- 您現在的位置：買賣IC網 > PDF目錄1931 > KSZ8862-16MQL (Micrel Inc)IC SWITCH 10/100 16BIT 128-PQFP PDF資料下載
參數資料
| 型號： | KSZ8862-16MQL |
| 廠商： | Micrel Inc |
| 文件頁數： | 58/125頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC SWITCH 10/100 16BIT 128-PQFP |
| 標準包裝： | 66 |
| 系列： | KSZ8862 |
| 控制器類型： | 以太網開關控制器 |
| 接口： | PCI |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 128-BFQFP |
| 供應商設備封裝： | 128-PQFP（14x20） |
| 包裝： | 托盤 |
| 配用： | 576-1638-ND - BOARD EVALUATION KSZ8862-10FL 576-1637-ND - BOARD EVALUATION KSZ8862-100FX |
| 其它名稱： | 576-1564 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁當前第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁
Micrel, Inc.
KSZ8862-16/32MQL
April 2007
38
M9999-040407-3.0
Queue Management Unit (QMU)
The Queue Management Unit (QMU) manages packet traffic between the MAC/PHY interface and the system host. It has
built-in packet memory for receive and transmit functions called TXQ (Transmit Queue) and RXQ (Receive Queue). Each
queue contains 4KB of memory for back-to-back, non-blocking frame transfer performance. It provides a group of control
registers for system control, frame status registers for current packet transmit/receive status, and interrupts to inform the
host of the real time TX/RX status.
Transmit Queue (TXQ) Frame Format
The frame format for the transmit queue is shown in the following Table 3. The first word contains the control information
for the frame to transmit. The second word is used to specify the total number of bytes of the frame. The packet data
follows. The packet data area holds the frame itself. It may or may not include the CRC checksum depending on whether
hardware CRC checksum generation is enabled.
Multiple frames can be pipelined in both the transmit queue and receive queue as long as there is enough queue memory,
thus avoiding overrun. For each transmitted frame, the transmit status information for the frame is located in the TXSR
register.
Packet Memory
Address Offset
Bit 15
Bit 0
2
nd Byte
1
st Byte
0
Control Word
2
Byte Count
4 - up
Packet Data
(maximum size is 1916)
Table 3. Transmit Queue Frame Format
Since multiple packets can be pipelined into the TX packet memory for transmit, the transmit status reflects the
status of the packet that is currently being transferred on the MAC interface (which may or may not be the last
queued packet in the TX queue).
The transmit control word is the first 16-bit word in the TX packet memory, followed by a 16-bit byte count. It must
be word aligned. Each control word corresponds to one TX packet. Table 4 gives the transmit control word bit
fields.
Bit
Description
15
TXIC Transmit Interrupt on Completion
When bit is set, the KSZ8862M sets the transmit interrupt after the present frame has been
transmitted.
14-10
Reserved
9-8
TXDPN Transmit Destination Port Number
When bit is set, this field indicates the destination port(s) where the packet is forwarded
from host system. Set bit 8 to indicate that port 1 is the destination port. Set bit 9 to
indicate that port 2 is the destination port.
Setting all ports to 1 causes the switch engine to broadcast the packet to both ports.
Setting all bits to 0 has no effect. The internal switch engine forwards the packets
according to the switching algorithm in its MAC lookup table.
7-6
Reserved
5-0
TXFID Transmit Frame ID
This field specifies the frame ID that is used to identify the frame and its associated status
information in the transmit status register TXSR[5:0].
Table 4. Transmit Control Word Bit Fields
相關PDF資料 |
PDF描述 |
|---|---|
| KSZ8862-32MQL | IC ETHERNET SW 2PORT BUS 128PQFP |
| KSZ8863MLLI | IC ETHERNET SWITCH 3PORT 48-LQFP |
| KSZ8864RMNI | IC ETHERNET SWITCH 4PORT 64QFN |
| KSZ8873FLLI | IC ETHERNET SWITCH 3PORT 64LQFP |
| KSZ8873MLLJ | IC ETHERNET SWITCH 3PORT 64LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| KSZ8862-16MQL-FX | 功能描述:以太網 IC 2-Port Ethernet Switch/Repeater + Generic (16-bit) bus interface. Fiber Capabilities on Port-1(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8862-32MQL | 功能描述:以太網 IC 2-Port Ethernet Switch/Repeater + Generic (32-bit) bus interface. Fiber Capabilities on Port-1(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8862-32MQL-FX | 功能描述:以太網 IC 2-Port Ethernet Switch/Repeater + Generic (32-bit) bus interface. Fiber Capabilities on Port-1(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8862-MQL | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:2-Port Ethernet Switch with Non-PCI Interface and Fiber Support |
| KSZ8863FLL | 功能描述:以太網 IC 3-Port 10/100 Ethernet Switch with 1x FX Port and 1x TX Port (Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。