參數資料
型號: ISD5116P
廠商: WINBOND ELECTRONICS CORP
元件分類: 音頻合成
英文描述: Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability
中文描述: 960 SEC, SPEECH SYNTHESIZER WITH RCDG, PDIP28
封裝: 0.600 INCH, PLASTIC, DIP-28
文件頁數: 31/57頁
文件大?。?/td> 735K
代理商: ISD5116P
Page 30
3. Erase digital data
1. Host executes I
2
C START
2. Send Slave Address with R/W bit = “0” (Write)
3. Slave responds back with an ACK
4. Wait for SCL to go HIGH
5. Host sends a byte to Slave - (Command Byte = D1)
6. Slave responds with an ACK
7. Wait for SCL to go HIGH
8. Host sends a byte to Slave - (High Address Byte)
9. Slave responds with an ACK.
10. Wait for SCL to go HIGH
11. Host sends a byte to Slave - (Low Address Byte)
12. Slave responds with an ACK
13. Wait for SCL to go HIGH
14. Host executes I
C STOP
15. Host counts RAC cycles to track where the chip is in the erase operation.
16. Host determines erase of final row has begun
17. Host executes I
C START
18. Send Slave Address with R/W bit = “0” (Write)
19. Slave responds back with an ACK
20. Wait for SCL to go HIGH
21. Host sends a byte to Slave - (Command Byte = 80)
22. Slave responds back with an ACK
23. Wait for SCL to go HIGH
24. Host executes I
C STOP
A
S
SLAVE ADDRESS
W
Command Byte
D1h
A
DATA
A
DATA
A
High Addr. Byte
Low Addr. Byte
A
S
SLAVE ADDRESS
W
P
Command Byte
80h
Erase starts on falling
edge of Slave
acknowledge
Note 2
"N" RAC cycles
Note 3.
Last erased row
Note 4.
A
P
Notes
1. Erase operations must be addressed on a Row boundary. The 5 LSB bits of the Low
Address Byte will be ignored.
2. I2C bus is released while erase proceeds. Other devices may use the bus until it is
time to execute the STOP command that causes the end of the Erase operation.
3. Host processor must count RAC cycles to determine where the chip is in the erase
process, one row per RAC cycle. RAC pulses LOW for 0.25 microsecond at the end
of each erased row. The erase of the "next" row begins with the rising edge of RAC.
See the
Digital Erase RAC timing diagram
on page 32.
4. When the erase of the last desired row begins, the following STOP command
(Command Byte = 80 hex) must be issued. This command must be completely given,
including receiving the ACK from the Slave before the RAC pin goes HIGH .25
microseconds before the end of the row.
相關PDF資料
PDF描述
ISD5116S Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability
ISD5116SD Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability
ISD5116SI Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability
ISD5116X Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability
ISG510065 CATV OUT-OF-BAND TUNER
相關代理商/技術參數
參數描述
ISD5116PY 功能描述:IC VOICE REC/PLAY 8-16MN 28-DIP RoHS:是 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP(0.300",7.62mm) 供應商設備封裝:28-PDIP 其它名稱:90-21300+000
ISD5116S 功能描述:IC VOICE REC/PLAY 8-16MN 28-SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP(0.300",7.62mm) 供應商設備封裝:28-PDIP 其它名稱:90-21300+000
ISD5116SD 制造商:WINBOND 制造商全稱:Winbond 功能描述:Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability
ISD5116SERIES 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Single-Chip Voice Record/Playback Device with Digital Memory Capability
ISD5116SI 功能描述:IC VOICE REC/PL 8-16MN IN 28SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP(0.300",7.62mm) 供應商設備封裝:28-PDIP 其它名稱:90-21300+000