- 您現在的位置：買賣IC網 > PDF目錄43901 > L9942XPTR (STMICROELECTRONICS) STEPPER MOTOR CONTROLLER, 2.5 A, PDSO24 PDF資料下載
參數資料
| 型號： | L9942XPTR |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 運動控制電子 |
| 英文描述： | STEPPER MOTOR CONTROLLER, 2.5 A, PDSO24 |
| 封裝： | LEAD FREE, POWER, SSO-24 |
| 文件頁數： | 3/40頁 |
| 文件大?。?/td> | 664K |
| 代理商： | L9942XPTR |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
L9942
Device description
2.10
Over Current Detection
The overcurrent detection circuit monitors the load current in each activated output stage. In
HS stage it is in function after detection of currentlimit during PWM cycle and in LS stage it
works permanently. If the load current exceeds the overcurrent detection threshold for at
least tISC = 4 s, the over-current flag is set and the corresponding driver is switched off to
reduce the power dissipation and to protect the integrated circuit. Error condition is lached
and the microcontroller needs to clear the status bits to reactivate the drivers.
2.11
Open Load Detection
The open load detection monitors the activity time of the PWM controller and is available for
each phase. If the limit of load current is below around 100mA then open load condition is
detectable. Open load bit for a bridge is set in the register6 if this low current limit can't
reached after at least 15 consecutive PWM cycles.
Truth table shows possible profiles for active open load detection. Maximum threshold IOL is
shown in left column if x bits are 1 (see also Figure 7). Lowest possible limit is e.g. 3.1 mA
for DC2=DC1=DC0=0 and it is set only I0=1.
2.12
Stepping Modes
One full revolution can consist of four full steps, eight half steps, sixteen mini steps or 32
microsteps.
Mode is set up in register 0 and it defines increment size of phase counter. Phase counter
value defines address of corresponding currentprofile. Stepping modes with typical profile
values can see in Figure 3 (e.g. also so called 'Two Phase On' shown in dashed line).
Table 2.
Truth table
DC2
DC1
DC0
I4
I3
I2
I1
I0
max. IOL
0000
xxxx
48mA
0010
xxxx
72mA
01000
x
56mA
11000
x
90mA
100000
x
58mA
101000
x
87mA
11000001
42mA
11100001
48mA
相關PDF資料 |
PDF描述 |
|---|---|
| L9951XPTR | BRUSH DC MOTOR CONTROLLER, 10 A, PDSO36 |
| L9951TR | BRUSH DC MOTOR CONTROLLER, 10 A, PDSO36 |
| L9952GXP | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO36 |
| L9952GXPTR | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO36 |
| L99H01QF | BRUSH DC MOTOR CONTROLLER, PQFP32 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L9946 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DC Motor Controller/Driver |
| L9947 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:QUAD HALF-BRIDGE AND SINGLE HIGH-SIDE DRIVER |
| L9947L | 制造商:STMicroelectronics 功能描述: |
| L9947S | 功能描述:馬達/運動/點火控制器和驅動器 Quad Half Bridge RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| L9949 | 功能描述:功率驅動器IC Door Actuator RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。