- 您現在的位置：買賣IC網 > PDF目錄360998 > ISP1161A (NXP Semiconductors N.V.) Full-speed Universal Serial Bus single-chip host and device controller PDF資料下載
參數資料
| 型號： | ISP1161A |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | Full-speed Universal Serial Bus single-chip host and device controller |
| 中文描述： | 全速通用串行總線的單芯片主機和設備控制器 |
| 文件頁數： | 57/134頁 |
| 文件大小： | 587K |
| 代理商： | ISP1161A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁當前第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁
Philips Semiconductors
ISP1161A
Full-speed USB single-chip host and device controller
Product data
Rev. 03 — 23 December 2004
57 of 134
9397 750 13962
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
10.3.2
HcRhDescriptorB register (R/W: 13H/93H)
The HcRhDescriptorB register is the second register of two describing the
characteristics of the Root Hub. These fields are written during initialization to
correspond with the system implementation. Reset values are
implementation-specific (IS).
12
NOCP
NoOverCurrentProtection:
This bit describes how the
overcurrent status for the Root Hub ports are reported. When this
bit is cleared, the OverCurrentProtectionMode field specifies
global or per-port reporting.
0 —
overcurrent status is reported collectively for all downstream
ports
1 —
no overcurrent reporting supported
OverCurrentProtectionMode:
This bit describes how the
overcurrent status for the Root Hub ports is reported. At reset, this
field reflects the same mode as PowerSwitchingMode. This field is
valid only if the NoOverCurrentProtection field is cleared.
11
OCPM
0 —
overcurrent status is reported collectively for all downstream
ports.
1 —
overcurrent status is reported on a per-port basis. On
power-up, clear this bit and then set it to logic 1.
DeviceType:
This bit specifies that the Root Hub is not a
compound device—it is not permitted. This field will always
read/write 0.
NoPowerSwitching:
These bits are used to specify whether
power switching is supported or ports are always powered. It is
implementation-specific. When this bit is cleared, the bit
PowerSwitchingMode specifies global or per-port switching.
10
DT
9
NPS
0 —
ports are power switched
1 —
ports are always powered on when the HC is powered on
PowerSwitchingMode:
This bit is used to specify how the power
switching of the Root Hub ports is controlled. It is
implementation-specific. This field is valid only if the
NoPowerSwitching field is cleared.
8
PSM
0 —
all ports are powered at the same time
1 —
each port is powered individually. This mode allows port
power to be controlled by either the global switch or per-port
switching. If the bit PortPowerControlMask is set, the port
responds to only port power commands (Set/ClearPortPower). If
the port mask is cleared, then the port is controlled only by the
global power switch (Set/ClearGlobalPower).
reserved
NumberDownstreamPorts:
These bits specify the number of
downstream ports supported by the Root Hub. The maximum
number of ports supported by ISP1161A is 2.
7 to 2
1 to 0
-
NDP[1:0]
Table 29:
Bit
HcRhDescriptorA register: bit description
…continued
Symbol
Description
相關PDF資料 |
PDF描述 |
|---|---|
| ISP1161ABD | Full-speed Universal Serial Bus single-chip host and device controller |
| ISP1161ABM | Full-speed Universal Serial Bus single-chip host and device controller |
| ISP1161 | Full-speed Universal Serial Bus single-chip host and device controller |
| ISP1161A1 | Universal Serial Bus single-chip host and device controller |
| ISP1161A1BD | Universal Serial Bus single-chip host and device controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISP1161A1 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal Serial Bus single-chip host and device controller |
| ISP1161A1BD | 功能描述:IC USB HOST/DEVICE CTRLR 64-LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A |
| ISP1161A1BD,118 | 功能描述:USB 接口集成電路 USB1.1 HOST &DEVICE RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ISP1161A1BD,151 | 功能描述:USB 接口集成電路 USB1.1 HOST &DEVICE RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ISP1161A1BD,157 | 功能描述:USB 接口集成電路 DO NOT USE ORDER -S OR -T PART RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
發布緊急采購，3分鐘左右您將得到回復。