN)
相關PDF資料 |
PDF描述 |
|---|---|
| MAX101A | 500Msps, 8-Bit ADC with Track/Hold |
| MAX1026ACEE-T | 10-Bit 300ksps ADCs with FIFO, Temp Sensor, Internal Reference |
| MAX1026AEEE-T | 10-Bit 300ksps ADCs with FIFO, Temp Sensor, Internal Reference |
| MAX1028 | 10-Bit 300ksps ADCs with FIFO, Temp Sensor, Internal Reference |
| MAX1030 | 10-Bit 300ksps ADCs with FIFO, Temp Sensor, Internal Reference |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX1020 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:10-Bit, Multichannel ADCs/DACs with FIFO, Temperature Sensing, and GPIO Ports |
| MAX1020_12 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:10-Bit, Multichannel ADCs/DACs with FIFO, Temperature Sensing, and GPIO Ports |
| MAX1020BETX | 功能描述:ADC / DAC多通道 RoHS:否 制造商:Texas Instruments 轉換速率: 分辨率:8 bit 接口類型:SPI 電壓參考: 電源電壓-最大:3.6 V 電源電壓-最小:2 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-40 |
| MAX1020BETX+ | 功能描述:ADC / DAC多通道 10Bit AD/DACs w/FIFO Temp Sns/GPIO Ports RoHS:否 制造商:Texas Instruments 轉換速率: 分辨率:8 bit 接口類型:SPI 電壓參考: 電源電壓-最大:3.6 V 電源電壓-最小:2 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-40 |
| MAX1020BETX+T | 功能描述:ADC / DAC多通道 10Bit AD/DACs w/FIFO Temp Sns/GPIO Ports RoHS:否 制造商:Texas Instruments 轉換速率: 分辨率:8 bit 接口類型:SPI 電壓參考: 電源電壓-最大:3.6 V 電源電壓-最小:2 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-40 |
發布緊急采購，3分鐘左右您將得到回復。