參數資料
型號: M37517F8HP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, FLASH, 4 MHz, MICROCONTROLLER, PQFP48
封裝: 7 X 7 MM, 0.50 MM PITCH, PLASTIC, LQFP-48
文件頁數: 50/98頁
文件大?。?/td> 886K
代理商: M37517F8HP
Rev.1.01
Aug 02, 2004
page 54 of 96
7517 Group
MISRG2(003716)
Analog in addtional bit
bit0 ADCON
(003416)
bit2 bit1 bit0
0
XXX
P35/AN5 - P30/AN0
1
000
P04/AN8
1
001
P05/AN9
1
010
P06/AN10
1
011
P07/AN11
1
X
Not available
b7
b0
32kHz RC oscillation calibration enable bit (Note 4)
0:Disabled
1:Enabled
High-speed on-chip oscillation stop bit (Note 4)
0:Oscillating
1:Stopping
Xin swith disable bit (Notes 3, 4)
0:Enable swith to XIN
1:Disable swith to XIN
32kHz RC oscillation enable bit (Note 4)
0:XCIN-XCOUT oscillation
1:32kHz RC oscillation
Low-speed mode serial I/O2 clock source select bit
0:XCIN
1:Built-in oscillator for SI/O2
Not used (returnn"0" when read)
Reserved (do not write "1")
Notes 3: When this bit is set to "1", it cannot be rewritten to "0" by program.
4: This bit is protected.
MISRG(003816)
Oscillation stabilizing time set after STP instruction
released bit
0: Automatically set “0116” to Timer 1, “FF16” to Prescaler
12
1: Automatically set nothing
Middle-speed mode automatic switch set bit
0: Disabled
1: Automatic switch enabled (Notes 1, 2)
Middle-speed mode automatic switch wait time set bit
0: 4.5 to 5.5 cycles
1: 6.5 to 7.5 cycles
Middle-speed mode automatic switch start bit
(depends on software)
0: Invalid
1: Automatic switch start (Note 2)
Not used (return “0” when read)
b7
b0
Notes 1: The microcomputer can be switched to the middle-speed mode automatically by the
SCL/SDA interrupt during operation in the low-speed mode.
2: When switching from the low-speed mode to the middle-speed mode, the value of the
CPU mode register also changes.
Fig.61 Structure of MISRG1, MISRG2
Fig.62 32kHz oscillation control register
sNotes on middle-speed mode switch set bit
When the middle-speed mode automatic switch set bit is set to “1”
during operation in the low-speed mode, XIN oscillation starts au-
tomatically by detecting the rising edge or the falling edge of the
SCL pin or the SDA pin and the microcomputer switch to the
middle-speed mode. Select the timing which switch from the low-
speed mode to the middle-speed mode by the middle-speed mode
automatic switch wait time set bit. The timing which changes from
the low-speed mode by the middle-speed mode automatic switch
wait time set bit. Select according to the oscillation start character-
istic of the oscillator of XIN to be used. By writing “1” in the
middle-speed mode automatic switch start bit during operation in
the low-speed mode, XIN oscillation starts automatically and the
microcomputer changes to the middle-speed mode.
b7 b6
b5
b4
b3
b2 b1
b7
b0
b8
b0
32kHz oscillation control register 0 (003216)
32kHz oscillation control register 1 (003316)
相關PDF資料
PDF描述
M37524E4-XXXSP 8-BIT, OTPROM, 4 MHz, MICROCONTROLLER, PDIP64
M37531E4V-XXXGP 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PQFP32
M37531M4T-XXXSP 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDIP32
M37531M4V-XXXGP 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP32
M37531E8FP 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PDSO36
相關代理商/技術參數
參數描述
M37530T-PTC 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:Converter for Connecting 42-pin 1.778mm-pitch SDIP to a 40-pin Narrow-pitch Connector (for 7531, 7540, 7542 and 7544 Groups)
M37530T-PTCB 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:Converter for Connecting 40-pin Narrow-pitch Connector to 32-pin 0.8mm-pitch LQFP (for 7531, 7532, 7534, 7540, 7542 and 7544 Groups)
M37530T-PTCC 功能描述:DEV 42-PIN RSS/MCU TO 32-PIN 1.7 RoHS:否 類別:編程器,開發系統 >> 配件 系列:- 標準包裝:1 系列:- 附件類型:適配器板 適用于相關產品:RCB230,RCB231,RCB212 配用:26790D-ND - RCB BREAKOUT BOARD RS232 CABLE
M37531E4FP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37531E4FP#U0 制造商:Renesas Electronics Corporation 功能描述:MITSUBISHI 8 BIT OTP MCU