- 您現在的位置：買賣IC網 > PDF目錄384519 > ISD5116P (WINBOND ELECTRONICS CORP) Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability PDF資料下載
參數資料
| 型號： | ISD5116P |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | 音頻合成 |
| 英文描述： | Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability |
| 中文描述： | 960 SEC, SPEECH SYNTHESIZER WITH RCDG, PDIP28 |
| 封裝： | 0.600 INCH, PLASTIC, DIP-28 |
| 文件頁數： | 8/57頁 |
| 文件大小： | 735K |
| 代理商： | ISD5116P |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁
October 2000
Page 7
2.1 INTERNAL REGISTERS
The ISD5116 has multiple internal registers that are used to store the address information and the
configuration or set-up of the device. The two 16-bit configuration registers control the audio paths
through the device, the sample frequency, the various gains and attenuations, the sections powered up
and down, and the volume settings. These registers are discussed in detail in
section 3.5
on page 13.
2.2 MEMORY ORGANIZATION
The ISD5116 memory array is arranged as 2048 rows (or pages) of 2048 bits for a total memory of
4,194,304 bits. The primary addressing for the 2048 pages is handled by 11 bits of address data in the
analog mode. At the 8 kHz sample rate, each page contains 256 milliseconds of audio. Thus at 8 kHz
there is actually room for 8 minutes and 44 seconds of audio.
A memory page is 2048 bits organized as thirty-two 64-bit "blocks" when used for digital storage. The
contents of a page are either analog or digital. This is determined by instruction (op code) at the time the
data is written. A record of what is analog and what is digital, and where, is stored by the system
microcontroller in the message address table (MAT). The MAT is a table kept in the microcontroller
memory that defines the status of each message “block.” It can be stored back into the ISD5116 if the
power fails or the system is turned off. Using this table allows for efficient message management.
Segments of messages can be stored wherever there is available space in the memory array. [This is
explained in detail for the ISD5008 in Applications Note #9 and will be similarly described in a later Note
for the ISD5116.]
When a page is used for analog storage, the same 32 blocks are present but there are 8 EOM (End-of-
Message) markers. This means that for each 4 blocks there is an EOM marker at the end. Thus, when
recording, the analog recording will stop at any one of eight positions. At 8 kHz, this results in a
resolution of 32 msec when ENDING an analog recording. Beginning an analog recording is limited to
the 256 msec resolution provided by the 11-bit address. A recording does not immediately stop when the
Stop command is given, but continues until the 32 millisecond block is filled. Then a bit is placed in the
EOM memory to develop the interrupt that signals a message is finished playing in the Playback mode.
Digital data is sent and received serially over the I
2
C interface. The data is serial-to-parallel converted and
stored in one of two alternating (commutating) 64-bit shift registers. When an input register is full, it
becomes the register that is parallel written into the array. The prior write register becomes the new serial
input register. A mechanism is built-in to ensure there is always a register available for storing new data.
Storing data in the memory is accomplished by accepting data one byte at a time and issuing an
acknowledge. If data is coming in faster than it can be written, the chip issues an acknowledge to the host
microcontroller, but holds SCL LOW until it is ready to accept more data.
The read mode is the opposite of the write mode. Data is read into one of two 64-bit registers from the
array and serially sent to the I
2
C interface. (See
section 5
on page 27 for details).
相關PDF資料 |
PDF描述 |
|---|---|
| ISD5116S | Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability |
| ISD5116SD | Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability |
| ISD5116SI | Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability |
| ISD5116X | Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability |
| ISG510065 | CATV OUT-OF-BAND TUNER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISD5116PY | 功能描述:IC VOICE REC/PLAY 8-16MN 28-DIP RoHS:是 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000 |
| ISD5116S | 功能描述:IC VOICE REC/PLAY 8-16MN 28-SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000 |
| ISD5116SD | 制造商:WINBOND 制造商全稱:Winbond 功能描述:Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability |
| ISD5116SERIES | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Single-Chip Voice Record/Playback Device with Digital Memory Capability |
| ISD5116SI | 功能描述:IC VOICE REC/PL 8-16MN IN 28SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP（0.300"，7.62mm） 供應商設備封裝:28-PDIP 其它名稱:90-21300+000 |
發布緊急采購，3分鐘左右您將得到回復。