參數資料
型號: LT1160
廠商: Linear Technology Corporation
英文描述: Half-/Full-Bridge N-Channel Power MOSFET Drivers(半橋,N-溝道功率MOS場效應管驅動器)
中文描述: Half-/Full-Bridge N溝道功率MOSFET驅動器(半橋的N溝道功率馬鞍山場效應管驅動器)
文件頁數: 9/16頁
文件大?。?/td> 287K
代理商: LT1160
9
LT1160/LT1162
Power MOSFET Selection
Since the LT1160 (or 1/2 LT1162) inherently protects the
top and bottom MOSFETs from simultaneous conduction,
there are no size or matching constraints. Therefore selec-
tion can be made based on the operating voltage and
R
DS(ON)
requirements. The MOSFET BV
DSS
should be
greater than the HV and should be increased to approxi-
mately (2)(HV) in harsh environments with frequent fault
conditions. For the LT1160 maximum operating HV supply
of 60V, the MOSFET BV
DSS
should be from 60V to 100V.
The MOSFET R
DS(ON)
is specified at T
J
= 25
°
C and is
generally chosen based on the operating efficiency re-
quired as long as the maximum MOSFET junction tem-
perature is not exceeded. The dissipation while each
MOSFET is on is given by:
P = D(I
DS
)
2
(1+
)R
DS(ON)
Where D is the duty cycle and
is the increase in R
DS(ON)
at the anticipated MOSFET junction temperature. From this
equation the required R
DS(ON)
can be derived:
P
DS ON
)
=
( )
R
D I
DS
+
(
)
2
1
For example, if the MOSFET loss is to be limited to 2W
when operating at 5A and a 90% duty cycle, the required
R
DS(ON)
would be 0.089
/(1 +
). (1 +
) is given for each
MOSFET in the form of a normalized R
DS(ON)
vs tempera-
ture curve, but
= 0.007/
°
C can be used as an approxima-
tion for low voltage MOSFETs. Thus, if T
A
= 85
°
C and the
available heat sinking has a thermal resistance of 20
°
C/W,
the MOSFET junction temperature will be 125
°
C and
= 0.007(125 – 25) = 0.7. This means that the required
R
DS(ON)
of the MOSFET will be 0.089
/1.7 = 0.0523
,
which can be satisfied by an IRFZ34 manufactured by
International Rectifier.
Transition losses result from the power dissipated in each
MOSFET during the time it is transitioning from off to on,
or from on to off. These losses are proportional to (f)(HV)
2
and vary from insignificant to being a limiting factor on
operating frequency in some high voltage applications.
APPLICATIO
S I
FOR
ATIO
U
W
U
U
Paralleling MOSFETs
When the above calculations result in a lower R
DS(ON)
than
is economically feasible with a single MOSFET, two or
more MOSFETs can be paralleled. The MOSFETs will
inherently share the currents according to their R
DS(ON)
ratio as long as they are thermally connected (e.g., on a
common heat sink). The LT1160 top and bottom drivers
can each drive five power MOSFETs in parallel with only a
small loss in switching speeds (see Typical Performance
Characteristics). A low value resistor (10
to 47
) in
series with each individual MOSFET gate may be required
to “decouple” each MOSFET from its neighbors to prevent
high frequency oscillations (consult manufacturer’s rec-
ommendations). If gate decoupling resistors are used the
corresponding gate feedback pin can be connected to any
one of the gates as shown in Figure 1.
Driving multiple MOSFETs in parallel may restrict the
operating frequency to prevent overdissipation in the
LT1160 (see the following Gate Charge and Driver Dissi-
pation).
Gate Charge and Driver Dissipation
A useful indicator of the load presented to the driver by a
power MOSFET is the total gate charge Q
G
, which includes
the additional charge required by the gate-to-drain swing.
Q
G
is usually specified for V
GS
= 10V and V
DS
= 0.8V
DS(MAX)
.
When the supply current is measured in a switching
application, it will be larger than given by the DC electrical
characteristics because of the additional supply current
associated with sourcing the MOSFET gate charge:
I
I
dQ
dt
dQ
dt
SUPPLY
DC
G
TOP
G
BOTTOM
=
+
+
GATE DR
GATE FB
LT1160
R
G
*
R
G
*
*OPTIONAL 10
1160 F01
Figure 1. Paralleling MOSFETs
相關PDF資料
PDF描述
LT1161 1-of-8 Data Selectors/Multiplexers With 3-State Outputs 16-SOIC 0 to 70
LT1161C Quad Protected High-Side MOSFET Driver
LT1161CN Quad Protected High-Side MOSFET Driver
LT1161CS Quad Protected High-Side MOSFET Driver
LT1161I Quad Protected High-Side MOSFET Driver
相關代理商/技術參數
參數描述
LT1160_1 制造商:LINEAR 制造商全稱:LINEAR 功能描述:Half-/Full-Bridge N-Channel Power MOSFET Drivers
LT1160CN 功能描述:IC PWR MOSFET DRIVER N-CH 14-DIP RoHS:否 類別:集成電路 (IC) >> PMIC - MOSFET,電橋驅動器 - 外部開關 系列:- 標準包裝:5 系列:- 配置:低端 輸入類型:非反相 延遲時間:600ns 電流 - 峰:12A 配置數:1 輸出數:1 高端電壓 - 最大(自引導啟動):- 電源電壓:14.2 V ~ 15.8 V 工作溫度:-20°C ~ 60°C 安裝類型:通孔 封裝/外殼:21-SIP 模塊 供應商設備封裝:模塊 包裝:散裝 配用:BG2A-NF-ND - KIT DEV BOARD FOR IGBT 其它名稱:835-1063
LT1160CN#PBF 功能描述:IC PWR MOSFET DRIVER N-CH 14-DIP RoHS:是 類別:集成電路 (IC) >> PMIC - MOSFET,電橋驅動器 - 外部開關 系列:- 標準包裝:5 系列:- 配置:低端 輸入類型:非反相 延遲時間:600ns 電流 - 峰:12A 配置數:1 輸出數:1 高端電壓 - 最大(自引導啟動):- 電源電壓:14.2 V ~ 15.8 V 工作溫度:-20°C ~ 60°C 安裝類型:通孔 封裝/外殼:21-SIP 模塊 供應商設備封裝:模塊 包裝:散裝 配用:BG2A-NF-ND - KIT DEV BOARD FOR IGBT 其它名稱:835-1063
LT1160CS 功能描述:IC PWR MOSFET DRIVER N-CH 14SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - MOSFET,電橋驅動器 - 外部開關 系列:- 標準包裝:5 系列:- 配置:低端 輸入類型:非反相 延遲時間:600ns 電流 - 峰:12A 配置數:1 輸出數:1 高端電壓 - 最大(自引導啟動):- 電源電壓:14.2 V ~ 15.8 V 工作溫度:-20°C ~ 60°C 安裝類型:通孔 封裝/外殼:21-SIP 模塊 供應商設備封裝:模塊 包裝:散裝 配用:BG2A-NF-ND - KIT DEV BOARD FOR IGBT 其它名稱:835-1063
LT1160CS#PBF 功能描述:IC PWR MOSFET DRIVER N-CH 14SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - MOSFET,電橋驅動器 - 外部開關 系列:- 標準包裝:95 系列:- 配置:高端和低端,獨立 輸入類型:非反相 延遲時間:160ns 電流 - 峰:290mA 配置數:1 輸出數:2 高端電壓 - 最大(自引導啟動):600V 電源電壓:10 V ~ 20 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 供應商設備封裝:8-SOIC 包裝:管件 產品目錄頁面:1381 (CN2011-ZH PDF)