參數資料
型號: ISD5116P
廠商: WINBOND ELECTRONICS CORP
元件分類: 音頻合成
英文描述: Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability
中文描述: 960 SEC, SPEECH SYNTHESIZER WITH RCDG, PDIP28
封裝: 0.600 INCH, PLASTIC, DIP-28
文件頁數: 14/57頁
文件大小: 735K
代理商: ISD5116P
October 2000
Page 13
3.4 DATA BYTES
In the I
2
C write mode, the device can accept data sent after the command byte. If a register load option is
selected, the next two bytes are loaded into the selected register. The format of the data is MSB first, the
I
2
C standard. Thus to load DATA<15:0> into the device, DATA<15:8> is sent first, the byte is
acknowledged, and DATA<7:0> is sent next. The address register consists of two bytes. The format of
the address is as follows:
ADDRESS<15:0> = PAGE_ADDRESS<10:0>, BLOCK_ADDRESS<4:0>
Note: if an analog function is selected, the block address bits must be set to 0000. Digital Read
and Write are block addressable
.
When the device is polled with the Read Status command, it will return three bytes of data. The first byte
is the status byte, the next the upper address byte and the last the lower address byte. The status register
is one byte long and its bit function is:
STATUS<7:0> = EOM, OVF, READY, PD, PRB, DEVICE_ID<2:0>
Lower address byte will always return the block address bits as zero, either in digital or analog mode.
The functions of the bits are:
EOM
OVF
READY
Indicates whether an EOM interrupt has occurred.
Indicates whether an overflow interrupt has occurred.
Indicates the internal status of the device – if READY is LOW no new commands
should be sent to device.
Device is powered down if PD is HIGH.
Play/Record mode indicator. HIGH=Play/LOW=Record.
An internal device ID. This is 001 for the ISD5116.
PD
PRB
DEVICE_ID
It is recommended that you read the status register after a Write or Record operation to ensure that the
device is ready to accept new commands. Depending upon the design and the number of pins available
on the controller, the polling overhead can be reduced. If INT and RAC are tied to the microcontroller, it
does not have to poll as frequently to determine the status of the ISD5116.
3.5 CONFIGURATION REGISTER BYTES
The configuration register bytes are defined, in detail, in the drawings of
Section 4
on page 21. The
drawings display how each bit enables or disables a function of the audio paths in the ISD5116. The
tables below give a general illustration of the bits. There are two configuration registers, CFG0 and CFG1,
so there are four 8-bit bytes to be loaded during the set-up of the device.
相關PDF資料
PDF描述
ISD5116S Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability
ISD5116SD Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability
ISD5116SI Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability
ISD5116X Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability
ISG510065 CATV OUT-OF-BAND TUNER
相關代理商/技術參數
參數描述
ISD5116PY 功能描述:IC VOICE REC/PLAY 8-16MN 28-DIP RoHS:是 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP(0.300",7.62mm) 供應商設備封裝:28-PDIP 其它名稱:90-21300+000
ISD5116S 功能描述:IC VOICE REC/PLAY 8-16MN 28-SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP(0.300",7.62mm) 供應商設備封裝:28-PDIP 其它名稱:90-21300+000
ISD5116SD 制造商:WINBOND 制造商全稱:Winbond 功能描述:Single-Chip Voice Record/Playback Device Up to 16-Minute Duration with Digital Storage Capability
ISD5116SERIES 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Single-Chip Voice Record/Playback Device with Digital Memory Capability
ISD5116SI 功能描述:IC VOICE REC/PL 8-16MN IN 28SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 語音錄制和重放 系列:ISD5100 標準包裝:14 系列:- 接口:串行 濾波器通頻帶:1.7kHz 持續時間:8 ~ 32 秒 安裝類型:通孔 封裝/外殼:28-DIP(0.300",7.62mm) 供應商設備封裝:28-PDIP 其它名稱:90-21300+000